论文信息 - Solution for Voltage Distribution in Transformer Winding Model

Solution for Voltage Distribution in Transformer Winding Model

This paper uses multi-conductor transmission line (MTL) to model transformer winding. Firstly, distributed parameters should be computed. According to capacitance, inductance and resistance parameter, transmission line equation can be solved by input terminal impedance method. Thus, voltage distribution in transformer winding can be obtained by solving MTL equation. In this paper, only voltage distribution at single frequency excitation is calculated. Then, the calculating voltage distribution is compared with the experimental result. Because PD signal can be separated into superposition of cosine wave by fast Fourier transform (FFT), research on single frequency voltage distribution has important significance in solving voltage distribution of PD signal.

[1] Jiao Cui-ping. DISTORTION CAUSED BY PARTIAL DISCHARGE PROPAGATION ALONG POWER TRANSFORMER WINDING , 2002 .

[2] K. J. Cornick,et al. A Computer Model for Calculating Steep-Fronted Surge Distribution in Machine Windings , 1989, IEEE Power Engineering Review.

[3] Xu Zhong-rong. PROPAGATION CHARACTERISTICS OF PARTIAL DISCHARGE PULSES IN TRANSFORMER WINDINGS , 2002 .

[4] Akio Ushida,et al. Analysis of Multi-Conductor Transmission Lines Terminated by Nonlinear Subnetworks , 1993 .

[5] Cui Xiang,et al. Analysis of Resonance in Transformer Windings Under Very Fast Transient Overvoltages , 2006 .

[6] Li Ming-jia. Investigation of Very Fast Transient Over-voltage Distribution in Taper Winding , 2006 .

[7] Guishu Liang,et al. Modeling of Transformer Windings Under Very Fast Transient Overvoltages , 2006, IEEE Transactions on Electromagnetic Compatibility.