Optical method for the determination of the oxygen-transfer capacity of small bioreactors based on sulfite oxidation.

The growth of microorganisms may be limited by operating conditions which provide an inadequate supply of oxygen. To determine the oxygen-transfer capacities of small-scale bioreactors such as shaking flasks, test tubes, and microtiter plates, a noninvasive easy-to-use optical method based on sulfite oxidation has been developed. The model system of sodium sulfite was first optimized in shaking-flask experiments for this special application. The reaction conditions (pH, buffer, and catalyst concentration) were adjusted to obtain a constant oxygen transfer rate for the whole period of the sulfite oxidation reaction. The sharp decrease of the pH at the end of the oxidation, which is typical for this reaction, is visualized by adding a pH dye and used to measure the length of the reaction period. The oxygen-transfer capacity can then be calculated by the oxygen consumed during the complete stoichiometric transformation of sodium sulfite and the visually determined reaction time. The suitability of this optical measuring method for the determination of oxygen-transfer capacities in small-scale bioreactors was confirmed with an independent physical method applying an oxygen electrode. The correlation factor for the maximum oxygen-transfer capacity between the chemical model system and a culture of Pseudomonas putida CA-3 was determined in shaking flasks. The newly developed optical measuring method was finally used for the determination of oxygen-transfer capacities of different types of transparent small-scale bioreactors.

[1]  E. G. Bailey,et al.  Effect of shaking speed and type of closure on shake flask cultures. , 1969, Applied microbiology.

[2]  A. Schumpe,et al.  Estimation of gas solubilities in salt solutions at temperatures from 273 K to 363 K , 1996 .

[3]  Jaroslav Hospodka,et al.  Oxygen‐absorption rate‐controlled feeding of substrate into aerobic microbial cultures , 1966 .

[4]  K. Akita.  Diffusivities of gases in aqueous electrolyte solutions , 1981 .

[5]  W. J. Beek,et al.  The oxidation of aqueous sodium sulphite solutions , 1973 .

[6]  V. Linek,et al.  A generalization of kinetic data on sulphite oxidation systems , 1971 .

[7]  J. Büchs,et al.  Device for sterile online measurement of the oxygen transfer rate in shaking flasks. , 2001, Biochemical engineering journal.

[8]  Robert Hermann,et al.  Methods for Intense Aeration, Growth, Storage, and Replication of Bacterial Strains in Microtiter Plates , 2000, Applied and Environmental Microbiology.

[9]  Gabriel Wild,et al.  A review of recent chemical techniques for the determination of the volumetric mass-transfer coefficient KLa in gas-liquid reactors , 1994 .

[10]  R. H. Crist,et al.  The Rate of Oxidation of Sulfite Ions by Oxygen , 1941 .

[11]  C. Wilke,et al.  Simultaneous measurement of interfacial area and mass transfer coefficients for a well—mixed gas dispersion in aqueous electrolyte solutions , 1974 .

[12]  V. Linek,et al.  Chemical Engineering Use of Catalyzed Sulfite Oxidation Kinetics for the Determination of Mass Transfer Characteristics of Gas-Liquid Contactors , 1981 .

[13]  S. A. Miller,et al.  Performance of Agitated Gas-Liquid Contactors , 1944 .

[14]  Raymond C. Whittemore,et al.  Behavior of gas bubbles in aqueous electrolyte solutions , 1971 .

[15]  V. Linek.  Bestimmung der Phasen-Grenzfläche in einem mit mechanischem Rührwerk versehenen Reaktor bei Gasdurchgang , 1966 .

[16]  R. Wilhelm,et al.  Oxygen Transfer and Agitation in Submerged Fermentations. Mass Transfer of Oxygen in Submerged Fermentation of Streptomyces griseus , 1950 .

[17]  A. Beenackers,et al.  ENHANCEMENT OF GAS TO WATER MASS-TRANSFER RATES BY A DISPERSED ORGANIC-PHASE , 1995 .

[18]  H. J. Henzler,et al.  Suitability of the shaking flask for oxygen supply to microbiological cultures , 1991 .

[19]  A. Schumpe,et al.  The estimation of gas solubilities in salt solutions , 1993 .

[20]  L. Ju,et al.  Effects of microorganisms on effective oxygen diffusion coefficients and solubilities in fermentation media , 1988, Biotechnology and bioengineering.

[21]  J. Bourne,et al.  Practical guidelines for the determination of oxygen transfer coefficients (KLa) with the sulfite oxidation method , 1985 .

[22]  V. Linek,et al.  The influence of diffusivity on liquid phase mass transfer in solutions of electrolytes , 1970 .