Numerical investigation of the oxy-fuel combustion in large scale boilers adopting the ECO-Scrub technology

The present paper presents a three-dimensional numerical investigation of a pulverized-fuel, tangentially-fired utility boiler located at Florina/Greece under air, partial and full oxy-fuel conditions. Heat and mass transfer and major species concentration, such as CO2, CO and O2 are calculated; whilst the results for the reference air case scenario studied are in good agreement with the corresponding operational data measured in the plant, both for combustion calculations and NOx emissions. Results for the partial and full oxy-fuel operation scenarios are in line with similar experimental and numerical investigations found in the recent literature. This numerical investigation of oxy-fuel conditions scenarios prior to their implementation under real scale conditions demonstrates the utmost of its importance, since significant results regarding the operation of a boiler in terms of lignite particle trajectories and burning rates are attained. Furthermore, NOx calculations have been performed for all the examined case studies.

[1]  Behdad Moghtaderi,et al.  An overview on oxyfuel coal combustion—State of the art research and technology development , 2009 .

[2]  G. Soete.  Overall reaction rates of NO and N2 formation from fuel nitrogen , 1975 .

[3]  Roman Weber,et al.  Evaluation of emissivity correlations for H2OCO2N2/air mixtures and coupling with solution methods of the radiative transfer equation , 1996 .

[4]  D. Vamvuka,et al.  A comparative reactivity and kinetic study on the combustion of coal–biomass char blends , 2006 .

[5]  Eric Croiset,et al.  Combustion characteristics of coal in a mixture of oxygen and recycled flue gas , 2006 .

[6]  R. Hurt,et al.  Semi-global intrinsic kinetics for char combustion modeling Entry 2 has also been referred to as , 2001 .

[7]  B. Chojnowski.  Research and Operational Measurements on Modern Power Station Boilers A Selective Survey , 1985 .

[8]  S. A. Morsi,et al.  An investigation of particle trajectories in two-phase flow systems , 1972, Journal of Fluid Mechanics.

[9]  Eric Croiset,et al.  Coal combustion in O2/CO2 mixtures compared with air , 2000 .

[10]  Eric Croiset,et al.  NOx and SO2 emissions from O2/CO2 recycle coal combustion , 2001 .

[11]  Takashi Kiga,et al.  Characteristics of pulverized-coal combustion in the system of oxygen/recycled flue gas combustion , 1997 .

[12]  R. Kurose,et al.  Numerical analysis of pulverized coal combustion characteristics using advanced low-NOx burner , 2004 .

[13]  Michael B Wilkinson,et al.  CO2 Capture via Oxyfuel Firing: Optimisation of a Retrofit Design Concept for a Refinery Power Station Boiler , 2001 .

[14]  D. Bouris,et al.  Numerical calculation of the effect of deposit formation on heat-exchanger efficiency , 1997 .

[15]  E. Croiset,et al.  Coal combustion with flue gas recirculation for CO2 recovery , 1999 .

[16]  A. Doukelis,et al.  Oxyfuel boiler design in a lignite-fired power plant , 2007 .

[17]  Chang Nyung Kim,et al.  Numerical investigation on the flow, combustion and NOx emission characteristics in a 500 MWe tangentially fired pulverized-coal boiler , 2009 .

[18]  Adel F. Sarofim,et al.  NO/char reactions at pulverized coal flame conditions , 1981 .

[19]  M. Baum,et al.  Predicting the Combustion Behaviour of Coal Particles , 1971 .

[20]  Luis I. Díez,et al.  Modelling of pulverized coal boilers: review and validation of on-line simulation techniques , 2005 .

[21]  Antonio Valero,et al.  Combustion and heat transfer monitoring in large utility boilers , 2001 .

[22]  Eric Croiset,et al.  Techno-economic study of CO2 capture from an existing coal-fired power plant: MEA scrubbing vs. O2/CO2 recycle combustion , 2003 .

[23]  B. M. Gibbs,et al.  Comparisons of pulverized coal combustion in air and in mixtures of O2/CO2 , 2005 .

[24]  Takashi Kiga,et al.  Analysis of the flame formed during oxidation of pulverized coal by an O2-CO2 mixture , 1997 .

[25]  Giorgio Cau,et al.  Numerical simulation of pulverized coal oxy-combustion with exhaust gas recirculation , 2009 .

[26]  David Migdal,et al.  A Source Flow Model for Continuum Gas-Particle Flow , 1967 .

[27]  RajenderKumar Gupta,et al.  Oxy-fuel combustion technology for coal-fired power generation , 2005 .

[28]  Lin Ma,et al.  The combustion of pulverised low grade lignite , 2006 .

[29]  A. Jensen,et al.  Fuel nitrogen conversion in solid fuel fired systems , 2003 .

[30]  J. G. Marakis,et al.  A parametric study of radiative heat transfer in pulverised coal furnaces , 2000 .

[31]  Eddy H. Chui,et al.  Modeling of oxy-fuel combustion for a western Canadian sub-bituminous coal☆ , 2003 .

[32]  G. Ch Bergeles,et al.  Effects of fouling on the efficiency of heat exchangers in lignite utility boilers , 1997 .

[33]  Behdad Moghtaderi,et al.  Factors influencing the ignition of flames from air-fired swirl pf burners retrofitted to oxy-fuel , 2008 .

[34]  L. D. Smoot,et al.  A decade of combustion research , 1997 .

[35]  Brian Stanmore,et al.  Modeling NOx release from a single coal particle I. Formation of NO from volatile nitrogen , 1996 .

[36]  Panagiotis Grammelis,et al.  Partial O2-fired coal power plant with post-combustion CO2 capture: A retrofitting option for CO2 capture ready plants , 2009 .

[37]  I. Naruse,et al.  Fundamental study on N2O formation/decomposition characteristics by means of low-temperature pulverized coal combustion , 1996 .

[38]  M. Field,et al.  Rate of combustion of size-graded fractions of char from a low-rank coal between 1 200°K and 2 000°K , 1969 .

[39]  Filip Johnsson,et al.  Combustion characteristics of lignite-fired oxy-fuel flames , 2009 .

[40]  Takashi Kiga,et al.  The characteristics of pulverized coal combustion in O2/CO2 mixtures for CO2 recovery , 1995 .