论文信息 - Modeling power amplifiers with antenna mismatch

Modeling power amplifiers with antenna mismatch

The paper presents an approach for behavioral level power amplifier modeling with antenna mismatch. The derived model is based on device large signal S-parameter measurements of a commercially available W-CDMA power amplifier. The measurement setup is described in detail and the model validity is verified by comparing measured and simulated adjacent channel power ratios (ACPR). The measured and simulated ACPR show very good agreement and match at the nominal drive level to within 2 dB over the maximum output VSWR ratings.

[1] Thomas R. Turlington,et al. Behavioral Modeling of Nonlinear RF and Microwave Devices , 1999 .

[2] Akhileshwar Kumar. Fixed and mobile terminal antennas , 1991 .

[3] Steve C. Cripps,et al. Advanced Techniques in RF Power Amplifier Design , 2002 .

[4] Torben Larsen,et al. RF Receiver Requirements for 3G W-CDMA Mobile Equipment , 2000 .

[5] Jan H. Mikkelsen,et al. Power Amplifier Modeling for Varying Envelope Modulation , 2004 .

[6] Jesper Ødum Nielsen,et al. Radiation pattern measurements of mobile phones next to different head phantoms , 2002, The 13th IEEE International Symposium on Personal, Indoor and Mobile Radio Communications.

[7] Peter B. Kenington,et al. High-Linearity RF Amplifier Design , 2000 .