Evaluation of infrared femtosecond laser ablation for the analysis of geomaterials by ICP-MS

The capabilities of an infrared (IR) Ti:sapphire femtosecond laser (≈800 nm) to ablate and analyze geomaterials such as monazite, zircon and synthetic glass reference materials is evaluated, with emphasis on U/Pb ratio determinations useful for dating accessory minerals in rocks. We particularly discuss the influence of pulse duration (respectively 60, 200, 350, 500, 670, 830, 2000 and 3000 fs) on the internal precision (2 min ablation), reproducibility over two weeks and accuracy of quadrupole ICP-MS measurements. The best results for all these criteria are obtained when using the shortest pulse duration (60 fs). It was found that internal precision and reproducibility were improved by a factor of 3 and 4, respectively, from picosecond to 60 fs pulsewidths. Reproducibility at this pulse duration for U/Pb ratio determinations is of 2% RSD or better, depending on the material analyzed, and this ratio is accurate within this uncertainty. Lead isotopic ratios also benefit from the shortest pulsewidth. They are measured at 60 fs with a precision (<0.5% RSD) approaching the limitations of quadrupole ICP-MS. Preliminary data were also obtained using the 3rd harmonic (≈266 nm) of the Ti:sapphire fundamental wavelength and they are compared with the infrared mode. There seems to be no obvious analytical benefit to switch from IR to UV in the femtosecond laser ablation regime. Analyses of zircon 91500 with IR pulses led to better repeatability, around 0.9% (10 values, 1σ), compared to 3% for the UV pulses. The accuracy appears to be comparable for the two wavelengths.

[1]  W. Hartung,et al.  Capabilities of femtosecond laser ablation inductively coupled plasma mass spectrometry for depth profiling of thin metal coatings. , 2007, Analytical chemistry.

[2]  K. Jochum,et al.  Validation of LA-ICP-MS trace element analysis of geological glasses using a new solid-state 193 nm Nd : YAG laser and matrix-matched calibration , 2007 .

[3]  D. Günther,et al.  Performance characteristics of ultra-violet femtosecond laser ablation inductively coupled plasma mass spectrometry at ∼265 and ∼200 nm , 2006 .

[4]  D. Günther,et al.  High efficiency aerosol dispersion cell for laser ablation-ICP-MS , 2006 .

[5]  F. Blanckenburg,et al.  In situ iron isotope ratio determination using UV-femtosecond laser ablation with application to hydrothermal ore formation processes , 2006 .

[6]  K. Niemax,et al.  Non-matrix matched calibration of major and minor concentrations of Zn and Cu in brass, aluminium and silicate glass using NIR femtosecond laser ablation inductively coupled plasma mass spectrometry , 2006 .

[7]  A. Vogel,et al.  Mechanisms of femtosecond laser nanosurgery of cells and tissues , 2005 .

[8]  Salvatore Amoruso,et al.  Ultrashort laser ablation of solid matter in vacuum: a comparison between the picosecond and femtosecond regimes , 2005 .

[9]  Kay Niemax,et al.  Elemental fractionation of dielectric aerosols produced by near-infrared femtosecond laser ablation of silicate glasses , 2005 .

[10]  J. Baker,et al.  Pb isotopic analysis of standards and samples using a 207Pb–204Pb double spike and thallium to correct for mass bias with a double-focusing MC-ICP-MS , 2004 .

[11]  William L. Griffin,et al.  The application of laser ablation-inductively coupled plasma-mass spectrometry to in situ U–Pb zircon geochronology , 2004 .

[12]  Kay Niemax,et al.  Particle size distributions and compositions of aerosols produced by near-IR femto- and nanosecond laser ablation of brass , 2004 .

[13]  S. Mao,et al.  Nanosecond and femtosecond laser ablation of brass: particulate and ICPMS measurements. , 2004, Analytical chemistry.

[14]  F. Poitrasson,et al.  Comparison of ultraviolet femtosecond and nanosecond laser ablation inductively coupled plasma mass spectrometry analysis in glass, monazite, and zircon. , 2003, Analytical chemistry.

[15]  F. Corfu,et al.  Advances in U-Pb geochronology using a frequency quintupled Nd:YAG based laser ablation system (λ= 213 nm) and quadrupole based ICP-MS , 2003 .

