Modelling of cracks developed in lithium-ion cells under mechanical loading

This research reports on an experimental and numerical study of material failure in the electrode assemblies (i.e. “jelly roll” and/or “electrode stack”) of lithium-ion batteries after local mechanical loading. Deformed cylindrical and pouch cells (i.e. lithium-ion polymer cells) were subjected to X-ray computed tomography (CT scanning) to detect location, size, and orientation of cracks that developed in the electrode assemblies at onset of short-circuit. An experimental program was completed to acquire properties of electrode–separator micro components of electrode assemblies in tension. This data was used for calibration of an anisotropic material model. Finite element models were developed for both cell types and a maximum strain criteria was used for element failure and deletion at short circuit. The models developed here predict the location of cracks in both pouch and cylindrical cells. The finite element models corroborated the CT scan regarding location and orientation of cracks formed in the electrode assemblies. In both pouch and cylindrical cells, cracks were found to initiate perpendicular to the transverse direction of the separator.

[1]  Azadeh Sheidaei,et al.  Mechanical behavior of a battery separator in electrolyte solutions , 2011 .

[2]  Nigel P. Brandon,et al.  Investigation of lithium-ion polymer battery cell failure using X-ray computed tomography , 2011 .

[3]  W. Lai,et al.  Mechanical behavior of representative volume elements of lithium-ion battery cells under compressive loading conditions , 2014 .

[4]  Gi‐Heon Kim,et al.  A three-dimensional thermal abuse model for lithium-ion cells , 2007 .

[5]  T. Wierzbicki,et al.  Modeling and short circuit detection of 18650 Li-ion cells under mechanical abuse conditions , 2012 .

[6]  T. Wierzbicki,et al.  Calibration and finite element simulation of pouch lithium-ion batteries for mechanical integrity , 2012 .

[7]  Ahmad Pesaran,et al.  Battery thermal models for hybrid vehicle simulations , 2002 .

[8]  Simon Zabler,et al.  In situ investigation of the discharge of alkaline Zn–MnO2 batteries with synchrotron x-ray and neutron tomographies , 2007 .

[9]  T. Wierzbicki,et al.  Homogenized mechanical properties for the jellyroll of cylindrical Lithium-ion cells , 2013 .

[10]  E. Roth,et al.  Simulation of abuse tolerance of lithium-ion battery packs , 2007 .

[11]  Lars Greve,et al.  Mechanical testing and macro-mechanical finite element simulation of the deformation, fracture, and short circuit initiation of cylindrical Lithium ion battery cells , 2012 .

[12]  W. Lai,et al.  Computational models for simulations of lithium-ion battery cells under constrained compression tests , 2013 .

[13]  Elena Sherman,et al.  Design and fabrication of multifunctional structural batteries , 2009 .

[14]  T. Wierzbicki,et al.  Characterizing and modeling mechanical properties and onset of short circuit for three types of lithium-ion pouch cells , 2014 .

[15]  Sang-Moon Hwang,et al.  Investigation on blanking of thin sheet metal using the ductile fracture criterion and its experimental verification , 2004 .

[16]  Yong Xia,et al.  Damage of cells and battery packs due to ground impact , 2014 .