Micromachined gyroscopes based on a rotating mechanically unconstrained proof mass

This paper describes the state-of-the-art of micromachined gyroscopes based on a spinning, electrostatically suspended rotor as proof mass. This approach has numerous advantages over the prevailing approach for MEMS gyroscopes relying on a two degree of freedom vibrating structure and Coriolis force coupling between two modes. The key benefits of a gyroscope with a suspended rotor are its higher scale factor, the absence of mode coupling issues such as quadrature error and that there is no need to tune modal resonant frequencies. The paper reviews the literature on gyroscopes with a spinning, mechanically unconstrained rotor and then reports on the authors' effort to develop such a gyroscope.

[1]  Bruce L. Golden,et al.  Optimisation , 1982, IEEE Trans. Syst. Man Cybern..

[2]  K. J. Gabriel,et al.  Design considerations for a practical electrostatic micro-motor , 1987 .

[3]  Stephen F. Bart,et al.  A study of three microfabricated variable-capacitance motors , 1990 .

[4]  Timothy J. Hawkey,et al.  Integrated microgyroscope , 1992, Defense, Security, and Sensing.

[5]  Vijay Gondhalekar,et al.  Electrostatically suspended and sensed micromechanical rate gyroscope , 1994, Defense, Security, and Sensing.

[6]  C. Shearwood,et al.  Levitation of a micromachined rotor for application in a rotating gyroscope , 1995 .

[7]  R. B. Yates,et al.  Initial fabrication of a micro-induction gyroscope , 1996 .

[8]  Gyroscope spin axis direction control for the Gravity Probe B satellite , 1996, Proceedings of 35th IEEE Conference on Decision and Control.

[9]  Thor Nelson Juneau.  Micromachined Dual Input Axis Rate Gyroscope , 1997 .

[10]  M. L. Nagy,et al.  A capacitive sensing integrated circuit for detection of micromotor critical angles , 1997, IEEE J. Solid State Circuits.

[11]  C. Shearwood,et al.  Modelling and testing of a frictionless levitated micromotor , 1997 .

[12]  Michael Kraft,et al.  Closed Loop Silicon Accelerometers , 1998 .

[13]  M. L. Nagy,et al.  An IC for closed-loop control of a micromotor with an electrostatically levitated rotor , 1999, ISCAS'99. Proceedings of the 1999 IEEE International Symposium on Circuits and Systems VLSI (Cat. No.99CH36349).

[14]  C. Shearwood,et al.  Development of a levitated micromotor for application as a gyroscope , 2000 .

[15]  K. Najafi,et al.  A HARPSS polysilicon vibrating ring gyroscope , 2001 .

[16]  Michael Kraft,et al.  Modelling of an accelerometer based on a levitated proof mass , 2002 .

[17]  L. E. Costlow,et al.  Common design techniques for BEI GyroChip quartz rate sensors for both automotive and aerospace/defense markets , 2003 .

[18]  M. Esashi,et al.  Electrostatically Levitated Ring-Shaped Rotational-Gyro/Accelerometer , 2003 .

[19]  E. Koukharenko,et al.  Optimisation, design and fabrication of a novel accelerometer , 2003, TRANSDUCERS '03. 12th International Conference on Solid-State Sensors, Actuators and Microsystems. Digest of Technical Papers (Cat. No.03TH8664).

[20]  Alan H. Epstein,et al.  Millimeter-Scale, Micro-Electro-Mechanical Systems Gas Turbine Engines , 2004 .

[21]  Michael Kraft,et al.  Modelling squeeze film effects in a MEMS accelerometer with a levitated proof mass , 2005 .

[22]  S. Nakamura,et al.  MEMS inertial sensor toward higher accuracy & multi-axis sensing , 2005, IEEE Sensors, 2005..

[23]  F. Ayazi,et al.  A low cost wafer-level MEMS packaging technology , 2005, 18th IEEE International Conference on Micro Electro Mechanical Systems, 2005. MEMS 2005..

[24]  B. Damrongsak,et al.  A micromachined electrostatically suspended gyroscope with digital force feedback , 2005, IEEE Sensors, 2005..

[25]  Michael Kraft,et al.  A high-performance accelerometer with a fifth-order sigma–delta modulator , 2005 .

[26]  Badin Damrongsak,et al.  Design and Simulation of a Micromachined Electrostatically Suspended Gyroscope , 2006 .

[27]  Farrokh Ayazi,et al.  Wafer-level MEMS packaging via thermally released metal-organic membranes , 2006 .

[28]  Wenyuan Chen,et al.  Development of a micromachined rotating gyroscope with electromagnetically levitated rotor , 2006 .

[29]  M. Mehregany,et al.  Design and fabrication of a micromachined electrostatically suspended gyroscope , 2008 .

[30]  C. Hierold,et al.  Determination of the Pull-Off Forces and Pull-Off Dynamics of an Electrostatically Actuated Silicon Disk , 2008, Journal of Microelectromechanical Systems.