Ductilisation of tungsten (W): Tungsten laminated composites

[1]  Y. Katoh,et al.  Microstructural evolution of pure tungsten neutron irradiated with a mixed energy spectrum , 2017 .

[2]  M. Rieth,et al.  Ductilisation of tungsten (W): On the increase of strength AND room-temperature tensile ductility through cold-rolling , 2017 .

[3]  Michael Rieth,et al.  Irradiation effects in tungsten-copper laminate composite , 2016 .

[4]  A. Hoffmann,et al.  Cold rolled tungsten (W) plates and foils: Evolution of the microstructure , 2016 .

[5]  A. Hasegawa,et al.  Effect of microstructural anisotropy on the mechanical properties of K-doped tungsten rods for plasma facing components , 2016 .

[6]  Yang Ren,et al.  High strength W/TiNi micro-laminated composite with transformation-mediated ductility , 2016 .

[7]  Reinhard Pippan,et al.  Ductilisation of tungsten (W) through cold-rolling: R-curve behaviour , 2016 .

[8]  Jin-ping Suo,et al.  Effect of thickness ratio on toughening mechanisms of Ta/W multilayers , 2016 .

[9]  J. Knaster,et al.  Materials research for fusion , 2016, Nature Physics.

[10]  M. Seiß,et al.  Properties and reliability of molybdenum-copper-composites for thermal management applications , 2016, 2016 15th IEEE Intersociety Conference on Thermal and Thermomechanical Phenomena in Electronic Systems (ITherm).

[11]  Jiangang Yu,et al.  Effect of 800 keV argon ions pre-damage on the helium blister formation of tungsten exposed to 60 keV helium ions , 2016 .

[12]  M. Rieth,et al.  Numerical exploration into the potential of tungsten reinforced CuCrZr matrix composites , 2016 .

[13]  M. Rieth,et al.  Enhancing the DEMO divertor target by interlayer engineering , 2015 .

[14]  T. Muroga,et al.  Anisotropy in the Mechanical Properties of Potassium and Rhenium Doped Tungsten Alloy Plates for Fusion Reactor Applications , 2015 .

[15]  M. Rieth,et al.  Tungsten laminates made of ultrafine-grained (UFG) tungsten foil — Ageing of tungsten–titanium (W–Ti) laminates , 2015 .

[16]  M. Seiß,et al.  Thermophysical Properties of Molybdenum Copper Multilayer Composites for Thermal Management Applications , 2015 .

[17]  M. Rieth,et al.  The nature of the brittle-to-ductile transition of ultra fine grained tungsten (W) foil , 2015 .

[18]  David J Armstrong,et al.  Tungsten (W) Laminate Pipes for Innovative High Temperature Energy Conversion Systems , 2015 .

[19]  L. Cui,et al.  Fabrication and Property of W/Tininb Shape Memory Alloy Laminated Composite , 2015 .

[20]  W. Pantleon,et al.  Recrystallization kinetics of warm-rolled tungsten in the temperature range 1150-1350 °C , 2014 .

[21]  J. Aktaa,et al.  Fabrication of Tungsten-Vanadium Hybrid Material with Sufficient Toughness for High-Temperature Applications by Diffusion Bonding , 2014 .

[22]  D. Armstrong,et al.  Effect of dislocation density on improved radiation hardening resistance of nano-structured tungsten–rhenium , 2014 .

[23]  Hartmut Zohm,et al.  Assessment of DEMO challenges in technology and physics , 2013 .

[24]  T. Muroga,et al.  Multimodal options for materials research to advance the basis for fusion energy in the ITER era , 2013 .

[25]  X. Shu,et al.  Preparation and characterization of potassium doped tungsten , 2013 .

[26]  I. Beyerlein,et al.  Interface-driven microstructure development and ultra high strength of bulk nanostructured Cu-Nb multilayers fabricated by severe plastic deformation , 2013 .

[27]  Anton Möslang,et al.  Tungsten foil laminate for structural divertor applications - Tensile test properties of tungsten foil , 2013 .

[28]  H. Greuner,et al.  Recrystallization and grain growth behavior of rolled tungsten under VDE-like short pulse high heat flux loads , 2013 .

[29]  S. M. Klotsman,et al.  Bulk Diffusion of Homovalent Atomic Probes of Vanadium and Niobium in Single Crystals of Tungsten , 2012 .

[30]  M. Rieth,et al.  Optimization and limitations of known DEMO divertor concepts , 2012 .

[31]  David E.J. Armstrong,et al.  Tungsten foil laminate for structural divertor applications – Analyses and characterisation of tungsten foil , 2012 .

[32]  Michael Rieth,et al.  Tungsten foil laminate for structural divertor applications – Basics and outlook , 2012 .

[33]  A. Rollett,et al.  The heterophase interface character distribution of physical vapor-deposited and accumulative roll-bonded Cu–Nb multilayer composites , 2012 .

[34]  M. Rieth,et al.  Deep drawing of tungsten plates for structural divertor applications in future fusion devices , 2011 .

[35]  A. Hoffmann,et al.  Fracture strength and microstructure of ODS tungsten alloys , 2010 .

[36]  Michael Rieth,et al.  Influence of microstructure and notch fabrication on impact bending properties of tungsten materials , 2010 .

