Study of sintered stainless steel fiber felt as gas diffusion backing in air-breathing DMFC

Abstract Adoption of a sintered stainless steel fiber felt was evaluated as gas diffusion backing in air-breathing direct methanol fuel cell (DMFC). By using a sintered stainless steel fiber felt as an anodic gas diffusion backing, the peak power density of an air-breathing DMFC is 24 mW cm −2 , which is better than that of common carbon paper. A 30-h-life test indicates that the degraded performance of the air-breathing DMFC is primarily due to the water flooding of the cathode. Twelve unit cells with each has 6 cm 2 of active area are connected in series to supply the power to a mobile phone assisted by a constant voltage diode. The maximum power density of 26 mW cm −2 was achieved in the stack, which is higher than that in single cell. The results show that the sintered stainless steel felt is a promising solution to gas diffusion backing in the air-breathing DMFC, especially in the anodic side because of its high electronical conductivity and hydrophilicity.

[1]  Steve Barrett.  Region focus on fuel cells R&D: Canada , 2001 .

[2]  P. Lund,et al.  Titanium sinter as gas diffusion backing in PEMFC , 2003 .

[3]  Emanuel Peled,et al.  Water-neutral micro direct-methanol fuel cell (DMFC) for portable applications , 2003 .

[4]  G. Squadrito,et al.  Effects of the Diffusion Layer Characteristics on the Performance of Polymer Electrolyte Fuel Cell Electrodes , 2001 .

[5]  Heli Wang,et al.  Stainless steel as bipolar plate material for polymer electrolyte membrane fuel cells , 2003 .

[6]  C. Chen,et al.  Performance of an air-breathing direct methanol fuel cell , 2003 .

[7]  Shimshon Gottesfeld,et al.  Thin-film catalyst layers for polymer electrolyte fuel cell electrodes , 1992 .

[8]  Y. Kubo,et al.  Small Direct Methanol Fuel Cell Pack for Portable Applications , 2002 .

[9]  Hubert A. Gasteiger,et al.  Handbook of fuel cells : fundamentals technology and applications , 2003 .

[10]  A. Shukla,et al.  Diffusion layer parameters influencing optimal fuel cell performance , 2000 .

[11]  Won-Yong Lee,et al.  Pore size effect of the DMFC catalyst supported on porous materials , 2003 .

[12]  Chenggang Xie,et al.  Developing micro-fuel cells for wireless communications , 2002 .

[13]  Hong Chang,et al.  Materials and processes for small fuel cells , 2002 .

[14]  Jaesung Han,et al.  Direct methanol fuel-cell combined with a small back-up battery , 2002 .

[15]  E. Ticianelli,et al.  Effects of the cathode gas diffusion layer characteristics on the performance of polymer electrolyte fuel cells , 2002 .