Heat emitting layers for enhancing NDE of composite structures

A new technique using hybrid polymer composites with infrared thermography is presented as a potential method for enhanced non-destructive evaluation (NDE) of polymer composite materials and structures. This fully integrated approach is a concept aimed at adding an NDE functionality to the composite. Termed HELTHY (Heat Emitting Layer for THermographY), the technique utilises an embedded heat emitting layer (HEL) to input thermal energy from within the composite structure. After activation of the HEL, surface temperature readings can be captured using an infrared detector. The idea was based on the fact that variations in the surface temperature relate to non-uniformities, i.e. defects, that are within the laminate, which can then be detected. The concept is first simulated using finite element analysis to help determine the main parameters that influence HELTHY. An experimental investigation follows in order to verify the results of the simulations. The concept proves to be very tolerant of a number of input parameters giving early signs that the technique is relatively robust. Finally, a two small-scale application case studies are investigated to examine the effect of the concept on more complex real-life structures.

[1]  Lance Richards,et al.  Health Monitoring Technique for Composite Materials Utilizing Embedded Thermal Fiber Optic Sensors , 2005 .

[2]  James H. Starnes,et al.  Design and manufacturing of aerospace composite structures, state-of-the-art assessment , 2002 .

[3]  Peter Cawley,et al.  Non-destructive testing—current capabilities and future directions , 2001 .

[4]  Shiv P. Joshi,et al.  Damage detection in CFRP by electrical conductivity mapping , 2001 .

[5]  Simon A. Hayes,et al.  A resistance-based damage location sensor for carbon-fibre composites , 2002 .

[6]  J. J. Toon.  Metal fibers and fabrics as shielding materials for composites, missiles and airframes , 1990, IEEE International Symposium on Electromagnetic Compatibility.

[7]  L. Robroek.  The development of rubber forming as a rapid thermoforming technique for continuous fibre reinforced thermoplastic composites: Quality control by process control , 1994 .

[8]  G. Giraud,et al.  In-situ monitoring of damage in CFRP laminates by means of AC and DC measurements , 2001 .

[9]  Giovanni Maria Carlomagno,et al.  Geometrical Limitations to Detection of Defects in Composites by Means of Infrared Thermography , 2004 .

[10]  L M Sim,et al.  Damage detection and assessment in fibre-reinforced composite structures with embedded fibre optic sensors-review , 2002 .

[11]  I. H. Marshall,et al.  Thermography as a tool for damage assessment , 2005 .

[12]  G. Mook,et al.  A comparative investigation of electrical resistance and acoustic emission during cyclic loading of CFRP laminates , 2001 .

[13]  Nobuo Takeda,et al.  Delamination monitoring of laminated composites subjected to low-velocity impact using small-diameter FBG sensors , 2005 .

[14]  X. Maldague,et al.  Aircraft composites assessment by means of transient thermal NDT , 2004 .

[15]  Jorge A Diaz,et al.  Developments to manufacture structural aeronautical parts in carbon fibre reinforced thermoplastic materials , 2003 .

[16]  Carosena Meola,et al.  Comparison between pulsed and modulated thermography in glass-epoxy laminates , 2002 .