A mode-matching 130-kHz ring-coupled gyroscope with 225 ppm initial driving/sensing mode frequency splitting

A degenerate mode 130-kHz ring-coupled gyroscope with auxiliary transducer array is designed to enhance the sensitivity as well as the mode-matching feature. The proof-of-concept device with 3 μm transducer's gap is fabricated using a conventional (100) silicon-on-insulator (SOI) wafer process with only two lithography steps. The auxiliary parallel-plate transducer array is located at the maximum displacement of the vibrating ring to enhance the electromechanical coupling while reducing the sensing noise. The in-plane trefoil mode (n=3) is adopted to alleviate the initial frequency splitting in (100) crystalline silicon device layer. The average frequency split for the drive/sense modes over multiple tested devices is only 225 ppm with the mean resonance frequency of 130 kHz. The measured Q-factor is 50 in atmospheric pressure and up to 10,000 in vacuum. Owing to the larger transduction area benefitting from the transducer array design, a low dc-bias voltage (VP) of 3 V in vacuum (21 V in air) is sufficient to sustain the driving loop oscillation. As integrated with the sensing circuits to operate the proposed gyroscope, a scale factor of 2.2 mV/°/s and resolution of 0.26 °/s, respectively, are characterized in atmospheric pressure.

[1]  K. Najafi,et al.  A HARPSS polysilicon vibrating ring gyroscope , 2001 .

[2]  Sang Won Yoon,et al.  Vibration sensitivity analysis of MEMS vibratory ring gyroscopes , 2011 .

[3]  Farrokh Ayazi,et al.  A 3MHz spoke gyroscope with wide bandwidth and large dynamic range , 2010, 2010 IEEE 23rd International Conference on Micro Electro Mechanical Systems (MEMS).

[4]  Chan-Shin Chou,et al.  In-plane free vibration of a single-crystal silicon ring , 2008 .

[5]  Geometric compensation of (100) single crystal silicon disk resonating gyroscope for mode-matching , 2013, 2013 Transducers & Eurosensors XXVII: The 17th International Conference on Solid-State Sensors, Actuators and Microsystems (TRANSDUCERS & EUROSENSORS XXVII).

[6]  T. W. Kenny,et al.  100K Q-factor toroidal ring gyroscope implemented in wafer-level epitaxial silicon encapsulation process , 2014, 2014 IEEE 27th International Conference on Micro Electro Mechanical Systems (MEMS).

[7]  Guohong He,et al.  A single-crystal silicon vibrating ring gyroscope , 2002, Technical Digest. MEMS 2002 IEEE International Conference. Fifteenth IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.02CH37266).