[16]  M. Tiepolo,et al.  A laser probe coupled with ICP-double focusing sector-field mass spectrometer for in situ analysis of geological samples and U-Pb dating of zircon , 2003 .

[17]  O. Albert,et al.  Time-resolved spectroscopy measurements of a titanium plasma induced by nanosecond and femtosecond lasers , 2003 .

[18]  D. Günther,et al.  The influence of ablation carrier gasses Ar, He and Ne on the particle size distribution and transport efficiencies of laser ablation-induced aerosols: implications for LA–ICP–MS , 2003 .

[19]  W. Heinrich,et al.  Experimental resetting of the U–Th–Pb systems in monazite , 2002 .

[20]  Xianglei Mao,et al.  Femtosecond laser ablation ICP-MS , 2002 .

[21]  Eric Audouard,et al.  Comparison of heat-affected zones due to nanosecond and femtosecond laser pulses using transmission electronic microscopy , 2002 .

[22]  J. Woodhead,et al.  Strontium, Neodymium and Lead Isotope Analyses of NIST Glass Certified Reference Materials: SRM 610, 612, 614 , 2001 .

[23]  K. Niemax.  Laser ablation – reflections on a very complex technique for solid sampling , 2001, Fresenius' journal of analytical chemistry.

[24]  V. Blanchet,et al.  Observation of coherent transients in ultrashort chirped excitation of an undamped two-level system. , 2001, Physical review letters.

[25]  W. McDonough,et al.  Precise elemental and isotope ratio determination by simultaneous solution nebulization and laser ablation-ICP-MS: application to U-Pb geochronology , 2000 .

[26]  P. Corkum,et al.  Influence of laser parameters and material properties on micro drilling with femtosecond laser pulses , 1999 .

[27]  A. Semerok,et al.  Femtosecond and picosecond laser microablation: ablation efficiency and laser microplasma expansion , 1999 .

[28]  Gerard Mourou,et al.  SHORT-PULSE LASER DAMAGE IN TRANSPARENT MATERIALS AS A FUNCTION OF PULSE DURATION , 1999 .

[29]  Brent C. Stuart,et al.  Ultrashort-pulse laser machining of dielectric materials , 1999 .

[30]  Rick Trebino,et al.  Measuring ultrashort laser pulses in the time-frequency domain using frequency-resolved optical gating , 1997 .

[31]  K. Sokolowski-Tinten,et al.  Laser-solid interaction in the femtosecond time regime , 1997 .

[32]  A. Tünnermann,et al.  Femtosecond, picosecond and nanosecond laser ablation of solids , 1996 .

[33]  P. P. Pronko,et al.  Thermophysical effects in laser processing of materials with picosecond and femtosecond pulses , 1995 .

[34]  W. Griffin,et al.  THREE NATURAL ZIRCON STANDARDS FOR U‐TH‐PB, LU‐HF, TRACE ELEMENT AND REE ANALYSES , 1995 .

[35]  Perry,et al.  Laser-induced damage in dielectrics with nanosecond to subpicosecond pulses. , 1995, Physical review letters.

[36]  P. Arrowsmith.  Laser ablation of solids for elemental analysis by inductively coupled plasma mass spectrometry , 1987 .

[37]  D. Günther,et al.  Effect of particle size distribution on ICP-induced elemental fractionation in laser ablation-inductively coupled plasma-mass spectrometry , 2002 .

[38]  R. Russo,et al.  Influence of wavelength on fractionation in laser ablation ICP-MS , 2000 .

[39]  G. Petite,et al.  Experimental investigations of laser ablation efficiency of pure metals with femto, pico and nanosecond pulses , 1999 .

[40]  D. Günther,et al.  Enhanced sensitivity in laser ablation-ICP mass spectrometry using helium-argon mixtures as aerosol carrier , 1999 .

[41]  B. Sharp,et al.  Characterisation and correction of instrumental bias in inductively coupled plasma quadrupole mass spectrometry for accurate measurement of lead isotope ratios , 1997 .

[42]  Gerard Mourou,et al.  Chirped pulse amplification of 300 fs pulses in an alexandrite regenerative amplifier , 1989 .

[43]  K. Wonigeit.  Analytik der Cyclosporin A-Bestimmung , 1988 .

[44]  A. L. Gray.  Solid sample introduction by laser ablation for inductively coupled plasma source mass spectrometry , 1985 .