Model extractions of coupled bonding-wire structures in electronic packaging

An extracted model of coupled bonding wires is presented. The discontinuity caused by the bonding wires would significantly affect the high-speed performance of the whole system as the speed of signal propagation is increasing. The bonding wire structures with regards to the vertical and parallel coupling schemes are analyzed in this paper while their middle interconnections are represented as the cascade network of uniform transmission-line sections. Finally, the validation is implemented by using the established models and measurements to verify the presented analysis methods.

[1]  Stephen H. Hall,et al.  High-Speed Digital System Design: A Handbook of Interconnect Theory and Design Practices , 2000 .

[2]  T. Krems,et al.  Millimeter-wave performance of chip interconnections using wire bonding and flip chip , 1996, 1996 IEEE MTT-S International Microwave Symposium Digest.

[3]  Justin Davis,et al.  High-Speed Digital System Design , 2006, High-Speed Digital System Design.

[4]  F. Alimenti,et al.  Quasi static analysis of microstrip bondwire interconnects , 1995, Proceedings of 1995 IEEE MTT-S International Microwave Symposium.

[5]  L. Roselli,et al.  An equivalent circuit for the double bonding wire interconnection , 1999, 1999 IEEE MTT-S International Microwave Symposium Digest (Cat. No.99CH36282).

[6]  Roberto Sorrentino,et al.  Modeling and characterization of the bonding-wire interconnection , 2001 .