On the Efficiency of Voltage Source and Current Source Inverters for High-Power Drives

The energy performance of various types of voltage-source and current-source converters is examined. For fairness and completeness, efficiency is calculated for three major battleground scenarios. The first is a low dynamic nonregenerative group of applications such as pumps, fans, and compressors. This group represents 85% of high power (2 MW) industrial applications where energy savings are usually a primary consideration justifying investment. The second scenario considers applications requiring good dynamic response and regenerative braking. Finally, the third group considers very high power applications (over 20 MW). The evaluation presented takes into account semiconductor switching and conduction losses, losses in the medium voltage feeding transformer (determined per IEEE Standard C57.18.10-1998), and the losses in ac and dc filters. For purposes of analysis, computer simulations validated against measurements taken on a 1-MW voltage source inverter (VSI) and a 1.4-MW current source inverter (CSI) were used. The results of the first scenario show competitive efficiencies for VSI and CSI drives, whereas voltage source-based solutions are more energy efficient in the second scenario considered. For the last group, the current source load-commutated inverter exhibits the best performance.

[1]  Bimal K. Bose,et al.  Investigation of fault modes of voltage-fed inverter system for induction motor drive , 1992, Conference Record of the 1992 IEEE Industry Applications Society Annual Meeting.

[2]  Frede Blaabjerg,et al.  Power losses in PWM-VSI inverter using NPT or PT IGBT devices , 1994 .

[3]  G. Joos,et al.  A current-source inverter fed induction motor drive system with reduced losses , 1995, IAS '95. Conference Record of the 1995 IEEE Industry Applications Conference Thirtieth IAS Annual Meeting.

[4]  L. W. Pierce.  Transformer design and application considerations for nonsinusoidal load currents , 1995 .

[5]  Michele Pastorelli,et al.  Influence of the inverter characteristics on the iron losses in PWM inverter fed induction motors , 1995, IAS '95. Conference Record of the 1995 IEEE Industry Applications Conference Thirtieth IAS Annual Meeting.

[6]  J. Espinoza,et al.  DSP based space vector PWM pattern generators for current source rectifiers and inverters , 1995, Proceedings 1995 Canadian Conference on Electrical and Computer Engineering.

[7]  G. Joos,et al.  State variable decoupling and power flow control in PWM current source rectifiers , 1995, Proceedings of IECON '95 - 21st Annual Conference on IEEE Industrial Electronics.

[8]  Geza Joos,et al.  Current-source converter on-line pattern generator switching frequency minimization , 1997, IEEE Trans. Ind. Electron..

[9]  M. J. Samotyj,et al.  Adjustable-speed drives for thermal power plant boiler feed pumps. Russian and American experience , 1997, 1997 IEEE International Electric Machines and Drives Conference Record.

[10]  Geza Joos,et al.  DSP-based space-vector PWM pattern generators for three-phase current source rectifiers and inverters , 1997, Canadian Journal of Electrical and Computer Engineering.

[11]  P.K. Steimer,et al.  IGCT-a new emerging technology for high power, low cost inverters , 1997, IAS '97. Conference Record of the 1997 IEEE Industry Applications Conference Thirty-Second IAS Annual Meeting.

[12]  A. von Jouanne,et al.  Evaluation of inverter and cable losses in adjustable speed drive applications with long motor leads , 1999, IEEE International Electric Machines and Drives Conference. IEMDC'99. Proceedings (Cat. No.99EX272).

[13]  A. Mertens,et al.  New medium voltage drive systems using three-level neutral point clamped inverter with high voltage IGBT , 1999, Conference Record of the 1999 IEEE Industry Applications Conference. Thirty-Forth IAS Annual Meeting (Cat. No.99CH36370).

[14]  M. S. Towers,et al.  Self protected light triggered thyristors , 1999 .

[15]  Jorge Pontt,et al.  Regenerative drives in the megawatt range for high performance downhill belt conveyors , 2000 .

[16]  N. Becker,et al.  "Regenerative drives in the megawatt range for high performance downhill belt conveyors" , 2000, Conference Record of the 2000 IEEE Industry Applications Conference. Thirty-Fifth IAS Annual Meeting and World Conference on Industrial Applications of Electrical Energy (Cat. No.00CH37129).

[17]  Rolando Burgos,et al.  Reduced switching frequency active front end converter for medium voltage current-source drives using space vector modulation , 2000, ISIE'2000. Proceedings of the 2000 IEEE International Symposium on Industrial Electronics (Cat. No.00TH8543).

[18]  W. M. Grady,et al.  Corrections to "measurement of eddy-current loss coefficient P/sub EC-R/ , derating of single-phase transformers, and comparison with K-factor approach" , 2000 .

[19]  Samir Kouro,et al.  Modeling and analysis of common-mode voltages generated in medium voltage PWM-CSI drives , 2003 .

[20]  Don-Ha Hwang,et al.  Loss distribution of three-phase induction motor fed by pulsewidth-modulated inverter , 2004 .

[21]  T.A. Lipo,et al.  Fault tolerant three-phase AC motor drive topologies: a comparison of features, cost, and limitations , 2003, IEEE Transactions on Power Electronics.

[22]  A. Fratta,et al.  Modeling inverter losses for circuit simulation , 2004, 2004 IEEE 35th Annual Power Electronics Specialists Conference (IEEE Cat. No.04CH37551).

[23]  José R. Espinoza,et al.  PWM regenerative rectifiers: state of the art , 2005, IEEE Transactions on Industrial Electronics.

[24]  José R. Espinoza,et al.  A systematic controller-design approach for neutral-point-clamped three-level inverters , 2005, IEEE Transactions on Industrial Electronics.

[25]  Hamid A. Toliyat,et al.  Current-source-rectifier topologies for sinusoidal supply current: theoretical studies and analyses , 2006, IEEE Transactions on Industrial Electronics.

[26]  Vijay Srinivasan,et al.  Modeling and design of a neutral-point voltage regulator for a three-level diode-clamped inverter using multiple-carrier modulation , 2006, IEEE Transactions on Industrial Electronics.

[27]  Bin Wu,et al.  High-Power Converters and AC Drives , 2006 .

[28]  Bin Wu,et al.  High-Power Converters and ac Drives: Wu/High-Power Converters and ac Drives , 2006 .

[29]  A.M. Knight,et al.  Impact of PWM Schemes on Induction Motor Losses , 2006, Conference Record of the 2006 IEEE Industry Applications Conference Forty-First IAS Annual Meeting.

[30]  Bimal K. Bose,et al.  Power Electronics and Motor Drives: Advances and Trends , 2006 .