Employing Hot Wire Anemometry to Directly Measure the Water Balance of a Commercial Proton Exchange Membrane Fuel Cell Stack

[1]  T. Berning,et al.  Applying hot wire anemometry to directly measure the water balance in a proton exchange membrane fuel cell – Part 1: Theory , 2015 .

[2]  Saher Al Shakhshir,et al.  Employing Hot Wire Anemometry to Directly Measure the Water Balance of a Proton Exchange Membrane Fuel Cell , 2015 .

[3]  T. Berning.  A method for the ad hoc and real-time determination of the water balance in a PEMFC , 2014 .

[4]  Longhua Ma,et al.  Online Soft Sensor of Humidity in PEM Fuel Cell Based on Dynamic Partial Least Squares , 2013, TheScientificWorldJournal.

[5]  Xianguo Li,et al.  Impact of One Side Hydrophobic Gas Diffusion Layer on Water Removal Rate and Proton Exchange Membrane Fuel Cell Performance , 2012 .

[6]  S. Kær,et al.  Water balance simulations of a polymer-electrolyte membrane fuel cell using a two-fluid model , 2011 .

[7]  T. Berning.  On water transport in polymer electrolyte membranes during the passage of current , 2011 .

[8]  G.J.M. Janssen,et al.  Water transport in the proton-exchange-membrane fuel cell: measurements of the effective drag coefficient , 2001 .

[9]  Felix N. Büchi,et al.  Operating Proton Exchange Membrane Fuel Cells Without External Humidification of the Reactant Gases Fundamental Aspects , 1997 .

[10]  H. H. Bruun,et al.  Hot-Wire Anemometry: Principles and Signal Analysis , 1996 .

[11]  T. Abe,et al.  Study of PEFCs by AC Impedance, Current Interrupt, and Dew Point Measurements I. Effect of Humidity in Oxygen Gas , 2004 .