High-loaded Fe-supported catalyst for the thermochemical BTL-FT process: Experimental results and modelling

The biomass-to-liquid Fischer-Tropsch (FT) process is an industrial process that converts bio-syngas in hydrocarbons ranging from C1–C100. Bio-syngas, a syngas mixture produced from biomass, is characterized by a H2/CO molar ratio in the range 1.0–1.5. An iron-based catalyst supported on silica for CO hydrogenation with 30 g/g of metal was prepared, characterized by BET, SEM, TEM, TPR, XRD and tested at different temperatures and H2/CO ratios in a FT bench scale plant using a Packed Bed Reactor (PBR). The experimental results demonstrated that this catalyst is also suitable for low H2/CO ratios, since by increasing the inlet H2/CO ratio, the CO conversion increases, the product selectivity remains largely unchanged, and the catalyst shows a satisfactory stability as a function of time of stream (TOS). Based on the collected data, a rigorous multi-scale simulation of reactor behaviour was developed in order to support the experimental tests and predict the reactor yield and conversion. The elaborated kinetic model is based on the hypothesis that both FT and Water Gas Shift (WGS) reactions are active on the catalyst, and the calculated results agree with the obtained experimental data.

[1]  Gilbert F. Froment,et al.  Kinetics of the Fischer-Tropsch reaction on a precipitated promoted iron catalyst. 2. Kinetic modeling , 1993 .

[2]  Jia Yang,et al.  Fischer–Tropsch synthesis: A review of the effect of CO conversion on methane selectivity , 2014 .

[3]  D. Bukur,et al.  Activation studies with a precipitated iron catalyst for Fischer-Tropsch synthesis. I. Characterization studies , 1995 .

[4]  Sayyed Faramarz Tayyari,et al.  Kinetics of the water-gas shift reaction in Fischer-Tropsch synthesis over a nano-structured iron catalyst , 2010 .

[5]  Ahmad Rafiee,et al.  Optimal design issues of a gas-to-liquid process , 2012 .

[6]  Anthony V. Bridgwater,et al.  Thermochemical Processing of Biomass , 2019 .

[7]  Abhaya K. Datye,et al.  Phase Transformations in Iron Fischer–Tropsch Catalysts during Temperature-Programmed Reduction , 2000 .

[8]  F. Yu,et al.  Application of Fischer–Tropsch Synthesis in Biomass to Liquid Conversion , 2012 .

[9]  C. Bianchi,et al.  Choosing the best diluent for a fixed catalytic bed: The case of CO hydrogenation , 2006 .

[10]  C. H. Bartholomew,et al.  Highly active and stable supported iron Fischer–Tropsch catalysts: Effects of support properties and SiO2 stabilizer on catalyst performance , 2014 .

[11]  G. V. D. Laan,et al.  Kinetics and Selectivity of the Fischer–Tropsch Synthesis: A Literature Review , 1999 .

[12]  W. Shafer,et al.  Fischer–Tropsch Synthesis: Effect of Activation Gas After Varying Cu Promoter Loading Over K-Promoted Fe-Based Catalyst , 2014, Catalysis Letters.

[13]  K. Sing.  Reporting physisorption data for gas/solid systems with special reference to the determination of surface area and porosity (Recommendations 1984) , 1985 .

[14]  Carlo Pirola,et al.  Fischer Tropsch and Water Gas Shift chemical regimes on supported iron-based catalysts at high metal loading , 2009 .

[15]  S. Abelló,et al.  Exploring iron-based multifunctional catalysts for Fischer-Tropsch synthesis: a review. , 2011, ChemSusChem.

[16]  Dragomir B. Bukur,et al.  Reaction kinetics over iron catalysts used for the fischer‐tropsch synthesis , 1990 .

[17]  Carlo Pirola,et al.  High Loading Fe-supported Fischer–Tropsch Catalysts: Optimization of the Catalyst Performance , 2009 .

[18]  Heon Jung,et al.  Negative Effects of CO2 in the Feed Stream on the Catalytic Performance of Precipitated Iron-Based Catalysts for Fischer–Tropsch Synthesis , 2012, Catalysis Letters.

[19]  M. Virginie,et al.  Support effects in high temperature Fischer-Tropsch synthesis on iron catalysts , 2014 .

[20]  B. Jovic,et al.  Mg-Fe-mixed oxides derived from layered double hydroxides: A study of the surface properties , 2011 .