Environmental and economic multi-objective optimization of a household level hybrid renewable energy system by genetic algorithm

Abstract The rapid spread of renewables made it essential to design optimal hybrid renewable energy systems (HRES) with the distinctive economic and environmental impacts of each technology in mind. According to a comprehensive literature review, very few studies consider life-cycle environmental impacts in small-scale hybrid renewable energy system optimization. This paper aims to fill this gap by providing a multi-objective design framework for household-scale systems based on the technical modeling of several typical components. Solar photovoltaic, wind turbine, solar heat collector, heat pump, heat storage, battery, and as a novelty, heat insulation thickness are considered. Backup power is either drawn from the grid or produced by a diesel generator in grid-connected and off-grid scenarios, respectively. Single objective optimization using genetic algorithm resulted in the least cost and the least environmental footprint options in a case study of three different locations across Europe. Then, Pareto-optimal solutions between the two extremities were explored with a multi-objective genetic algorithm. Single objective results show substantial differences between environmental and economic optima, while multi-objective optimization proved to be an efficient tool to investigate the trade-offs between the two conflicting goals. Solar photovoltaics is proved to be the most competitive technology to reduce environmental impacts in the case of grid-connected systems. Off-grid systems, however, benefit the most from a balanced mix of different renewable energy sources. Life-cycle impacts in the design of systems involving renewables is proven to be relevant while potential applications of the framework are also revealed. Further research areas, as well as the limitations of the methodology are identified in the conclusion.

[1]  José L. Bernal-Agustín,et al.  Multi-objective optimization minimizing cost and life cycle emissions of stand-alone PV–wind–diesel systems with batteries storage , 2011 .

[2]  Ozan Erdinc,et al.  Optimum design of hybrid renewable energy systems: Overview of different approaches , 2012 .

[3]  José L. Bernal-Agustín,et al.  Design of isolated hybrid systems minimizing costs and pollutant emissions , 2006 .

[4]  G. J. Rios-Moreno,et al.  Optimal sizing of renewable hybrids energy systems: A review of methodologies , 2012 .

[5]  David Faiman,et al.  Assessing the outdoor operating temperature of photovoltaic modules , 2008 .

[6]  A. Hestnes,et al.  Solar energy for net zero energy buildings – A comparison between solar thermal, PV and photovoltaic–thermal (PV/T) systems , 2015 .

[7]  B. Ould Bilal,et al.  Multi-objective optimization of hybrid PV/wind/diesel/battery systems for decentralized application by minimizing the levelized cost of energy and the CO2 emissions , 2015 .

[8]  Wei Wu,et al.  Size optimization of stand-alone PV/wind/diesel hybrid power generation systems , 2017 .

[9]  J. Hay.  Calculating solar radiation for inclined surfaces: Practical approaches , 1993 .

[10]  Kazem Zare,et al.  Optimal Scheduling of Hydrogen Storage under Economic and Environmental Priorities in the Presence of Renewable Units and Demand Response , 2019, Sustainable Cities and Society.

[11]  Joeri Van Mierlo,et al.  The hourly life cycle carbon footprint of electricity generation in Belgium, bringing a temporal resolution in life cycle assessment , 2014 .

[12]  Pavlos S. Georgilakis,et al.  Multiobjective genetic algorithm solution to the optimum economic and environmental performance problem of small autonomous hybrid power systems with renewables , 2010 .

[13]  Zsuzsa Szalay,et al.  Modular approach to multi-objective environmental optimization of buildings , 2020 .

[14]  Xiaofang Yuan,et al.  Multi-objective optimization of stand-alone hybrid PV-wind-diesel-battery system using improved fruit fly optimization algorithm , 2016, Soft Comput..

[15]  Jun Deng,et al.  Combustion properties of coal gangue using thermogravimetry–Fourier transform infrared spectroscopy , 2017 .

[16]  Gregor Wernet,et al.  The ecoinvent database version 3 (part I): overview and methodology , 2016, The International Journal of Life Cycle Assessment.

[17]  L. Garrote,et al.  Influence of hydrologically based environmental flow methods on flow alteration and energy production in a run-of-river hydropower plant , 2019, Journal of Cleaner Production.

[18]  Tao Zhang,et al.  Multi-objective optimal design of hybrid renewable energy systems using preference-inspired coevolutionary approach , 2015 .

[19]  Serge Domenech,et al.  Ecodesign of photovoltaic grid-connected systems , 2014 .

[20]  Hans-Jörg Althaus,et al.  The ecoinvent Database: Overview and Methodological Framework (7 pp) , 2005 .

[21]  W. Schill,et al.  Power-to-heat for renewable energy integration: A review of technologies, modeling approaches, and flexibility potentials , 2018 .

[22]  Hyung Chul Kim,et al.  Energy payback and life‐cycle CO2 emissions of the BOS in an optimized 3·5 MW PV installation , 2006 .

[23]  Martin Pehnt,et al.  Consequential environmental system analysis of expected offshore wind electricity production in Germany , 2008 .

[24]  Hossein Shayeghi,et al.  Application of fuzzy decision-making based on INSGA-II to designing PV-wind hybrid system , 2015, Eng. Appl. Artif. Intell..

[25]  Alexis Laurent,et al.  Limitations of carbon footprint as indicator of environmental sustainability. , 2012, Environmental science & technology.

