Sludge accumulation in polishing ponds treating anaerobically digested wastewater.

When ponds are used for wastewater treatment, settleable solids will form a steadily growing bottom sludge layer, which reduces their effective volume. Eventually this sludge must be removed to ensure that the pond maintains the required retention time to keep performing properly. The settleable solids may either be present in the influent or they are formed during the treatment as a result of algal flocculation. An experimental investigation was carried out to evaluate bottom sludge accumulation in a polishing pond used for treatment of UASB effluent. The mass and composition of the bottom sludge formed in a polishing pond was evaluated after the pilot scale pond had been in operation for 1 year and about 60 m3 of digested wastewater had been treated per m3 of pond. The bottom sludge mass represented a solids accumulation of 70 g per m3 of digested wastewater. About half of these solids were the result of settling of influent solids in the first part of the pond, while the other half was attributable to settling of algae, formed in the pond. It is concluded that the bottom sludge growth in a polishing pond is so low, that desludging during the useful life span of the pond will most likely not be necessary. This leads to the important conclusion that excess sludge discharge from UASB reactors (a major factor in operational costs) may be omitted, if a polishing pond is used for post-treatment. The bottom sludge had a high volatile solids concentration (58%) and the macronutrient fractions were also high (3.9% N and 1.1% P of the TSS mass). The bottom sludge was stable and could be dried directly without problems. The hygienic quality of the bottom sludge was very poor: about half the influent helminth eggs during one year of operation were found in the bottom sludge and the faecal coliform concentration was very high.