Notch detection in copper tubes immersed in water by leaky compressional guided waves

Abstract Tube- or pipe-like structures are used to convey fluids such as gas, oil or water. These fluids can be transported on land, in sea or in industrial buildings. Hence, tubes can suffer from mechanical, thermal and chemical stresses. The latter, can severely damage these structures due to the oxidation phenomena. This damage weakens the structure and reveals cracks and inhomogeneities. The objective of this work is to detect and characterise damage in tubes immersed in water by a non-destructive method. This research work is devoted to the development of an experimental device. This device can detect and locate axy- and nonaxy-symmetric circumferential small notches located on the outer surface of a filled tube and immersed in water using guided waves. Different sizes of notches are milled into copper tubes with a thin wall are considered. A single transducer is used for emission and reception of leaky guided waves by using the pulse-echo technique. The compressional L(0,2)mode is launched at relatively high frequency using oblique incidence of the transducer into the fluid. By using the wave leakages, notches of small sizes are detected and located. In addition, the sensitivity of the L(0,2) mode to the radial depth and circumferential extent of notches is evaluated. A roughly linear behaviour of the amplitude reflection coefficients is revealed which is in accordance with research works found in the literature.

[1]  Peter W. Tse,et al.  Experimental investigation of reflection in guided wave-based inspection for the characterization of pipeline defects , 2010 .

[2]  A. G. Roosenbrand,et al.  The reflection of the fundamental torsional mode from cracks and notches in pipes. , 2003, The Journal of the Acoustical Society of America.

[3]  Joseph L. Rose,et al.  Thin-Shell approach for elastic wave propagation in a pipe with liquid , 2005 .

[4]  T. Plona,et al.  Axisymmetric wave propagation in fluid‐loaded cylindrical shells. I: Theory , 1992 .

[5]  M. Lowe,et al.  The Reflection of Guided Waves From Circumferential Notches in Pipes , 1998 .

[6]  Peter Cawley,et al.  Guided waves in fluid-filled pipes surrounded by different fluids , 2001 .

[7]  Emmanuel Moulin,et al.  Study of the fundamental Lamb modes interaction with asymmetrical discontinuities , 2008 .

[8]  Joseph L. Rose,et al.  Guided Wave Resonance Tuning for Pipe Inspection , 2002 .

[9]  Sébastien Grondel,et al.  Experimental study of the A0 and S0 Lamb waves interaction with symmetrical notches. , 2009, Ultrasonics.

[10]  Peter Cawley,et al.  THE REFLECTION OF GUIDED WAVES FROM NOTCHES IN PIPES: A GUIDE FOR INTERPRETING CORROSION MEASUREMENTS , 2004 .

[11]  D. Gazis.  Three‐Dimensional Investigation of the Propagation of Waves in Hollow Circular Cylinders. I. Analytical Foundation , 1959 .

[12]  Philip L. Marston,et al.  High-frequency backscattering enhancements by thick finite cylindrical shells in water at oblique incidence: Experiments, interpretation, and calculations , 1998 .

[13]  W. Mohr,et al.  On Inspection of Thin-Walled Tubes for Transverse and Longitudinal Flaws by Guided Ultrasonic Waves , 1976, IEEE Transactions on Sonics and Ultrasonics.

[14]  T. Plona,et al.  Axisymmetric wave propagation in fluid‐loaded cylindrical shells: Theory versus experiment. , 1992 .

[15]  N. Popplewell,et al.  Scattering of Guided Waves by Circumferential Cracks in Steel Pipes , 2001 .

[16]  Emmanuel Moulin,et al.  Study of the fundamental Lamb modes interaction with symmetrical notches , 2008 .

[17]  Gérard Maze,et al.  Resonances of plates and cylinders: Guided waves , 1985 .

[18]  Y. P. Guo,et al.  Approximate solutions of the dispersion equation for fluid‐loaded cylindrical shells , 1994 .

[19]  J. Ditri.  Utilization of guided elastic waves for the characterization of circumferential cracks in hollow cylinders , 1994 .

[20]  Fernand Léon,et al.  Scattering of an obliquely incident acoustic wave by an infinite hollow cylindrical shell , 1992 .