A study on the optimal monolith combination for improving flow uniformity and warm-up performance of an auto-catalyst

The optimal design of an auto-catalyst needs a good compromise between the pressure drop and flow uniformity in the monolith. One of the effective methods to achieve this goal is to use the concept of a radially variable cell density. But this method has not been examined with respect to its usefulness in terms of chemical behavior and light-off performance. In this study, a multi-dimensional performance prediction of catalyst coupled with a turbulent reacting flow simulation has been used to evaluate the benefits of this method from the simultaneous viewpoint of fluid dynamics and chemical response during warm-up. The results showed that the combined monolith with 93/73 and 93/62 was very prospective for improved light-off performance and reduced the pressure loss due to both the balanced space velocity and the efficient usage of the geometric surface area of the channels. It was also found that the air distribution between the different cell densities greatly affects not only pressure loss and flow uniformity but also the light-off pattern. In this study, thermal durability was also examined by using simple correlation governed by mechanical and thermal properties. It was found that based on the thermal shock parameter, the cell combined monolith shows weaker thermal resistance than the conventional monolith.

[1]  Paul Victor Keller.  Modeling and simulation of monolith reactors , 1991 .

[2]  Suresh T. Gulati,et al.  Performance Parameters for Advanced Ceramic Catalyst Supports , 1999 .

[3]  Scott C. Williams,et al.  Modeling current generation catalytic converters: laboratory experiments and kinetic parameter optimization. Steady state kinetics , 1992 .

[4]  G. Koltsakis.  Warm-up behavior of monolithic reactors under non-reacting conditions , 1997 .

[5]  Michel Prigent,et al.  Three-way catalytic converter modelling: fast- and slow-oxidizing hydrocarbons, inhibiting species, and steam-reforming reaction , 1998 .

[6]  S.-J. Jeong,et al.  A three-dimensional numerical study of the effect of pulsating flow on conversion efficiency inside a catalytic converter , 2001 .

[7]  W. Moore,et al.  Evaluation of High Cell Density Substrates for Advanced Catalytic Converter Emissions Control , 1999 .

[8]  S. E. Voltz,et al.  Kinetic Study of Carbon Monoxide and Propylene Oxidation on Platinum Catalysts , 1973 .

[9]  Daniel Schweich,et al.  Three-way monolithic converter: Simulations versus experiments , 1996 .

[10]  S. Orszag,et al.  Renormalization group analysis of turbulence. I. Basic theory , 1986 .

[11]  Arvind Varma,et al.  Reaction kinetics on a commercial three-way catalyst: the carbon monoxide-nitrogen monoxide-oxygen-water system , 1985 .

[12]  Woo-Seung Kim,et al.  Three-Dimensional Numerical Study on the Use of Warm-up Catalyst to Improve Light-Off Performance , 2000 .

[13]  James C. Cavendish,et al.  Transients of monolithic catalytic converters. Response to step changes in feedstream temperature as related to controlling automobile emissions , 1982 .

[14]  Gerhart Eigenberger,et al.  On the dynamic behavior of automotive catalysts , 1997 .

[15]  S. Orszag,et al.  Renormalization group analysis of turbulence. I. Basic theory , 1986, Physical review letters.

[16]  Kyriacos Zygourakis,et al.  Transient operation of monolith catalytic converters: a two-dimensional reactor model and the effects of radially nonuniform flow distributions , 1989 .

[17]  C. Rhie,et al.  Numerical Study of the Turbulent Flow Past an Airfoil with Trailing Edge Separation , 1983 .

[18]  Frank Terres,et al.  Experimental and Predictive Investigation of a Close Coupled Catalytic Converter with Pulsating Flow , 1996 .

[19]  S-J Jeong,et al.  A new strategy for improving the warm-up performance of a light-off auto-catalyst for reducing cold-start emissions , 2001 .

[20]  B. Andersson,et al.  Mass transfer in monolith catalysts–CO oxidation experiments and simulations , 1998 .

[21]  Jeong Y. Kim,et al.  Improving Flow Efficiency of a Catalytic Converter Using the Concept of Radially Variable Cell Density - Part I , 1999 .