Heat Transport Capability in an Oscillating Heat Pipe

A mathematical model predicting the oscillating motion in an oscillating heat pipe is developed. The model considers the vapor bubble as the gas spring for the oscillating motions including effects of operating temperature, nonlinear vapor bulk modulus, and temperature difference between the evaporator and the condenser. Combining the oscillating motion predicted by the model, a mathematical model predicting the temperature difference between the evaporator and the condenser is developed including the effects of the forced convection heat transfer due to the oscillating motion, the confined evaporating heat transfer in the evaporating section, and the thin film condensation in the condensing section. In order to verify the mathematical model, an experimental investigation was conducted on a copper oscillating heat pipe with eight turns. Experimental results indicate that there exists an onset power input for the excitation of oscillating motions in an oscillating heat pipe, i.e., when the input power or the temperature difference from the evaporating section to the condensing section was higher than this onset value the oscillating motion started, resulting in an enhancement of the heat transfer in the oscillating heat pipe. Results of the combined theoretical and experimental investigation will assist in optimizing the heat transfer performance and provide a better understanding of heat transfer mechanisms occurring in the oscillating heat pipe.

[1]  Hongbin Ma,et al.  Experimental Investigation of Oscillating Motions in a Flat Plate Pulsating Heat Pipe , 2007 .

[2]  Amir Faghri,et al.  Oscillatory Flow in Pulsating Heat Pipes with Arbitrary Numbers of Turns , 2002 .

[3]  J. C. Chen.  Correlation for Boiling Heat Transfer to Saturated Fluids in Convective Flow , 1966 .

[4]  Qingsong Yu,et al.  An Experimental Investigation of Heat Transport Capability in a Nanofluid Oscillating Heat Pipe , 2006 .

[5]  M. T. North,et al.  High heat flux heat pipe mechanism for cooling of electronics , 2001 .

[6]  C. Chen,et al.  An investigation of oscillating motions in a miniature pulsating heat pipe , 2006 .

[7]  Hongbin Ma,et al.  Nanofluid Effect on the Heat Transport Capability in a Well-Balanced Oscillating Heat Pipe , 2007 .

[8]  G. Wallis.  One Dimensional Two-Phase Flow , 1969 .

[9]  U. Kurzweg,et al.  Enhanced Heat Conduction in Fluids Subjected to Sinusoidal Oscillations , 1985 .

[10]  Chang-JinCJ Kim,et al.  Valveless pumping using traversing vapor bubbles in microchannels , 1998 .

[11]  U. Kurzweg,et al.  Heat transfer by high‐frequency oscillations: A new hydrodynamic technique for achieving large effective thermal conductivities , 1984 .

[12]  Amir Faghri,et al.  Heat transfer in a pulsating heat pipe with open end , 2002 .

[13]  Lanchao Lin,et al.  Experimental Investigation of Oscillating Heat Pipes , 2001 .

[14]  Manfred Groll,et al.  An insight into thermo-hydrodynamic coupling in closed loop pulsating heat pipes , 2004 .

[15]  Andrea Prosperetti,et al.  Growth and collapse of a vapor bubble in a small tube , 1999 .

[16]  Hongbin Ma,et al.  Theoretical analysis of startup of a pulsating heat pipe , 2007 .

[17]  X. M. Zhang,et al.  EXPERIMENTAL STUDY OF A PULSATING HEAT PIPE USING FC-72, ETHANOL, AND WATER AS WORKING FLUIDS , 2004 .