Embedded Laser Doppler Velocimetry Boundary-Layer Investigation on a Tilt-Rotor Blade

A fundamental study is made of a rotating boundary layer (BL) in the inboard region of a tilt-rotor blade, using an embedded laser Doppler velocimetry probe inside a rotating blade. Velocity measurements have been performed to get insight into the BL behavior around a blade section close to the rotor hub.,BL transition and separation phenomena are investigated on the basis of both chordwise and spanwise velocity profiles measured for different collective pitch angles on a two-bladed hovering rotor. The velocity. experimental data bank appears to be in good agreement with theoretical velocity profiles in attached How conditions (laminar, transitional, or turbulent). Moreover, validation of a transitional criterion based on the second thickness of energy delta'(3) of the BL is extended to the rotational flow configuration. Usually such a configuration classically exhibits a separation of the BL for high collective pitch angles. However, in the particular case of a high twisted tilt-rotor blade operating in, hover, centrifugal effects are shown to be responsible for an important delay in the BL separation process.

[1]  K. Rinoie,et al.  Oscillating behaviour of laminar separation bubble formed on an aerofoil near stall , 2004, The Aeronautical Journal (1968).

[2]  Harvey H. Hubbard,et al.  Aeroacoustics of Flight Vehicles: Theory and Practice , 1994 .

[3]  Larry A Young.  Tilt Rotor Aeroacoustic Model (TRAM): A New Rotorcraft Research Facility , 1998 .

[4]  Narayanan Komerath,et al.  Rotor Wake/Fixed Wing Interactions with Flap Deflection , 1999 .

[5]  Wayne Johnson.  Calculation of the Aerodynamic Behavior of the Tilt Rotor Aeroacoustic Model (TRAM) in the DNW , 2001 .

[6]  Roger L. Simpson,et al.  Surface Pressure Fluctuations Beneath Two- and Three-Dimensional Turbulent Boundary Layers , 2000 .

[7]  Neil D. Sandham,et al.  Direct numerical simulation of ‘short’ laminar separation bubbles with turbulent reattachment , 2000, Journal of Fluid Mechanics.

[8]  P. Sagaut,et al.  Large Eddy Simulation of Flow Around an Airfoil Near Stall , 2002 .

[9]  K. Pengel,et al.  FLOW MEASUREMENTS OF AN ISOLATED MODEL TILT ROTOR , 1999 .

[10]  M. S. Chandrasekhara,et al.  Quantitative study of unsteady compressible flow on an oscillating airfoil , 1994 .

[11]  Wayne Johnson.  Airloads and Wake Geometry Calculations for an Isolated Tiltrotor Model in a Wind Tunnel , 2001 .

[12]  L. Carr.  Progress in analysis and prediction of dynamic stall , 1988 .

[13]  E. Berton,et al.  Embedded LDV measurement methods applied to unsteady flow investigation , 2001 .

[14]  Michael B. Bragg,et al.  Flow oscillation over an airfoil near stall , 1996 .

[15]  Tadghighi Hormoz,et al.  Acoustic Characteristics of a Model Isolated Tiltrotor in DNW , 1999 .