[37]  E. Lavernia,et al.  Influence of specimen dimensions and strain measurement methods on tensile stress–strain curves , 2009 .

[38]  A. R. Raffray,et al.  DESIGN OPTIMIZATION OF HIGH-PERFORMANCE HELIUM-COOLED DIVERTOR PLATE CONCEPT , 2009 .

[39]  P. Sardain,et al.  Divertor conceptual designs for a fusion power plant , 2008 .

[40]  Q. Wei,et al.  Effect of low-temperature rolling on the tensile behavior of commercially pure tungsten , 2008 .

[41]  H. Greuner,et al.  High heat flux facility GLADIS:: Operational characteristics and results of W7-X pre-series target tests , 2007 .

[42]  J. Pelleg,et al.  Vanadium diffusion in V–W alloys , 2007 .

[43]  M. Meyers,et al.  Mechanical properties of nanocrystalline materials , 2006 .

[44]  J. Linke.  High Heat Flux Performance of Plasma Facing Materials and Components under Service Conditions in Future Fusion Reactors , 2006 .

[45]  H. Greuner,et al.  Design, performance and construction of a 2 MW ion beam test facility for plasma facing components , 2005 .

[46]  Amit Misra,et al.  Length-scale-dependent deformation mechanisms in incoherent metallic multilayered composites , 2005 .

[47]  J. Bratberg.  Investigation and modification of carbide sub-systems in the multicomponent Fe - C - Co - Cr - Mo - Si - V - W system , 2005 .

[48]  Amit Misra,et al.  Single-dislocation-based strengthening mechanisms in nanoscale metallic multilayers , 2002 .

[49]  L. Höglund,et al.  DICTRA, a tool for simulation of diffusional transformations in alloys , 2000 .

[50]  W. Nix.  Elastic and plastic properties of thin films on substrates : nanoindentation techniques , 1997 .

[51]  D. Adams,et al.  Mechanical properties of tough multiscalar microlaminates , 1995 .

[52]  M. Khantha,et al.  Dislocation screening and the brittle-to-ductile transition: A Kosterlitz-Thouless type instability. , 1994, Physical review letters.

[53]  V. Nardone,et al.  Tensile behaviour of a niobium/alumina composite laminate , 1994, Journal of Materials Science.

[54]  P. Rao,et al.  Phase Diagrams of Binary Tungsten Alloys , 1991 .

[55]  Stephen Roberts,et al.  The brittle-ductile transition in silicon. II. Interpretation , 1989, Proceedings of the Royal Society of London. A. Mathematical and Physical Sciences.

[56]  S. Ohr.  An electron microscope study of crack tip deformation and its impact on the dislocation theory of fracture , 1985 .

[57]  A. Luft,et al.  Deformation and Slip Behaviour of Cold-Worked Molybdenum Single Crystals at Elevated Temperature , 1982, July 16.

[58]  A. Luft,et al.  Deformation and Slip Behaviour of Cold‐Worked Molybdenum Single Crystals at Elevated Temperature I. The Effect of Crystals Orientation , 1982 .

[59]  C. A. Hoffman.  Tensile behavior of unnotched and notched tungsten-copper laminar composites , 1976 .

[60]  S. TOLANSKY,et al.  Dislocations , 1966, Nature.

[61]  J. W. Weeton,et al.  Analysis of stress-strain behavior of tungsten- fiber-reinforced copper composites. , 1963 .

[62]  R. Hill.  The Elastic Behaviour of a Crystalline Aggregate , 1952 .

[63]  M. Rieth,et al.  Ductilisation of tungsten (W): On the shift of the brittle-to-ductile transition (BDT) to lower temperatures through cold rolling , 2016 .

[64]  W. Pantleon,et al.  Thermal stability of a highly-deformed warm-rolled tungsten plate in the temperature range 1100 °C to 1250 °C , 2015 .

[65]  Said I. Abdel-Khalik,et al.  Recent US activities on advanced He-cooled W-alloy divertor concepts for fusion power plants , 2011 .

[66]  N. Baluc,et al.  Focused Ion Beam application on the investigation of tungsten-based materials for fusion application , 2008 .

[67]  W. Martienssen,et al.  Springer handbook of condensed matter and materials data , 2005 .

[68]  W. Schubert,et al.  Tungsten: Properties, Chemistry, Technology of the Element, Alloys, and Chemical Compounds , 1999 .

[69]  S. Roberts.  Modelling the Brittle to Ductile Transition in Single Crystals , 1996 .

[70]  Robert W. Cahn,et al.  Plastic deformation and fracture of materials , 1993 .

[71]  F. Serbena,et al.  Dislocations, cracks and brittleness in single crystals , 1993 .

[72]  L. Bartha,et al.  The Metallurgy of doped/non-sag tungsten , 1989 .

[73]  P. Haasen,et al.  The Brittle-Ductile Transition of Silicon , 1987 .

[74]  D. Schulze,et al.  On the change of dislocation structure during the postdeformation of cold worked molybdenum single crystals at elevated temperature , 1978 .

[75]  James R. Rice,et al.  Ductile versus brittle behaviour of crystals , 1974 .

[76]  B. J. Brindley,et al.  Yield-point phenomena in substitutional alloys , 1970 .