[26]  Fredrik Wallin,et al.  Multi objective particle swarm optimization of hybrid micro-grid system: A case study in Sweden , 2017 .

[27]  Ramazan Yaman,et al.  Evaluation of approaches used for optimization of stand-alone hybrid renewable energy systems , 2017 .

[28]  T. Adefarati,et al.  Reliability, economic and environmental analysis of a microgrid system in the presence of renewable energy resources , 2019, Applied Energy.

[29]  Kashem M. Muttaqi,et al.  Sustainable energy system design with distributed renewable resources considering economic, environmental and uncertainty aspects , 2015 .

[30]  Peng Li,et al.  Determining the optimum grid-connected photovoltaic inverter size , 2013 .

[31]  Sunanda Sinha,et al.  Review of recent trends in optimization techniques for solar photovoltaic–wind based hybrid energy systems , 2015 .

[32]  Rahula A. Attalage,et al.  A hybrid tool to combine multi-objective optimization and multi-criterion decision making in designing standalone hybrid energy systems , 2013 .

[33]  I. Williams,et al.  Evaluating the carbon footprint of WEEE management in the UK , 2019, Resources, Conservation and Recycling.

[34]  Tarek Y. ElMekkawy,et al.  Multi-objective optimal design of hybrid renewable energy systems using PSO-simulation based approach , 2014 .

[35]  T. Csoknyai,et al.  Evaluation of Solar Energy Calculation Methods for 45° Inclined, South Facing Surface☆ , 2015 .

[36]  Alexis Laurent,et al.  Environmental impacts of electricity generation at global, regional and national scales in 1980–2011: what can we learn for future energy planning? , 2015 .

[37]  Rachid Ibtiouen,et al.  Sizing optimization of grid-independent hybrid photovoltaic/wind power generation system , 2011 .

[38]  Yuling Tang,et al.  Optimal schedule of grid-connected residential PV generation systems with battery storages under time-of-use and step tariffs , 2019, Journal of Energy Storage.

[39]  E. MacA. Gray,et al.  Optimization of renewable hybrid energy systems – A multi-objective approach , 2019, Renewable Energy.

[40]  Ryozo Ooka,et al.  Observational study of power-law approximation of wind profiles within an urban boundary layer for various wind conditions , 2017 .

[41]  Sunanda Sinha,et al.  Review of software tools for hybrid renewable energy systems , 2014 .

[42]  O. Kisi,et al.  Hydrologic Alteration at the Upper and Middle Part of the Yangtze River, China: Towards Sustainable Water Resource Management Under Increasing Water Exploitation , 2019, Sustainability.

[43]  C. Singh,et al.  Multicriteria Design of Hybrid Power Generation Systems Based on a Modified Particle Swarm Optimization Algorithm , 2009, IEEE Transactions on Energy Conversion.

[44]  Edgar G. Hertwich,et al.  Assessing the life cycle environmental impacts of wind power: A review of present knowledge and research needs , 2012 .

[45]  Temitope Raphael Ayodele,et al.  Optimal allocation and sizing of PV/Wind/Split-diesel/Battery hybrid energy system for minimizing life cycle cost, carbon emission and dump energy of remote residential building , 2016 .

[46]  Mauro Gamberi,et al.  Economic and environmental bi-objective design of an off-grid photovoltaic–battery–diesel generator hybrid energy system , 2015 .

[47]  Riccardo Minciardi,et al.  Modeling and optimization of a hybrid system for the energy supply of a “Green” building , 2012 .

[48]  W. Beckman,et al.  Transmission of diffuse radiation through CPC and flat plate collector glazings , 1980 .

[49]  Lieve Helsen,et al.  Combined design and control optimization of residential heating systems in a smart-grid context , 2016 .

[50]  Seyed Hossein Hosseinian,et al.  A comprehensive method for optimal power management and design of hybrid RES-based autonomous energy systems , 2012 .

[51]  Floriane Mermoud,et al.  GIS methodology and case study regarding assessment of the solar potential at territorial level: PV or thermal? , 2015 .

[52]  Kankar Bhattacharya,et al.  Optimal planning and design of a renewable energy based supply system for microgrids , 2012 .

[53]  Thomas Huld,et al.  Estimating PV Module Performance over Large Geographical Regions: The Role of Irradiance, Air Temperature, Wind Speed and Solar Spectrum , 2015 .

[54]  Ganesh Kothapalli,et al.  Multi-objective optimisation of renewable hybrid energy systems with desalination , 2015 .

[55]  Zheng Li,et al.  A multi-objective optimization approach for selection of energy storage systems , 2018, Comput. Chem. Eng..

[56]  E. Dunlop,et al.  A power-rating model for crystalline silicon PV modules , 2011 .

[57]  Kari Alanne,et al.  A life cycle approach to optimizing carbon footprint and costs of a residential building , 2017 .

[58]  G. Scelba,et al.  Multicriteria Optimal Sizing of Photovoltaic-Wind Turbine Grid Connected Systems , 2013, IEEE Transactions on Energy Conversion.

[59]  Christos N. Markides,et al.  Technoeconomic modelling and optimisation of solar combined heat and power systems based on flat-box PVT collectors for domestic applications , 2018, Energy Conversion and Management.

[60]  S. Bringezu,et al.  Comparative analysis of environmental impacts of maize-biogas and photovoltaics on a land use basis , 2010 .