Road dust emission sources and assessment of street washing effect

Although previous studies report on the effect of street washing on ambient particulate matter levels, there is a lack of studies investigating the results of street washing on the emission strength of road dust. A sampling campaign was conducted in Madrid urban area during July 2009 where road dust samples were collected in two sites, namely Reference site (where the road surface was not washed) and Pelayo site (where street washing was performed daily during night). Following the chemical characterization of the road dust particles the emission sources were resolved by means of Positive Matrix Factorization, PMF (Multilinear Engine scripting) and the mass contribution of each source was calculated for the two sites. Mineral dust, brake wear, tire wear, carbonaceous emissions and construction dust were the main sources of road dust with mineral and construction dust being the major contributors to inhalable road dust load. To evaluate the effectiveness of street washing on the emission sources, the sources mass contributions between the two sites were compared. Although brake wear and tire wear had lower concentrations at the site where street washing was performed, these mass differences were not statistically significant and the temporal variation did not show the expected build-up after dust removal. It was concluded that the washing activities resulted merely in a road dust moistening, without effective removal and that mobilization of particles took place in a few hours between washing and sampling. The results also indicated that it is worth paying attention to the dust dispersed from the construction sites as they affect the emission strength in nearby streets. ©Taiwan Association for Aerosol Research.

[1]  Hugo Denier van der Gon,et al.  Effect of rain events on the mobility of road dust load in two Dutch and Spanish roads , 2012 .

[2]  Julio Lumbreras,et al.  Variation of PM2.5 concentrations in relation to street washing activities , 2012 .

[3]  X. Querol,et al.  Mineralogy and elemental composition ff brake pads of common use in Spain , 2012 .

[4]  X. Querol,et al.  Sources and variability of inhalable road dust particles in three European cities , 2011 .

[5]  Lin Peng,et al.  The Chemical Composition and Sources of PM10 in Urban Road Dust , 2011 .

[6]  Julio Lumbreras,et al.  Road dust contribution to PM levels - Evaluation of the effectiveness of street washing activities by means of Positive Matrix Factorization , 2011 .

[7]  Byeong-Kyu Lee,et al.  Toxicity and source assignment of polycyclic aromatic hydrocarbons in road dust from urban residential and industrial areas in a typical industrial city in Korea , 2011 .

[8]  C. Johansson,et al.  A review on the effectiveness of street sweeping, washing and dust suppressants as urban PM control methods. , 2010, Science of the Total Environment.

[9]  Teresa Moreno,et al.  Evaluating urban PM10 pollution benefit induced by street cleaning activities , 2009 .

[10]  P. Siskos,et al.  Assessment of source apportionment by Positive Matrix Factorization analysis on fine and coarse urban aerosol size fractions , 2009 .

[11]  Monica Pandolfi,et al.  Quantifying road dust resuspension in urban environment by Multilinear Engine: A comparison with PMF2 , 2009 .

[12]  Mar Viana,et al.  Spatial and chemical patterns of PM10 in road dust deposited in urban environment , 2009 .

[13]  Roy M Harrison,et al.  Sources and properties of non-exhaust particulate matter from road traffic: a review. , 2008, The Science of the total environment.

[14]  Shuiyuan Cheng,et al.  Characteristics of re-suspended road dust and its impact on the atmospheric environment in Beijing , 2007 .

[15]  Hirokazu Kimura,et al.  Particle size and composition distribution analysis of automotive brake abrasion dusts for the evaluation of antimony sources of airborne particulate matter , 2007 .

[16]  Luke Chen,et al.  Evaluation of street sweeping and washing to reduce ambient PM10 , 2007 .

[17]  Christer Johansson,et al.  Studies of some measures to reduce road dust emissions from paved roads in Scandinavia , 2006 .

[18]  P. Zhao,et al.  Characterizations of resuspended dust in six cities of North China , 2006 .

[19]  J. Schauer,et al.  Characterization of metals emitted from motor vehicles. , 2006, Research report.

[20]  K. Adachi,et al.  Characterization of heavy metal particles embedded in tire dust. , 2004, Environment international.

[21]  Judith C. Chow,et al.  Characterization of PM10 and PM2.5 source profiles for fugitive dust in Hong Kong , 2003 .

[22]  Åke Sjödin,et al.  Metal emissions from road traffic and the influence of resuspension: results from two tunnel studies , 2002 .

[23]  G. Weckwerth,et al.  Verification of traffic emitted aerosol components in the ambient air of Cologne (Germany) , 2001 .

[24]  J. Chow,et al.  Chemical composition of fugitive dust emitters in Mexico City , 2001 .

[25]  Xavier Querol,et al.  Monitoring of PM10 and PM2.5 around primary particulate anthropogenic emission sources , 2001 .

[26]  P. Paatero Least squares formulation of robust non-negative factor analysis , 1997 .

[27]  P. Paatero,et al.  Analysis of different modes of factor analysis as least squares fit problems , 1993 .

[28]  Glen R. Cass,et al.  SOURCES OF FINE ORGANIC AEROSOL. 3. ROAD DUST, TIRE DEBRIS, AND ORGANOMETALLIC BRAKE LINING DUST: ROADS AS SOURCES AND SINKS , 1993 .

[29]  J. Nriagu A silent epidemic of environmental metal poisoning? , 1988, Environmental pollution.