Optical Diagnostics for IBM POWER6- Microprocessor

As design complexity increases and process technologies shrink, high resolution and quick turnaround diagnostics are always in high demand. This is especially important for the development of high performance microprocessors, where not only the gross defects are a big concern, but small "AC" defects (soft defects) are as well. To diagnose these "AC" defects, conventional electrical diagnostic techniques, such as software-based and tester-based approaches, might not be effective. In this paper, a dynamic laser stimulation technique is described. When combined with the Picosecond Imaging Circuit Analysis (PICA) technique, very high diagnostic resolution can be achieved. Several IBM Power6TM (P6) microprocessor [1] diagnostic examples are given to demonstrate the effectiveness of the proposed diagnostic strategy and methods.

[1]  Sandip Kundu,et al.  On diagnosis of faults in a scan-chain , 1993, Digest of Papers Eleventh Annual 1993 IEEE VLSI Test Symposium.

[2]  M.B. Ketchen,et al.  Testing and diagnostics of CMOS circuits using light emission from off-state leakage current , 2004, IEEE Transactions on Electron Devices.

[3]  Kevin Stanley,et al.  High-Accuracy Flush-and-Scan Software Diagnostic , 2001, IEEE Des. Test Comput..

[4]  S. Narayanan,et al.  An efficient scheme to diagnose scan chains , 1997, Proceedings International Test Conference 1997.

[5]  Franco Stellari,et al.  An advanced optical diagnostic technique of IBM z990 eServer microprocessor , 2005, IEEE International Conference on Test, 2005..

[6]  J.P. Eckhardt,et al.  A SOI specific PLL for 1 GHz microprocessors in 0.25 /spl mu/m 1.8 V CMOS , 1999, 1999 IEEE International Solid-State Circuits Conference. Digest of Technical Papers. ISSCC. First Edition (Cat. No.99CH36278).

[7]  Franco Motika,et al.  Diagnostic techniques for the IBM S/390 600 MHz G5 microprocessor , 1999, International Test Conference 1999. Proceedings (IEEE Cat. No.99CH37034).

[8]  Wu-Tung Cheng,et al.  A complete test set to diagnose scan chain failures , 2007, 2007 IEEE International Test Conference.

[9]  Geetani Edirisooriya,et al.  Diagnosis of scan path failures , 1995, Proceedings 13th IEEE VLSI Test Symposium.

[10]  R. J. McNulty,et al.  Partner SRLs for improved shift register diagnostics , 1992, Digest of Papers. 1992 IEEE VLSI Test Symposium.

[11]  Eric M. Schwarz,et al.  IBM POWER6 microarchitecture , 2007, IBM J. Res. Dev..

[12]  Edward I. Cole,et al.  Novel failure analysis techniques using photon probing with a scanning optical microscope , 1994, Proceedings of 1994 IEEE International Reliability Physics Symposium.

[13]  D. Benson,et al.  TIVA and SEI Developments for Enhanced Front and Backside Interconnection Failure Analysis , 1999 .

[14]  Mario Paniccia,et al.  Novel optical probing technique for flip chip packaged microprocessors , 1998, Proceedings International Test Conference 1998 (IEEE Cat. No.98CH36270).

[15]  J. Kash,et al.  Dynamic internal testing of CMOS circuits using hot luminescence , 1997, IEEE Electron Device Letters.

[16]  Srikanth Venkataraman,et al.  A technique for fault diagnosis of defects in scan chains , 2001, Proceedings International Test Conference 2001 (Cat. No.01CH37260).

[17]  Melvin A. Breuer,et al.  Digital systems testing and testable design , 1990 .

[18]  Alan J. Weger,et al.  Transmission line pulse picosecond imaging circuit analysis methodology for evaluation of ESD and latchup , 2003, 2003 IEEE International Reliability Physics Symposium Proceedings, 2003. 41st Annual..

[19]  Jeremy A. Rowlette,et al.  Critical timing analysis in microprocessors using near-ir laser assisted device alteration (lada) , 2003, International Test Conference, 2003. Proceedings. ITC 2003..

[20]  Kiyoshi Nikawa,et al.  New capabilities of OBIRCH method for fault localization and defect detection , 1997, Proceedings Sixth Asian Test Symposium (ATS'97).