Predictive Models for Flank Wear in Near Dry Machining
暂无分享,去创建一个
[1] S. Liang,et al. Modelling of the cutting temperature distribution under the tool flank wear effect , 2003 .
[2] Steven Y. Liang,et al. Modeling of CBN Tool Flank Wear Progression in Finish Hard Turning , 2004 .
[3] C. F. Jeff Wu,et al. Experiments: Planning, Analysis, and Parameter Design Optimization , 2000 .
[4] Patrick Judd,et al. Computational design of wear coatings , 1985 .
[5] Patrick Kwon,et al. Predictive models for flank wear on coated inserts , 2000 .
[6] M. C. Shaw,et al. Mechanics of Machining: An Analytical Approach to Assessing Machinability , 1989 .
[7] Álisson Rocha Machado,et al. The effect of extremely low lubricant volumes in machining , 1997 .
[8] E. Rabinowicz,et al. A study of abrasive wear under three-body conditions , 1961 .
[9] T. N. Loladze. Of the Theory of Diffusion Wear , 1981 .
[10] Mahmudur Rahman,et al. Experimental Evaluation on the Effect of Minimal Quantities of Lubricant in Milling , 2002 .
[11] Anselmo Eduardo Diniz,et al. Using a minimum quantity of lubricant (MQL) and a diamond coated tool in the drilling of aluminum–silicon alloys , 2002 .
[12] A. S. Varadarajan,et al. Investigations on hard turning with minimal cutting fluid application (HTMF) and its comparison with dry and wet turning , 2002 .
[13] Etsuo Marui,et al. Fundamental study on normal load dependency of friction characteristics in boundary lubrication , 1998 .
[14] P.L.B. Oxley,et al. Allowing for Nose Radius Effects in Predicting the Chip Flow Direction and Cutting Forces in Bar Turning , 1987 .
[15] E. Kannatey-Asibu. A Transport-Diffusion Equation in Metal Cutting and its Application to Analysis of the Rate of Flank Wear , 1985 .
[16] E. Trent. Chapter 5 – Heat in metal cutting , 2000 .