An Efficient Piezoelectric Energy Harvesting Interface Circuit Using a Bias-Flip Rectifier and Shared Inductor

Harvesting ambient vibration energy through piezoelectric means is a popular energy harvesting technique which can potentially supply 10-100's of ¿W of available power. One of the main limitations of existing piezoelectric harvesters is in their interface circuitry. In this paper, a bias-flip rectifier circuit that can improve the power extraction capability from piezoelectric harvesters over conventional full-bridge rectifiers and voltage doublers by greater than 4X is implemented in a 0.35 ¿m CMOS process. An efficient control circuit to regulate the output voltage of the rectifier and recharge a storage capacitor is presented. The inductor used within the bias-flip rectifier is shared efficiently with a multitude of switching DC-DC converters within the system reducing the overall component count.

[1]  A.P. Chandrakasan,et al.  Next generation micro-power systems , 2008, 2008 IEEE Symposium on VLSI Circuits.

[2]  Jan M. Rabaey,et al.  Energy Scavenging for Wireless Sensor Networks: with Special Focus on Vibrations , 2012 .

[3]  Heath Hofmann,et al.  Adaptive piezoelectric energy harvesting circuit for wireless remote power supply , 2002 .

[4]  Chao Lu,et al.  A Batteryless Vibration-based Energy Harvesting System for Ultra Low Power Ubiquitous Applications , 2007, 2007 IEEE International Symposium on Circuits and Systems.

[5]  D. Guyomar,et al.  Toward energy harvesting using active materials and conversion improvement by nonlinear processing , 2005, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[6]  Rajeevan Amirtharajah,et al.  A Full-Wave Rectifier for Interfacing with Multi-Phase Piezoelectric Energy Harvesters , 2008, 2008 IEEE International Solid-State Circuits Conference - Digest of Technical Papers.

[7]  Sang-Gook Kim,et al.  MEMS power generator with transverse mode thin film PZT , 2005 .

[8]  Yogesh K. Ramadass.  Energy processing circuits for low-power applications , 2009 .

[9]  Enrico Dallago,et al.  Active self supplied AC-DC converter for piezoelectric energy scavenging systems with supply independent bias , 2008, 2008 IEEE International Symposium on Circuits and Systems.

[10]  Anantha Chandrakasan,et al.  Minimum Energy Tracking Loop with Embedded DC-DC Converter Delivering Voltages down to 250mV in 65nm CMOS , 2007, 2007 IEEE International Solid-State Circuits Conference. Digest of Technical Papers.

[11]  A. von Jouanne,et al.  Piezoelectric micro-power generation interface circuits , 2006, IEEE Journal of Solid-State Circuits.

[12]  Jan M. Rabaey,et al.  An Ultra-Low-Power Power Management IC for Wireless Sensor Nodes , 2007, 2007 IEEE Custom Integrated Circuits Conference.

[13]  E. Dallago,et al.  Electronic interface for Piezoelectric Energy Scavenging System , 2008, ESSCIRC 2008 - 34th European Solid-State Circuits Conference.

[14]  Anantha Chandrakasan,et al.  An efficient piezoelectric energy-harvesting interface circuit using a bias-flip rectifier and shared inductor , 2009, 2009 IEEE International Solid-State Circuits Conference - Digest of Technical Papers.

[15]  E. Dallago,et al.  Integrable High-Efficiency AC-DC Converter for Piezoelectric Energy Scavenging System , 2007, 2007 IEEE International Conference on Portable Information Devices.

[16]  A.P. Chandrakasan,et al.  Minimum Energy Tracking Loop With Embedded DC–DC Converter Enabling Ultra-Low-Voltage Operation Down to 250 mV in 65 nm CMOS , 2008, IEEE Journal of Solid-State Circuits.

[17]  Mickaël Lallart,et al.  An optimized self-powered switching circuit for non-linear energy harvesting with low voltage output , 2008 .

[18]  C. Van Hoof,et al.  Piezoelectric Harvesters and MEMS Technology: Fabrication, Modeling and Measurements , 2007, TRANSDUCERS 2007 - 2007 International Solid-State Sensors, Actuators and Microsystems Conference.

[19]  Claude Richard,et al.  Enhanced semi-passive damping using continuous switching of a piezoelectric device on an inductor , 2000, Smart Structures.

[20]  Naveen Verma,et al.  Design considerations for ultra-low energy wireless microsensor nodes , 2005, IEEE Transactions on Computers.