论文信息 - LOW-TEMPERATURE ANALOGUE BURNER FACE PLATE TIME RESPONSE

LOW-TEMPERATURE ANALOGUE BURNER FACE PLATE TIME RESPONSE

This paper presents the measurement of time response of the face plate from a low-temperature analogue burner. To avoid the need for a shutter system as used previously in the pilot low-temperature analogue burner, the burner faceplate has been designed to have a low thermal mass with a time response of less than one second. A thin film mylar face plate was used to replace the thick polycarbonate plate in the design of the compact lowtemperature analogue burner. This is to allow a step change of gas temperature of less than one second in the transient heat transfer testing. Calculation of the time response of different thickness of mylar, polycarbonate and PVC face plate materials were presented.

[1] Abu Talib,et al. Detailed investigation of the low-temperature analogy of an aircraft engine standard fire-test , 2003 .

[2] Peter T. Ireland,et al. A Novel Liquid Crystal Image Processing Technique Using Multiple Gas Temperature Steps to Determine Heat Transfer Coefficient Distribution and Adiabatic Wall Temperature , 2004 .

[3] Peter T. Ireland,et al. Compact Low-Temperature Analogue of Aero Engine Fire-Certification Burner , 2001 .

[4] T. V. Jones,et al. Detailed measurements of heat transfer on and around a pedestal in fully developed passage flow , 1986 .

[5] Terry V. Jones,et al. Liquid crystal measurements of heat transfer and surface shear stress , 2000 .

[6] A. Neely,et al. Pilot study to investigate novel experimental and theoretical fire-event modelling techniques , 1999 .

[7] Peter T. Ireland,et al. A Novel Transient Liquid Crystal Technique to Determine Heat Transfer Coefficient Distributions and Adiabatic Wall Temperature in a Three Temperature Problem , 2002 .

[8] Peter T. Ireland,et al. A Novel Transient Liquid Crystal Technique to Determine Heat Transfer Coefficient Distributions and Adiabatic Wall Temperature in a Three-Temperature Problem , 2003 .