A Comparison of Redundant Inverter Topologies to Improve Voltage Source Inverter Reliability

For applications sensitive to reliability, typical voltage-source inverters (VSIs) cannot always meet the reliability requirements. In these cases, some method of redundancy is used to improve system reliability. This paper compares the reliability of two redundant VSI circuit topologies to a typical VSI circuit. The redundant circuits function normally after the failure (open or short) of any single component, including the controller, current and voltage sensors, capacitors, insulated gate bipolar transistors, and power diodes. The parts count method of reliability comparison that is described in MIL-HDBK-217F is used to compare the reliability functions for the three circuit topologies.

[1]  Axel Mertens,et al.  Reliability of megawatt drive concepts , 2003, IEEE International Conference on Industrial Technology, 2003.

[2]  G. Oriti,et al.  A novel clamp circuit for a regenerative rectifier using AC/AC matrix converter theory , 2005, IEEE Transactions on Industry Applications.

[3]  Jose Rodriguez,et al.  Method to increase reliability in 5-level inverter , 2003 .

[4]  Y. Kawagoe,et al.  Highly reliable uninterruptible power supply using a bi-directional converter , 1999, 21st International Telecommunications Energy Conference. INTELEC '99 (Cat. No.99CH37007).

[5]  Bimal K. Bose,et al.  Investigation of fault modes of voltage-fed inverter system for induction motor drive , 1992, Conference Record of the 1992 IEEE Industry Applications Society Annual Meeting.

[6]  U. De Pra,et al.  Analysis of the degree of reliability of a redundant modular inverter structure , 1998, INTELEC - Twentieth International Telecommunications Energy Conference (Cat. No.98CH36263).