An efficient mathematical model for air-breathing PEM fuel cells

A simple and efficient mathematical model for air-breathing proton exchange membrane (PEM) fuel cells has been built. One of the major objectives of this study is to investigate the effects of the Joule and entropic heat sources, which are often neglected, on the performance of air-breathing PEM fuel cells. It is found that the fuel cell performance is significantly over-predicted if one or both of these heat sources is not incorporated into the model. Also, it is found that the performance of the fuel cell is highly sensitive to the state of the water at the thermodynamic equilibrium magnitude as both the entropic heat and the Nernst potential considerably increase if water is assumed to be produced in liquid form rather than in vapour form. Further, the heat of condensation is shown to be small and therefore, under single-phase modelling, has a negligible effect on the performance of the fuel cell. Finally, the favourable ambient conditions depend on the operating cell potential. At intermediate cell potentials, a mild ambient temperature and low humidity are favoured to maintain high membrane conductivity and mitigate water flooding. At low cell potentials, low ambient temperature and high humidity are favoured to prevent membrane dehydration.

[1]  Siti Kartom Kamarudin,et al.  Passive direct methanol fuel cells for portable electronic devices , 2011 .

[2]  S. Kjelstrup,et al.  Calculation of reversible electrode heats in the proton exchange membrane fuel cell from calorimetric measurements , 2011 .

[3]  P. Ekdunge,et al.  Proton Conductivity of Nafion 117 as Measured by a Four‐Electrode AC Impedance Method , 1996 .

[4]  S. Dutta,et al.  Numerical prediction of mass-exchange between cathode and anode channels in a PEM fuel cell , 2001 .

[5]  T. Henriques,et al.  Increasing the efficiency of a portable PEM fuel cell by altering the cathode channel geometry: A numerical and experimental study , 2010 .

[6]  T. Springer,et al.  Polymer Electrolyte Fuel Cell Model , 1991 .

[7]  In-Hwan Oh,et al.  Effects of cathode open area and relative humidity on the performance of air-breathing polymer electrolyte membrane fuel cells , 2006 .

[8]  Ned Djilali,et al.  Mathematical modelling of ambient air-breathing fuel cells for portable devices , 2007 .

[9]  D. Ingham,et al.  The in-plane thermal conductivity and the contact resistance of the components of the membrane electrode assembly in proton exchange membrane fuel cells , 2013 .

[10]  Sandip Mazumder,et al.  Rigorous 3-D mathematical modeling of PEM fuel cells. II. Model predictions with liquid water transport , 2003 .

[11]  Andreas Schmitz,et al.  Modelling Approach for Planar Self‐Breathing PEMFC and Comparison with Experimental Results , 2004 .

[12]  D. Maillet,et al.  Heat sources in proton exchange membrane (PEM) fuel cells , 2009 .

[13]  Mark W. Verbrugge,et al.  A Mathematical Model of the Solid‐Polymer‐Electrolyte Fuel Cell , 1992 .

[14]  Fritz B. Prinz,et al.  Engineering model of a passive planar air breathing fuel cell cathode , 2007 .

[15]  D. Ingham,et al.  Effects of anisotropic permeability and electrical conductivity of gas diffusion layers on the performance of proton exchange membrane fuel cells , 2012 .

[16]  Wei Yuan,et al.  Dominance evaluation of structural factors in a passive air-breathing direct methanol fuel cell based on orthogonal array analysis , 2011 .

[17]  Hideaki Imura,et al.  Natural-convection heat transfer from a plate with arbitrary inclination , 1972 .

[18]  Alfredo Iranzo,et al.  Numerical model for the performance prediction of a PEM fuel cell. Model results and experimental va , 2010 .

[19]  P. Ekdunge,et al.  Modelling the PEM fuel cell cathode , 1997 .

[20]  Xianguo Li,et al.  Improved experimental method for measuring gas diffusivity through thin porous media , 2013 .

[21]  Adam Z. Weber,et al.  Coupled Thermal and Water Management in Polymer Electrolyte Fuel Cells , 2006 .

[22]  Ned Djilali,et al.  Reduced-dimensional models for straight-channel proton exchange membrane fuel cells , 2010 .

[23]  Chao-Yang Wang,et al.  Computational Fluid Dynamics Modeling of Proton Exchange Membrane Fuel Cells , 2000 .

[24]  Ned Djilali,et al.  A 3D, Multiphase, Multicomponent Model of the Cathode and Anode of a PEM Fuel Cell , 2003 .

[25]  Suk Won Cha,et al.  Air-breathing miniature planar stack using the flexible printed circuit board as a current collector , 2009 .

[26]  Narissara Bussayajarn,et al.  Planar air breathing PEMFC with self-humidifying MEA and open cathode geometry design for portable applications , 2009 .

[27]  Lin Ma,et al.  Thermal modelling of the cathode in air-breathing PEM fuel cells , 2013 .

[28]  Hyunchul Ju,et al.  A single-phase, non-isothermal model for PEM fuel cells , 2005 .

[29]  Ranga Pitchumani,et al.  Numerical studies on an air-breathing proton exchange membrane (PEM) fuel cell stack , 2007 .

[30]  Matthew M. Mench,et al.  Fuel Cell Engines , 2008 .

[31]  Ajit Kumar Kolar,et al.  A model for a vertical planar air breathing PEM fuel cell , 2007 .

[32]  Jon G. Pharoah,et al.  The Seebeck coefficient and the Peltier effect in a polymer electrolyte membrane cell with two hydrogen electrodes , 2013 .

[33]  Ned Djilali,et al.  THREE-DIMENSIONAL COMPUTATIONAL ANALYSIS OF TRANSPORT PHENOMENA IN A PEM FUEL CELL , 2002 .

[34]  Frano Barbir,et al.  PEM Fuel Cells , 2006 .

[35]  S. Kandlikar,et al.  A critical review of cooling techniques in proton exchange membrane fuel cell stacks , 2012 .

[36]  Song-Yul Choe,et al.  Modeling and simulation of a PEM fuel cell stack considering temperature effects , 2006 .

[37]  S. M. Ghiaasiaan,et al.  Convective Heat and Mass Transfer , 2011 .

[38]  M. Mench,et al.  Direct measurement of through-plane thermal conductivity and contact resistance in fuel cell materials , 2006 .

[39]  C. Lee,et al.  A study on the overall efficiency of direct methanol fuel cell by methanol crossover current , 2010 .

[40]  Suk Won Cha,et al.  The role of ambient conditions on the performance of a planar, air-breathing hydrogen PEM fuel cell , 2006 .

[41]  Ranga Pitchumani,et al.  Numerical studies on an air-breathing proton exchange membrane (PEM) fuel cell , 2007 .