Analysis of toner-cartridge remanufacturer waste stream

Environmental concerns with the disposal of laser-printer toner cartridges are being addressed, in part, by the remanufacture of toner cartridges. Remanufacturing, or recycling at a part level, involves the disassembly, restoration to like-new condition and reassembly of a used product. Remanufacturing offers significant environmental benefits by reusing the energy and resources expended during original manufacture, and by diverting solid waste from landfill and incineration. Since the primary purpose of remanufacturing is to reuse parts, the parts that are not reused enter the remanufacturers' waste stream and may be studied to identify difficulties in remanufacture. The research undertaken aims to quantify the amount of product discarded (as opposed to reused) and to categorise reasons for discard in the toner-cartridge industry. From the discard reasons, it may be possible to identify product design factors that directly affect the remanufacturability of the product. This knowledge may be used to formulate design strategies to facilitate remanufacturing. The waste streams of three toner-cartridge remanufacturers were studied. Data gathered over a period of four months showed the main reasons for discard and highlighted areas in toner-cartridge design that are problematic for remanufacture.

[1]  Narendra J. Sheth,et al.  Statistical Design and Analysis of Engineering Experiments , 1973 .

[2]  K. Masui,et al.  An international comparison of product end-of-life scenarios and legislation for consumer electronics , 1998, Proceedings of the 1998 IEEE International Symposium on Electronics and the Environment. ISEE - 1998 (Cat. No.98CH36145).

[3]  M. Sherwood,et al.  Analysis of the waste stream of an original equipment remanufacturer : Towards the development of integrated life-cycle design guidelines , 2000 .

[4]  K. Masui,et al.  How product characteristics determine end-of-life strategies , 1998, Proceedings of the 1998 IEEE International Symposium on Electronics and the Environment. ISEE - 1998 (Cat. No.98CH36145).

[5]  Michael Costello,et al.  Remanufacturing: The Optimum Solution for Life Cycle Planning , 1997 .

[6]  T. J. Bartel.  Recycling program for printer toner cartridges and optical photoconductors , 1995, Proceedings of the 1995 IEEE International Symposium on Electronics and the Environment ISEE (Cat. No.95CH35718).

[7]  K. Mueller,et al.  The evolution of environmental initiatives for toner containers at Xerox Corporation , 1995, Proceedings of the 1995 IEEE International Symposium on Electronics and the Environment ISEE (Cat. No.95CH35718).

[8]  L. J. Turbini,et al.  Designing for technological obsolescence and discontinuous change: an evaluation of three successional electronic products , 1998, Proceedings of the 1998 IEEE International Symposium on Electronics and the Environment. ISEE - 1998 (Cat. No.98CH36145).

[9]  R. H. Myers,et al.  Probability and Statistics for Engineers and Scientists , 1978 .

[10]  L. H. Shu,et al.  Considering remanufacture and other end-of-life options in selection of fastening and joining methods , 1995, Proceedings of the 1995 IEEE International Symposium on Electronics and the Environment ISEE (Cat. No.95CH35718).