Fabrication of distributed electrostatic micro actuator (DEMA)

A distributed electrostatic micro actuator (DEMA) has been proposed. The actuator has many small driving units which consist of two wave-like insulated electrodes. Both ends of insulated electrodes are connected to each other, and the driving unit has narrow gap for deformation caused by electrostatic forces. The driving units have large area of electrodes and are distributed in series and in parallel. So, a strong electrostatic force can be obtained, and the deformation and the generated force of the actuator would be large. Macro model of the DEMA was fabricated with polyimide films, and the deformation of the actuator was measured. When the applied voltage was 200 V, the deformation ratio was 36%. A micro actuator was fabricated by use of photolithography and electroplating. The displacement of 28 mu m was observed when applied voltage was 160 V. Experimental results of the micro actuator were compared with the results simulated by finite element method (FEM) analysis. >

[1]  William C. Tang,et al.  Laterally Driven Polysilicon Resonant Microstructures , 1989 .

[2]  S. Goodwin-Johansson,et al.  Integrated force arrays , 1993, [1993] Proceedings IEEE Micro Electro Mechanical Systems.

[3]  Dale F. Ostergaard.  Adapting available finite element heat transfer programs to solve 2-D and 3-D electrostatic field problems , 1987 .

[4]  T. Niino,et al.  Development of an electrostatic actuator exceeding 10 N propulsive force , 1992, [1992] Proceedings IEEE Micro Electro Mechanical Systems.

[5]  Wolfgang Ehrfeld,et al.  Resist technology for deep‐etch synchrotron radiation lithography , 1989 .

[6]  K. J. Gabriel,et al.  Design considerations for a practical electrostatic micro-motor , 1987 .

[7]  J. H. Lang,et al.  Operation of microfabricated harmonic and ordinary side-drive motors , 1990, IEEE Proceedings on Micro Electro Mechanical Systems, An Investigation of Micro Structures, Sensors, Actuators, Machines and Robots..

[8]  Bumkyoo Choi,et al.  Deep X-ray and UV lithographies for micromechanics , 1990, IEEE 4th Technical Digest on Solid-State Sensor and Actuator Workshop.

[9]  William S. N. Trimmer,et al.  Microrobots and micromechanical systems , 1989 .

[10]  N. C. MacDonald,et al.  An isolation technology for joined tungsten MEMS , 1993, [1993] Proceedings IEEE Micro Electro Mechanical Systems.

[11]  Yu-Chong Tai,et al.  IC-processed electrostatic synchronous micromotors , 1989 .

[12]  T. Hirano,et al.  Operation of sub-micron gap electrostatic comb-drive actuators , 1991, TRANSDUCERS '91: 1991 International Conference on Solid-State Sensors and Actuators. Digest of Technical Papers.

[13]  Masayoshi Esashi,et al.  Distributed electrostatic micro actuator , 1993, [1993] Proceedings IEEE Micro Electro Mechanical Systems.

[14]  Masayoshi Esashi,et al.  Cryogenic dry etching for high aspect ratio microstructures , 1993, [1993] Proceedings IEEE Micro Electro Mechanical Systems.