Improvement of sidewall surface roughness in silicon-on-insulator rib waveguides

Silicon-on-insulator (SOI) rib waveguides with residual sidewall roughness were fabricated through inductive coupled plasma reactive ion etching (ICPRIE) process. The sidewall surface morphology was characterized by scan electron microscope (SEM), and the root mean square (rms) roughness of the sidewall surface was directly measured by atomic force microscope (AFM). Sidewall surface roughness is the dominant scattering loss source. The ripples on the sidewall surface could be eliminated by mixed ICPRIE, and the rms roughness could be low down to 0.3 nm after thermal oxidation and hf rinse. According to the scattering theory developed by Payne and Lacey, the scattering loss could be minimized to below 0.01 dB/cm. The results indicated that the scattering loss would be a sharp fall by the combination with these two techniques.

[1]  P. Dumon,et al.  Nanophotonic waveguides in silicon-on-insulator fabricated with CMOS technology , 2005, Journal of Lightwave Technology.

[2]  Wim Bogaerts,et al.  Scattering at sidewall roughness in photonic crystal slabs. , 2003, Optics letters.

[3]  J. Ogilvy,et al.  Rough surfaces: gaussian or exponential statistics? , 1989 .

[4]  Lionel C. Kimerling,et al.  Losses in polycrystalline silicon waveguides , 1996 .

[5]  M. Paniccia,et al.  A high-speed silicon optical modulator based on a metal–oxide–semiconductor capacitor , 2004, Nature.

[6]  JeongYong Lee,et al.  Structural modification of a trench by hydrogen annealing , 2000 .

[7]  Joseph H. Abeles,et al.  Direct measurement of nanoscale sidewall roughness of optical waveguides using an atomic force microscope , 2003 .

[8]  L. Vivien,et al.  Size influence on the propagation loss induced by sidewall roughness in ultrasmall SOI waveguides , 2004, IEEE Photonics Technology Letters.

[9]  F. Payne,et al.  A theoretical analysis of scattering loss from planar optical waveguides , 1994 .

[10]  Ali Shakouri,et al.  InP-based passive ring-resonator-coupled lasers , 2003 .

[11]  Yuichi Sakai,et al.  Improvement of sidewall roughness in deep silicon etching , 2000 .

[12]  A. Koster,et al.  Low-loss optical waveguide on standard SOI/SIMOX substrate , 1998 .

[13]  Wensyang Hsu,et al.  Sidewall roughness control in advanced silicon etch process , 2003 .

[14]  L C Kimerling,et al.  Fabrication of ultralow-loss Si/SiO(2) waveguides by roughness reduction. , 2001, Optics letters.

[15]  Chung-Yen Chao,et al.  Thermal-flow technique for reducing surface roughness and controlling gap size in polymer microring resonators , 2004 .