Short-circuit ruggedness of high-voltage IGBTs

The IGBT can run into different short-circuit types (SC I, SC II, SC III). Especially in SC II and III, an interaction between the gate drive unit and the IGBT takes place. A self-turn-off mechanism after short-circuit turn on can occur. Parasitic elements in the connection between the IGBT and the gate unit as well as asymmetrical wiring of devices connected in parallel are of effect to the short-circuit capability. In high-voltage IGBTs, filament formation can occur at short-circuit condition. Destructive measurements with its failure patterns and short-circuit protection methods are shown.

[1]  T. Laska,et al.  A 2000 V non-punchthrough IGBT with high ruggedness , 1992 .

[2]  J. Sakano,et al.  A Planar-Gate High-Conductivity IGBT (HiGT) With Hole-Barrier Layer , 2007, IEEE Transactions on Electron Devices.

[3]  Dionyz Pogany,et al.  Improvement of the electrical safe operating area of a DMOS transistor during ESD events , 2009, 2009 IEEE International Reliability Physics Symposium.

[4]  R. Letor,et al.  Short circuit behaviour of IGBTs correlated to the intrinsic device structure and on the application circuit , 1992, Conference Record of the 1992 IEEE Industry Applications Society Annual Meeting.

[5]  Sameer Pendharkar,et al.  Zero voltage switching behavior of punchthrough and nonpunchthrough insulated gate bipolar transistors (IGBT's) , 1998 .

[6]  S. Ghandhi.  Semiconductor power devices , 1977 .

[7]  Josef Lutz,et al.  Short circuit III in high power IGBTs , 2009, 2009 13th European Conference on Power Electronics and Applications.

[8]  A. Benmansour,et al.  Failure mechanism of trench IGBT under short-circuit after turn-off , 2006, Microelectron. Reliab..

[9]  U. Schlapbach,et al.  Limitation of the short-circuit ruggedness of high-voltage IGBTs , 2009, 2009 21st International Symposium on Power Semiconductor Devices & IC's.

[10]  Hans-Gunter Eckel,et al.  Negative differential miller capacitance during switching transients of IGBTs , 2011, Proceedings of the 2011 14th European Conference on Power Electronics and Applications.

[11]  Salvatore Musumeci,et al.  Parallel strings of IGBTs in short circuit transients: analysis of the parameter influence and experimental behavior , 2002, IEEE 2002 28th Annual Conference of the Industrial Electronics Society. IECON 02.

[12]  Roland Jakob,et al.  The influence of asymmetries on the parallel connection of IGBT chips under short-circuit condition , 2011, Proceedings of the 2011 14th European Conference on Power Electronics and Applications.

[13]  Hans-Gunter Eckel,et al.  Optimization of the Short-Circuit Behaviour of NPT-IGBT by the Gate Drive , 1996 .

[14]  S. Lefebvre,et al.  Experimental behavior of single-chip IGBT and COOLMOS devices under repetitive short-circuit conditions , 2005, IEEE Transactions on Electron Devices.

[15]  Hans-Gunter Eckel,et al.  Experimental investigation on the behaviour of IGBT at short-circuit during the on-state , 1994, Proceedings of IECON'94 - 20th Annual Conference of IEEE Industrial Electronics.

[16]  J. Lutz,et al.  Semiconductor Power Devices: Physics, Characteristics, Reliability , 2011 .

[17]  T. Ohi,et al.  Investigation of gate voltage oscillations in an IGBT module under short circuit conditions , 2002, 2002 IEEE 33rd Annual IEEE Power Electronics Specialists Conference. Proceedings (Cat. No.02CH37289).

[18]  Wilfried Hofmann,et al.  Passive turn-on process of IGBTs in Matrix converter applications , 2009, 2009 13th European Conference on Power Electronics and Applications.