Blob properties in full-turbulence simulations of the TCV scrape-off layer

To investigate blob properties in the tokamak scrape-off layer (SOL), we perform dedicated numerical nonlinear simulations of plasma turbulence in the SOL of a TCV discharge using the Global Braginskii Solver code. A blob detection technique is used for the first time in a three-dimensional (3D) full-turbulence simulation to track the motion of the filaments in the SOL. The specific size, density amplitude and radial velocity of the blobs are computed, with the typical values being 7.4 rho(s), 0.33 n(e) and 0.016 c(s), respectively. The analysis of blob structure in the parallel direction shows that the blobs are partially detached from the limiter. The cross correlation analysis shows how the blobs are born all along the entire field line, not being generated primarily on the low field side SOL and expanding towards the limiter. The blob radial velocity agrees well with the inertial branch of the existing scaling law. The radial particle and heat fluxes given by blobs are shown to be responsible of up to 100% and 70% of the turbulent particle and heat flux in the far SOL, respectively. The results of a second simulation with a 40 times higher resistivity are also discussed.

[1]  Jonas Gloeckner.  Lecture Notes On Principles Of Plasma Processing , 2016 .

[2]  Federico David Halpern,et al.  Boundary conditions for plasma fluid models at the magnetic presheath entrance , 2012 .

[3]  N. Walkden,et al.  Investigation of the effect of resistivity on scrape off layer filaments using three-dimensional simulations , 2015, 1508.04085.

[4]  Odd Erik Garcia,et al.  Fluctuation statistics in the scrape-off layer of Alcator C-Mod , 2014, 1410.4114.

[5]  D. A. D’Ippolito,et al.  Recent theoretical progress in understanding coherent structures in edge and SOL turbulence , 2008, Journal of Plasma Physics.

[6]  F. Halpern,et al.  Velocity shear, turbulent saturation, and steep plasma gradients in the scrape-off layer of inner-wall limited tokamaks , 2016, 1606.08564.

[7]  S. Zweben,et al.  Edge turbulence in different density regimes in Alcator C-Mod experiment , 2011 .

[8]  R. E. Bell,et al.  Edge and SOL turbulence and blob variations over a large database in NSTX , 2015 .

[9]  James Myra,et al.  Collisionality and magnetic geometry effects on tokamak edge turbulent transport. I. A two-region model with application to blobs , 2006 .

[10]  A. Y. Aydemir,et al.  Convective transport in the scrape-off layer of tokamaks , 2005 .

[11]  N. Nishino,et al.  Statistical features of coherent structures at increasing magnetic field pitch investigated using fast imaging in QUEST , 2012 .

[12]  F. Halpern,et al.  Turbulent regimes in the tokamak scrape-off layer , 2013 .

[13]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.

[14]  J. Madsen,et al.  Blob dynamics in the TORPEX experiment: a multi-code validation , 2016 .

[15]  V. Naulin,et al.  Three dimensional simulations of plasma filaments in the scrape off layer: A comparison with models of reduced dimensionality , 2014, 1410.2137.

[16]  A. Fasoli,et al.  Cross-field motion of plasma blobs in an open magnetic field line configuration. , 2009, Physical review letters.

[17]  F. Halpern,et al.  Finite ion temperature effects on scrape-off layer turbulence , 2015 .

[18]  Heat loads in inboard limited L-mode plasmas in TCV , 2015 .

[19]  Federico David Halpern,et al.  Simulation of plasma turbulence in scrape-off layer conditions: the GBS code, simulation results and code validation , 2012 .

[20]  Fabio Riva,et al.  Non-linear simulations of the TCV Scrape-Off Layer , 2017 .

[21]  Ambrogio Fasoli,et al.  Probabilistic analysis of turbulent structures from two-dimensional plasma imaging , 2006 .

[22]  D. D'Ippolito,et al.  Blob stability and transport in the scrape-off-layer , 2003 .

[23]  T. Carter,et al.  Intermittent turbulence and turbulent structures in a linear magnetized plasma , 2005, physics/0504209.

[24]  Christoph Wersal,et al.  A first-principles self-consistent model of plasma turbulence and kinetic neutral dynamics in the tokamak scrape-off layer , 2015 .

[25]  J. Contributors,et al.  Experimental Validation of a Filament Transport Model in Turbulent Magnetized Plasmas. , 2015, Physical review letters.

[26]  Fabio Riva,et al.  The GBS code for tokamak scrape-off layer simulations , 2016, J. Comput. Phys..

[27]  James Myra,et al.  Convective transport by intermittent blob-filaments: Comparison of theory and experiment , 2011 .

[28]  G. Tonetti,et al.  Tokamak equilibrium reconstruction using Faraday rotation measurements , 1988 .

[29]  N. Fedorczak,et al.  Plasma blob generation due to cooperative elliptic instability. , 2011, Physical review letters.

[30]  R. Mitteau,et al.  Impact of a narrow limiter SOL heat flux channel on the ITER first wall panel shaping , 2015 .

[31]  T. Klinger,et al.  Radial propagation of structures in drift wave turbulence , 2006 .

[32]  N. Walkden,et al.  Dynamics of 3D isolated thermal filaments , 2016, 1606.00582.

[33]  M. Porkolab,et al.  Experiments on the propagation of plasma filaments. , 2008, Physical review letters.

[34]  F. Pegoraro,et al.  Effects of the parallel electron dynamics and finite ion temperature on the plasma blob propagation in the scrape-off layer , 2008 .

[35]  O. E. Garcia,et al.  Experimental investigation of the parallel structure of fluctuations in the scrape-off layer of Alcator C-Mod , 2014 .

[36]  U. Stroth,et al.  Filament velocity scaling laws for warm ions , 2013 .

[37]  J. Madsen,et al.  Collisionality dependent transport in TCV SOL plasmas , 2007 .

[38]  G. Yu,et al.  Dynamics of blobs in scrape-off-layer/shadow regions of tokamaks and linear devices , 2003 .