Membrane evaporation of amine solution for energy saving in post-combustion carbon capture: Wetting and condensation

Abstract A membrane evaporation system for energy penalty reduction in liquid absorbent based carbon capture and the effects of operating parameters (i.e. evaporation temperature, and gas/liquid flow rates) on mass and heat transfer are systematically investigated. It is found that monoethanolamine (MEA) vapor flux is approximately one order of magnitude lower than water vapor flux for membrane evaporation of 30 wt% MEA solution. Heat flux across the membrane is closely associated with mass transfer and is also influenced by the evaporation efficiency. Experimental results show that membrane wetting and vapor condensation occurs during the evaporation of MEA solution. Both evaporation temperatures and liquid flow rates play important roles in membrane wetting via changing the pressure on the liquid side. Slight wetting may decrease both mass transfer and the associated convective heat transfer across the membrane, but it can also provide benefit by preventing CO 2 absorption into the lean solvent. The occurrence of vapor condensation on the gas side is determined by the gas flow rate. Vapor condensation occurs at low gas flow rates but it will not be a significant operational issue in the membrane evaporator application as long as condensation occurs within the desorber where the latent heat is released and recovered.

[1]  Muftah H. El-Naas,et al.  Evaluation of the removal of CO2 using membrane contactors: Membrane wettability , 2010 .

[2]  Jing-liang Li,et al.  Review of CO2 absorption using chemical solvents in hollow fiber membrane contactors , 2005 .

[3]  Denis Roizard,et al.  Ammonia based CO2 capture process using hollow fiber membrane contactors , 2014 .

[4]  H. A. Rangwala.  Absorption of carbon dioxide into aqueous solutions using hollow fiber membrane contactors , 1996 .

[5]  Meihong Wang,et al.  Post-combustion CO2 capture with chemical absorption: A state-of-the-art review , 2011 .

[6]  P. Feron,et al.  Membrane evaporation of amine solution for energy saving in post-combustion carbon capture: Performance evaluation , 2015 .

[7]  Zou Yong,et al.  Adsorption of carbon dioxide at high temperature—a review , 2002 .

[8]  Paul Feron,et al.  Exploring the potential for improvement of the energy performance of coal fired power plants with post-combustion capture of carbon dioxide , 2010 .

[9]  Paul Feron,et al.  Condensation studies in membrane evaporation and sweeping gas membrane distillation , 2014 .

[10]  Mohamed Khayet,et al.  Thermal boundary layers in sweeping gas membrane distillation processes , 2002 .

[11]  Mohamed Khayet,et al.  Nature of flow on sweeping gas membrane distillation , 2000 .

[12]  Paitoon Tontiwachwuthikul,et al.  Using polypropylene and polytetrafluoroethylene membranes in a membrane contactor for CO2 absorption , 2006 .

[13]  Edward L Cussler,et al.  Microporous hollow fibers for gas absorption : II. Mass transfer across the membrane , 1985 .

[14]  Fernando G. Martins,et al.  Recent developments on carbon capture and storage: An overview , 2011 .

[15]  Jian-Gang Lu,et al.  Wetting mechanism in mass transfer process of hydrophobic membrane gas absorption , 2008 .

[16]  Imona C. Omole.  Hollow-fiber membrane contactors , 1999 .

[17]  Jiuping Xu,et al.  Greenhouse Gas Control , 2014 .

[18]  Mohamed Khayet,et al.  Theory and experiments on sweeping gas membrane distillation , 2000 .

[19]  G. Stevens,et al.  Membrane stripping: Desorption of carbon dioxide from alkali solvents , 2011 .

[20]  Edward L Cussler,et al.  Microporous hollow fibers for gas absorption. I. Mass transfer in the liquid , 1985 .

[21]  Jun-de Li,et al.  Influence of module design and membrane compressibility on VMD performance , 2013 .

[22]  Shuaifei Zhao,et al.  Biogas upgrading by CO2 removal with a highly selective natural amino acid salt in gas–liquid membrane contactor , 2014 .

[23]  Ahmad Fauzi Ismail,et al.  Preparation of polyvinylidene fluoride hollow fiber membranes for CO2 absorption using phase-inversion promoter additives , 2010 .

[24]  Haiqing Lin,et al.  Power plant post-combustion carbon dioxide capture: An opportunity for membranes , 2010 .

[25]  Denis Roizard,et al.  A dense membrane contactor for intensified CO 2 gas/liquid absorption in post-combustion capture , 2011 .

[26]  Paitoon Tontiwachwuthikul,et al.  Comparing the Absorption Performance of Packed Columns and Membrane Contactors , 2005 .

[27]  É. Favre,et al.  Gas-liquid separation processes based on physical solvents: opportunities for membranes , 2014 .

[28]  Matthias Wessling,et al.  Selection of top layer materials for gas-liquid membrane contactors , 2004 .

[29]  A. E. Jansen,et al.  Membrane Contactors in Industrial Applications , 2005 .

[30]  Su Lin,et al.  Absorption of carbon dioxide by mixed piperazine–alkanolamine absorbent in a plasma-modified polypropylene hollow fiber contactor , 2009 .

[31]  Zhong-yang Luo,et al.  CO2 desorption from rich alkanolamine solution by using membrane vacuum regeneration technology , 2012 .

[32]  M. Iliuta,et al.  Wetting phenomenon in membrane contactors – Causes and prevention , 2014 .

[33]  Young Moo Lee,et al.  High performance polymer membranes for CO2 separation , 2013 .

[34]  Denis Roizard,et al.  Membrane Contactors for Postcombustion Carbon Dioxide Capture: A Comparative Study of Wetting Resistance on Long Time Scales , 2011 .

[35]  Jun-de Li,et al.  Modelling heat and mass transfers in DCMD using compressible membranes , 2012 .

[36]  Timothy E. Fout,et al.  Advances in CO2 capture technology—The U.S. Department of Energy's Carbon Sequestration Program ☆ , 2008 .

[37]  Denis Roizard,et al.  Modeling of CO2 post-combustion capture using membrane contactors, comparison between one- and two-dimensional approaches , 2014 .

[38]  Jun-de Li,et al.  Effect of applied pressure on performance of PTFE membrane in DCMD , 2011 .

[39]  P. Feron,et al.  Innovative use of membrane contactor as condenser for heat recovery in carbon capture. , 2015, Environmental science & technology.

[40]  Kang Li,et al.  Use of permeation and absorption methods for CO2 removal in hollow fibre membrane modules , 1998 .

[41]  Jianhua Zhang,et al.  Condensation, re-evaporation and associated heat transfer in membrane evaporation and sweeping gas membrane distillation , 2015 .

[42]  Rong Wang,et al.  Effect of membrane structure on mass-transfer in the membrane gas–liquid contacting process using microporous PVDF hollow fibers , 2006 .

[43]  Anthony G. Fane,et al.  Heat and mass transfer in membrane distillation , 1987 .

[44]  G. Versteeg,et al.  Membrane–solvent selection for CO2 removal using membrane gas–liquid contactors , 2004 .

[45]  Geert Versteeg,et al.  New absorption liquids for the removal of CO2 from dilute gas streams using membrane contactors , 2002 .