Nitric oxide emissions and combustion performance of nontraditional ring-fired boilers with furnace geometries

[1]  Yang Meng,et al.  Numerical investigation of the nonlinear flow characteristics in an ultra-supercritical utility boiler furnace , 2015 .

[2]  Hao Li,et al.  Air-Staged Combustion Characteristics of Pulverized Coal under High Temperature and Strong Reducing Atmosphere Conditions , 2014 .

[3]  J. L. Ferrín,et al.  Numerical study of a 350 MWe tangentially fired pulverized coal furnace of the As Pontes Power Plant , 2013 .

[4]  Juhun Song,et al.  Simulation studies on direct ash recycling and reburning technology in a tangentially fired 500 MW pulverized coal boiler , 2013 .

[5]  Defu Che,et al.  Effects of Air Staging Conditions on the Combustion and NOx Emission Characteristics in a 600 MW Wall Fired Utility Boiler Using Lean Coal , 2013 .

[6]  C. Jeon,et al.  Combustion and emission characteristics of low rank-coals utilized in Korea , 2013 .

[7]  F. A. Serant,et al.  Twelve years’ experience of successful adoption and operation of E-820 circular-furnace boiler , 2013 .

[8]  Audai Hussein Al-Abbas,et al.  Numerical simulation of brown coal combustion in a 550 MW tangentially-fired furnace under different operating conditions , 2013 .

[9]  Gyungmin Choi,et al.  Experimental study on interaction and excess heat release under oxy-fuel combustion of blended coals , 2013, Korean Journal of Chemical Engineering.

[10]  Audai Hussein Al-Abbas,et al.  CFD modelling of air-fired and oxy-fuel combustion in a large-scale furnace at Loy Yang A brown coal power station , 2012 .

[11]  Linbo Yan,et al.  Numerical Simulation of a 600 MW Utility Boiler with Different Tangential Arrangements of Burners , 2012 .

[12]  Hari B. Vuthaluru,et al.  CFD based prediction of erosion rate in large scale wall-fired boiler , 2012 .

[13]  Young Ju Kim,et al.  Effects of gas and particle emissions on wall radiative heat flux in oxy-fuel combustion , 2012 .

[14]  Qingyan Fang,et al.  Numerical Simulation of Multifuel Combustion in a 200 MW Tangentially Fired Utility Boiler , 2012 .

[15]  Shien Hui,et al.  Study of optimal pulverized coal concentration in a four-wall tangentially fired furnace , 2011 .

[16]  A. Fomichev,et al.  Development and study of boilers with a ring furnace using different coals , 2011 .

[17]  Norbert Modliński,et al.  Computational modeling of a utility boiler tangentially-fired furnace retrofitted with swirl burners , 2010 .

[18]  Seong-Joon Kim,et al.  Experiment and CFD simulation of hybrid SNCR-SCR using urea solution in a pilot-scale reactor , 2010, Comput. Chem. Eng..

[19]  Zhengqi Li,et al.  Numerical Simulation of Combustion Characteristics and NOx Emissions in a 300 MWe Utility Boiler with Different Outer Secondary-Air Vane Angles , 2010 .

[20]  Juhun Song,et al.  Numerical Study of the Optimization of Combustion and Emission Characteristics of Air-Staged Combustion in a Pulverized Coal-Fired Boiler , 2010 .

[21]  Zhengchun Lin,et al.  Impact of air staging along furnace height on NOx emissions from pulverized coal combustion , 2010 .

[22]  Risto V. Filkoski,et al.  Pulverised-Coal Combustion with Staged Air Introduction: CFD Analysis with Different Thermal Radiation Methods , 2010 .

[23]  Shaohua Wu,et al.  Numerical simulation of the influence of over fire air position on the combustion in a single furnace boiler with dual circle firing , 2009 .

[24]  Nadine D. Spitz,et al.  Firing a sub-bituminous coal in pulverized coal boilers configured for bituminous coals , 2008 .

[25]  Luis I. Díez,et al.  Numerical investigation of NOx emissions from a tangentially-fired utility boiler under conventional and overfire air operation , 2008 .

[26]  Francisco Cadavid,et al.  Coal combustion modelling of large power plant, for NOx abatement , 2007 .

[27]  Li Baoming,et al.  Devolatilization characteristics of biomass at flash heating rate , 2006 .

[28]  金炳斗.  Boiler furnace that avoids thermal no2 , 2005 .

[29]  Boshu He,et al.  Numerical study of the optimum counter-flow mode of air jets in a large utility furnace , 2004 .

[30]  S. C. Hill,et al.  Modeling of nitrogen oxides formation and destruction in combustion systems , 2000 .

[31]  S. Visona,et al.  Prediction of NO emissions from a number of coal-fired power station boilers , 2000 .

[32]  S. C. Hill,et al.  NOx control through reburning , 1998 .

[33]  Klaus R. G. Hein,et al.  Basic effects on NOx emissions in air staging and reburning at a bench-scale test facility , 1996 .

[34]  M. Baum,et al.  Predicting the Combustion Behaviour of Coal Particles , 1971 .

[35]  Katja Bachmeier,et al.  Numerical Heat Transfer And Fluid Flow , 2016 .

[36]  B. M. Gibbs,et al.  The effect of air staged, co-combustion of pulverised coal and biomass blends on NOx emissions and combustion efficiency , 2011 .

[37]  Mário Costa,et al.  Impact of the air staging on the performance of a pulverized coal fired furnace , 2009 .

[38]  K. Hein,et al.  Comparison of Different Radiative Heat Transfer Models and their Applicability to Coal-Fired Utility Boiler Simulations , 1998 .

[39]  Roman Weber,et al.  Mathematical Modeling of a 2.4 MW Swirling Pulverized Coal Flame , 1997 .

[40]  L. D. Smoot,et al.  A decade of combustion research , 1997 .

[41]  B. Hjertager,et al.  On mathematical modeling of turbulent combustion with special emphasis on soot formation and combustion , 1977 .