An adaptable steady state Aspen Hysys model for the methane fuelled solid oxide fuel cell

Abstract An adaptable model for the methane fed internal reforming SOFC using the in built features of Aspen Hysys is presented in this paper. The model includes the electrochemistry, the diffusion phenomena and the reforming kinetics in detail. Three potential methods for representing the SOFC are investigated out of which the recycled reforming model is found to be capable of providing reasonable results over a wide range of operating conditions. The electrochemical model that gives good agreement with experimental data is also identified. From the simulations, it is concluded that the developed model is reasonably accurate over a wide operating range and can be used for steady state analysis. The computational challenges in the modelling are discussed. The model will be used for system level optimisation studies of the SOFC system especially in conjuncture with gas turbines and steam turbines.

[1]  Nobuyoshi Nakagawa,et al.  Catalytic activity of Ni–YSZ–CeO2 anode for the steam reforming of methane in a direct internal-reforming solid oxide fuel cell , 2001 .

[2]  Periasamy Vijay,et al.  A bond graph model-based evaluation of a control scheme to improve the dynamic performance of a solid oxide fuel cell , 2009 .

[3]  Alan S. Fung,et al.  Effects of operating and design parameters on the performance of a solid oxide fuel cell–gas turbine system , 2011 .

[4]  Fabian Mueller,et al.  Dynamic Simulation of an Integrated Solid Oxide Fuel Cell System Including Current-Based Fuel Flow Control , 2005 .

[5]  Hee Chun Lim,et al.  Carbon deposition and cell performance of Ni-YSZ anode support SOFC with methane fuel , 2002 .

[6]  Moses O. Tadé,et al.  Improved Tank in Series Model for the Planar Solid Oxide Fuel Cell , 2011 .

[7]  Ulrich Stimming,et al.  Optimization of a 200 kW SOFC cogeneration power plant. Part II: variation of the flowsheet , 1998 .

[8]  Yann Bultel,et al.  Modeling of a SOFC fuelled by methane: From direct internal reforming to gradual internal reforming , 2007 .

[9]  Dieter Froning,et al.  Clean combined-cycle SOFC power plant — cell modelling and process analysis , 2000 .

[10]  Vinod M. Janardhanan,et al.  Modeling Elementary Heterogeneous Chemistry and Electrochemistry in Solid-Oxide Fuel Cells , 2005 .

[11]  Paola Costamagna,et al.  Modeling of Solid Oxide Heat Exchanger Integrated Stacks and Simulation at High Fuel Utilization , 1998 .

[12]  J. Young,et al.  Thermodynamic and transport properties of gases for use in solid oxide fuel cell modelling , 2002 .

[13]  Lars Sjunnesson,et al.  Combined solid oxide fuel cell and gas turbine systems for efficient power and heat generation , 2000 .

[14]  Nigel P. Brandon,et al.  High performance cathode-supported SOFC with perovskite anode operating in weakly humidified hydrogen and methane , 2007 .

[15]  Biao Huang,et al.  Dynamic modeling of solid oxide fuel cell: The effect of diffusion and inherent impedance , 2005 .

[16]  M. Assadi,et al.  Modeling of Overpotentials in an Anode-Supported Planar SOFC Using a Detailed Simulation Model , 2011 .

[17]  C. Adjiman,et al.  Anode-supported intermediate temperature direct internal reforming solid oxide fuel cell. I: model-based steady-state performance , 2004 .

[18]  Effects of Pressurization on Cell Performance of a Microtubular SOFC with Sc-Doped Zirconia Electrolyte , 2008 .

[19]  S. Chan,et al.  Performance evaluation of anode-supported solid oxide fuel cells with thin film YSZ electrolyte , 2004 .

[20]  V. Belyaev,et al.  Internal steam reforming of methane over Ni-based electrode in solid oxide fuel cells , 1995 .

[21]  R. Reid,et al.  The Properties of Gases and Liquids , 1977 .

[22]  A. Reynolds,et al.  Simulation of a Tubular Solid Oxide Fuel Cell Stack Operating on Biomass Syngas Using Aspen Plus , 2010 .

[23]  Eric Croiset,et al.  Simulation of a tubular solid oxide fuel cell stack using AspenPlusTM unit operation models , 2004 .

[24]  K. Kendall,et al.  High temperature solid oxide fuel cells : fundamentals, design and applicatons , 2003 .