A multi-material 3D printing approach for conformal microwave antennas

In this paper a new approach for implementing conformal antennas using direct digital manufacturing is presented. The new approach is based on fused deposition printing of a 150 micron-thick thermoplastic layer on top of Kapton tape forming a smooth, thin and flexible substrate. The antenna metallization is then printed on the smooth face of the flexible substrate using micro-dispensing, and the substrate is subsequently adhered to a 3D form. This approach represents a simple and versatile method for building microwave components as 3D structures. A 6 GHz 3D dipole is presented as an example to validate the fabrication approach. An acrylonitrile butadiene styrene (ABS) substrate (relative permittivity of 2.7 and a loss tangent of 0.008) and Dupont CB028 silver paste are used to fabricate the dipole antenna.

[1]  Lluis Pradell,et al.  CPW balun for printed balanced antennas , 2014 .

[2]  Constantine A. Balanis,et al.  Flexible bow-tie antennas with reduced metallization , 2011, 2011 IEEE Radio and Wireless Symposium.

[3]  Ruimin Xu,et al.  Compact parylene-c-coated flexible antenna for WLAN and upper-band UWB applications , 2014 .

[4]  Kamal Sarabandi,et al.  Flexible Antenna Integrated With an Epitaxial Lift-Off Solar Cell Array for Flapping-Wing Robots , 2014, IEEE Transactions on Antennas and Propagation.

[5]  Qun Wu,et al.  Investigation on the radiation features of the flexible antenna at 5.8GHz , 2014, Proceedings of 2014 3rd Asia-Pacific Conference on Antennas and Propagation.

[6]  Thomas Ketterl,et al.  3D multi-layer additive manufacturing of a 2.45 GHz RF front end , 2015, 2015 IEEE MTT-S International Microwave Symposium.

[7]  Fukuro Koshiji,et al.  A flexible broadband antenna with fan-shaped and trapezoidal elements formed on printed circuit board for ultra-wideband radio , 2014, 2014 International Conference on Electronics Packaging (ICEP).

[8]  Jim Euchner.  Design , 2014, Catalysis from A to Z.

[9]  C. Balanis,et al.  Design, Simulation, Fabrication and Testing of Flexible Bow-Tie Antennas , 2011, IEEE Transactions on Antennas and Propagation.

[10]  T. Weller,et al.  Simultaneous RF electrical conductivity and topography mapping of smooth and rough conductive traces using microwave microscopy to identify localized variations , 2015, 2015 IEEE 16th Annual Wireless and Microwave Technology Conference (WAMICON).