EVALUATION OF HEAT TRANSFER AND THERMAL STABILITY OF SUPERCRITICAL JP-7 FUEL

A series of electrically heated tube experiments was conducted to investigate the potential of JP-7 as a coolant under conditions relevant to a Mach 8 propulsion system. The heat transfer capabilities, carbon deposition, and material compatibility of JP-7 at surface temperatures up to 1700 °F (927 °C) were tested in 0.125 in. diameter tubes of 304 SS, Inconel 617, Haynes 188, Haynes 230, and 50/50 Moly-Rhenium. The heat transfer to the coolant was modeled well by a Dittus-Boelter correlation at lower heat fluxes. At higher heat fluxes, audible instabilities were observed and corresponded to a significant enhancement in the coolant heat transfer. The carbon deposition rates in these tests were comparable to those in previous experiments at lower heat fluxes and much longer residence times. This result suggests that alternative paths of the deposition mechanism may be enhanced under high heat flux test conditions. Microscopic investigation of the post test tubes indicated that there was a significant layer of ordered carbon deposits that had not been seen in the tests at lower heat flux.

[1]  Sanders D. Rosenberg,et al.  Compatibility of hydrocarbon fuels with booster engine combustion chamber liners , 1991 .

[2]  Tim Edwards,et al.  USAF supercritical hydrocarbon fuels interests , 1993 .

[3]  Gilbert F. Froment,et al.  Influence of Metal Surface and Sulfur Addition on Coke Deposition in the Thermal Cracking of Hydrocarbons , 1995 .

[4]  R. W. Graham,et al.  Experimental heat-transfer results for cryogenic hydrogen flowing in tubes at subcritical and supercritical pressures to 800 pounds per square inch absolute , 1966 .

[5]  R. Hendricks.  Correlation of Hydrogen Heat Transfer in Boiling and Supercritical Pressure States , 1962 .

[6]  W. S. Hines,et al.  Pressure Oscillations Associated With Heat Transfer to Hydrocarbon Fluids at Supercritical Pressures and Temperatures , 1962 .

[7]  M. Meyer.  Electrically heated tube investigation of cooling channel geometry effects , 1995 .

[8]  William H. Heiser,et al.  Hypersonic Airbreathing Propulsion , 1994 .

[9]  Status and applications of materials developed for NASP , 1995 .

[10]  Nature of high temperature deposits from n-alkanes in flow reactor tubes , 1996 .

[11]  Robert J. Moffat,et al.  EXPERIMENTAL HEAT TRANSFER , 1990 .

[12]  Michael L. Meyer,et al.  A Heated Tube Facility for Rocket Coolant Channel Research , 1995 .

[13]  E. J. Szetela,et al.  Deposit formation and heat-transfer characteristics of hydrocarbon rocket fuels , 1985 .

[14]  Frank P. Incropera,et al.  Fundamentals of Heat and Mass Transfer , 1981 .

[15]  F. Incropera,et al.  Fundamentals of heat and mass transfer, 2nd edition , 1990 .

[16]  Tim Edwards,et al.  Thermal Stability of High Temperature Fuels , 1997 .

[17]  E. N. Sieder,et al.  Heat Transfer and Pressure Drop of Liquids in Tubes , 1936 .

[18]  H. T. Henderson,et al.  Heat sink capability of jet A fuel - Heat transfer and coking studies , 1971 .

[19]  Robb W. Newman.  Oxidation-resistant high-temperature materials , 1993 .