The assessment of material handling strategies in dealing with sudden loading: the effects of load handling position on trunk biomechanics.

Back injury caused by sudden loading is a significant risk among workers that perform manual handling tasks. The present study investigated the effects of load handling position on trunk biomechanics (flexion angle, L5/S1 joint moment and compression force) during sudden loading. Eleven subjects were exposed to a 6.8 kg sudden loading while standing upright, facing forward and holding load at three different vertical heights in the sagittal plane or 45° left to the sagittal plane (created by arm rotation). Results showed that the increase of load holding height significantly elevated the peak L5/S1 joint compression force and reduced the magnitude of trunk flexion. Further, experiencing sudden loading from an asymmetric direction resulted in significantly smaller peak L5/S1 joint compression force, trunk flexion angle and L5/S1 joint moment than a symmetric posture. These findings suggest that handling loads in a lower position could work as a protective strategy during sudden loading.

[1]  W S Marras,et al.  The Development of Response Strategies in Preparation for Sudden Loading to the Torso , 1993, Spine.

[2]  R. Lipton,et al.  Lost productive time and cost due to common pain conditions in the US workforce. , 2003, JAMA.

[3]  K P Granata,et al.  Female and male trunk geometry: size and prediction of the spine loading trunk muscles derived from MRI. , 2001, Clinical biomechanics.

[4]  K Omino,et al.  Preparation of dynamic posture and occurrence of low back pain. , 1992, Ergonomics.

[5]  R. Norman,et al.  A comparison of peak vs cumulative physical work exposure risk factors for the reporting of low back pain in the automotive industry. , 1998, Clinical biomechanics.

[6]  K P Granata,et al.  MRI-derived moment-arms of the female and male spine loading muscles. , 2001, Clinical biomechanics.

[7]  W. Marras.  Occupational low back disorder causation and control , 2000, Ergonomics.

[8]  E. Yelin,et al.  Special article the economic cost and social and psychological impact of musculoskeletal conditions , 1995 .

[9]  W. Halperin,et al.  Back pain prevalence in US industry and estimates of lost workdays. , 1999, American journal of public health.

[10]  A. Hadjipavlou,et al.  Work-related low back injuries caused by unusual circumstances. , 1997, The Journal of orthopaedic and sports physical therapy.

[11]  John H Evans,et al.  The effects of release height on center of pressure and trunk muscle response following sudden release of stoop lifting tasks. , 2003, Applied ergonomics.

[12]  S. T. Pheasant,et al.  Bodyspace : anthropometry, ergonomics and design , 1986 .

[13]  T. Waters,et al.  Evaluation of spinal loading during lowering and lifting. , 1998, Clinical biomechanics.

[14]  Vijay K. Goel,et al.  Three dimensional moments in the lumbar spine during asymmetric lifting. , 1998, Clinical biomechanics.

[15]  G. Mawston,et al.  The effects of prior exposure, warning, and initial standing posture on muscular and kinematic responses to sudden loading of a hand-held box. , 2007, Clinical biomechanics.

[16]  W S Marras,et al.  The Effects of Preview and Task Symmetry on Trunk Muscle Response to Sudden Loading , 1989, Human factors.

[17]  W S. Marras,et al.  The development of an EMG-assisted model to assess spine loading during whole-body free-dynamic lifting. , 1997, Journal of electromyography and kinesiology : official journal of the International Society of Electrophysiological Kinesiology.

[18]  Gary A Mirka,et al.  Influence of asymmetry on the flexion relaxation response of the low back musculature. , 2011, Clinical biomechanics.

[19]  Karl F. Orishimo,et al.  Response of trunk muscle coactivation to changes in spinal stability. , 2001, Journal of biomechanics.

[20]  Manning Dp,et al.  Body movements and events contributing to accidental and nonaccidental back injuries. , 1984 .

[21]  W. Marras,et al.  Cost-benefit of muscle cocontraction in protecting against spinal instability. , 2000, Spine.

[22]  Xiaopeng Ning,et al.  The assessment of material handling strategies in dealing with sudden loading: influences of foot placement on trunk biomechanics , 2013, Ergonomics.

[23]  Bart W. Koes,et al.  Daily spinal mechanical loading as a risk factor for acute non-specific low back pain: a case–control study using the 24-Hour Schedule , 2006, European Spine Journal.

[24]  Gary A Mirka,et al.  An algorithm for defining the onset and cessation of the flexion-relaxation phenomenon in the low back musculature. , 2012, Journal of electromyography and kinesiology : official journal of the International Society of Electrophysiological Kinesiology.

[25]  Gary A Mirka,et al.  Adaptive system identification applied to the biomechanical response of the human trunk during sudden loading. , 2005, Journal of biomechanics.

[26]  W. Marras,et al.  The effects of a temporal warning signal on the biomechanical preparations for sudden loading. , 1995, Journal of electromyography and kinesiology : official journal of the International Society of Electrophysiological Kinesiology.

[27]  W. Marras,et al.  Trunk loading and expectation. , 1987, Ergonomics.

[28]  A Garg,et al.  Revised NIOSH equation for the design and evaluation of manual lifting tasks. , 1993, Ergonomics.

[29]  R W Norman,et al.  Biomechanical and psychosocial risk factors for low back pain at work. , 2001, American journal of public health.

[30]  Frymoyer Jw,et al.  An overview of the incidences and costs of low back pain. , 1991 .

[31]  J. Cholewicki,et al.  Stabilizing Function of Trunk Flexor‐Extensor Muscles Around a Neutral Spine Posture , 1997, Spine.

[32]  Linda C. Li,et al.  The economic burden of low back pain: a review of studies published between 1996 and 2001. , 2002, Best practice & research. Clinical rheumatology.