Detection of impact damage in CFRP laminates by means of electrical potential techniques

Quasi-isotropic samples of carbon fibre reinforced polymer composite 2 mm thick were manufactured and instrumented with an array of electrodes. The electrodes were used to introduce a DC current and to measure the resultant potential distribution on the top and bottom surfaces of the laminate. Instrumented samples were impacted at energies between 2 and 12 J, and the potential fields measured before and after the impact. The impact damage caused significant changes in local values of potential. Indications of the extent and severity of the impact damage could be best obtained by representing the data as contours of equi-potential change. There was excellent correlation between regions of potential change and impact damage as measured by ultrasonic C scan. The results of finite element calculations of potential change distribution on the surface of current carrying quasi-isotropic laminates containing delaminations of a range of sizes and locations were qualitatively similar to those obtained experimentally, but differed in detail. Results are discussed in terms of the differences between real impact damage and that which was simulated, and the likely performance of a damage detection system based on this principle.

[1]  Ning Liu,et al.  Impact Damage Detection in Carbon Fibre Composites Using Neural Networks an Acoustic Emission , 1999 .

[2]  Karl Schulte,et al.  Non-destructive testing of FRP by d.c. and a.c. electrical methods , 2001 .

[3]  N. Khemiri,et al.  Damage detection in CFRP laminates using electrical potential techniques , 2003, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[4]  Shiv P. Joshi,et al.  Damage detection in CFRP by electrical conductivity mapping , 2001 .

[5]  Akira Todoroki,et al.  Delamination identification of cross-ply graphite/epoxy composite beams using electric resistance change method , 2002 .

[6]  Karl Schulte,et al.  Load and failure analyses of CFRP laminates by means of electrical resistivity measurements , 1989 .

[7]  Phil E. Irving,et al.  Experimental and finite element study of the electrical potential technique for damage detection in CFRP laminates , 2005 .

[8]  Serge Abrate,et al.  Impact on Composite Structures , 1998 .

[9]  Akira Todoroki,et al.  Electrical resistance change method for monitoring delaminations of CFRP laminates: effect of spacing between electrodes , 2005 .

[10]  Hideo Kobayashi,et al.  Application of Electric Potential Method to Smart Composite Structures for Detecting Delamination , 1995 .

[11]  Phil E. Irving,et al.  The electrical resistance response of continuous carbon fibre composite laminates to mechanical strain , 2004 .

[12]  Phil E. Irving,et al.  Fatigue damage characterization in carbon fibre composite materials using an electrical potential technique , 1998 .

[13]  Damodar R. Ambur,et al.  AN ARTIFICIAL NEURAL NETWORK BASED DAMAGE DETECTION SCHEME FOR ELECTRICALLY CONDUCTIVE COMPOSITE STRUCTURES , 2003 .