Modified dip-coating method for preparation of pinhole-free ceramic membranes

Abstract Pinhole defects can lead to an unacceptable deterioration and sometimes loss of the usual separation ability of ceramic membranes. A modified dip-coating method was proposed in an attempt to avoid pinhole defects in ceramic membranes. This was realized by applying a tangential flow of suspension against the support during the step of support dipping in a dip-coating process, in order to achieve a dynamic particle deposition. The idea was to obtain a uniform and pinhole-free particle layer by the interaction of capillary-filtration and suspension tangential flow. One α-Al 2 O 3 membrane with an average pore size of 0.6 μm was prepared by the modified dip-coating method. It was demonstrated that pinholes could be effectively avoided by applying a suspension flow velocity of 50 mm s −1 and a withdrawal speed of 4 mm s −1 via a single coating-sintering procedure. The largest pore size of the as-prepared membrane could be reduced to 0.76 μm, which is very close to the average pore size of the membrane, while the pure water flux of the membrane remained as high as 8.0 m 3  h −1  m −2  bar −1 .

[1]  Olav Bolland,et al.  High-temperature membranes in power generation with CO2 capture , 2004 .

[2]  H. Mori,et al.  Process conditions on the preparation of supported microporous SiO2 membranes by sol-gel modification techniques , 1997 .

[3]  Toshinori Tsuru,et al.  INORGANIC POROUS MEMBRANES FOR LIQUID PHASE SEPARATION , 2001 .

[4]  Jerry Y. S. Lin,et al.  Sol–gel synthesis and properties of unsupported and supported mesoporous ceria membranes , 2005 .

[5]  N. Xu,et al.  A new route for the fabrication of TiO2 ultrafiltration membranes with suspension derived from a wet chemical synthesis , 2006 .

[6]  B. Kellett,et al.  Thermodynamics of Densification: I, Sintering of Simple Particle Arrays, Equilibrium Configurations, Pore Stability, and Shrinkage , 1989 .

[7]  N. Nishiyama,et al.  Zirconium-containing mesoporous silica Zr-MCM-48 for alkali resistant filtration membranes , 2003 .

[8]  A. Burggraaf,et al.  Synthesis of ceramic membranes , 1992 .

[9]  Muhammad H. Al-Malack,et al.  Formation of dynamic membranes with crossflow microfiltration , 1996 .

[10]  L. Cot,et al.  Fundamentals of inorganic membrane science and technology , 1996 .

[11]  F. B. Hodgdon.  A PORCELAIN AT CONE 31 , 1929 .

[12]  G. B. Tanny,et al.  Dynamic Membranes in Ultrafiltration and Reverse Osmosis , 1978 .

[13]  G. Sakellaropoulos,et al.  Defects in microporous silica membranes: Analysis and repair , 2010 .

[14]  Kang Li.  Ceramic Membranes for Separation and Reaction , 2007 .

[15]  B. Chiang,et al.  Formation and characteristics of zirconium ultrafiltration dynamic membranes of various pore sizes , 1998 .

[16]  H. Verweij,et al.  Permeation porometry: Effect of probe diffusion in the condensate , 2008 .

[17]  A. J. Burggraaf,et al.  Formation and characterization of supported microporous ceramic membranes prepared by sol-gel modification techniques , 1995 .

[18]  N. Xu,et al.  Pore evolution model of ceramic membrane during constrained sintering , 2009, Journal of Materials Science.

[19]  R. J. Kriek,et al.  Direct synthesis of a titania membrane on a centrifugally casted tubular ceramic support , 2006 .

[20]  Dominique Hittner,et al.  Structural and mechanical characterizations of microporous silica-boron membranes for gas separation , 2009 .

[21]  J. D. Costa,et al.  Carbonised template molecular sieve silica membranes in fuel processing systems: permeation, hydrostability and regeneration , 2004 .

[22]  D. Korelskiy,et al.  Permporometry analysis of zeolite membranes , 2009 .

[23]  A. J. Burggraaf,et al.  The preparation and characterization of alumina membranes with ultrafine pores: 2. The formation of supported membranes , 1985 .

[24]  Yuehe Lin,et al.  MICROPOROUS INORGANIC MEMBRANES , 2000 .

[25]  Michel Y. Jaffrin,et al.  Dynamic shear-enhanced membrane filtration: A review of rotating disks, rotating membranes and vibrating systems , 2008 .

[26]  William J. Koros,et al.  Ceramic membrane characterization via the bubble point technique , 1997 .