Gas-hydrate formation, agglomeration and inhibition in oil-based drilling fluids for deep-water drilling

Abstract One of the main challenges in deep-water drilling is gas-hydrate plugs, which make the drilling unsafe. Some oil-based drilling fluids (OBDF) that would be used for deep-water drilling in the South China Sea were tested to investigate the characteristics of gas-hydrate formation, agglomeration and inhibition by an experimental system under the temperature of 4 °C and pressure of 20 MPa, which would be similar to the case of 2000 m water depth. The results validate the hydrate shell formation model and show that the water cut can greatly influence hydrate formation and agglomeration behaviors in the OBDF. The oleophobic effect enhanced by hydrate shell formation which weakens or destroys the interfacial films effect and the hydrophilic effect are the dominant agglomeration mechanism of hydrate particles. The formation of gas hydrates in OBDF is easier and quicker than in water-based drilling fluids in deep-water conditions of low temperature and high pressure because the former is a W/O dispersive emulsion which means much more gas-water interfaces and nucleation sites than the later. Higher ethylene glycol concentrations can inhibit the formation of gas hydrates and to some extent also act as an anti-agglomerant to inhibit hydrates agglomeration in the OBDF.

[1]  E. D. Sloan,et al.  Direct conversion of water droplets to methane hydrate in crude oil , 2009 .

[2]  Amadeu K. Sum,et al.  Effective kinetic inhibitors for natural gas hydrates , 1996 .

[3]  P. Rodger,et al.  Simulations of the methane hydrate/methane gas interface near hydrate forming conditions conditions , 1996 .

[4]  Carolyn A. Koh,et al.  Clathrate hydrates of natural gases , 1990 .

[5]  C. Dalmazzone,et al.  DSC measurements and modelling of the kinetics of methane hydrate formation in water-in-oil emulsion , 2009 .

[6]  J. Argillier,et al.  Methane solubility in synthetic oil-based drilling muds , 1999 .

[7]  E. Dendy Sloan,et al.  Introductory overview: Hydrate knowledge development , 2004 .

[8]  Ryen Caenn,et al.  Drilling fluids : State of the art , 1996 .

[9]  P. Englezos,et al.  Unusual kinetic inhibitor effects on gas hydrate formation , 2006 .

[10]  Lars Henrik Gjertsen,et al.  Hydrate Plug Properties: Formation and Removal of Plugs , 2000 .

[11]  J. Herri,et al.  Chord length distributions measurements during crystallization and agglomeration of gas hydrate in a water-in-oil emulsion: Simulation and experimentation , 2010 .

[12]  E. Dendy Sloan,et al.  Methane hydrate formation and an inward growing shell model in water-in-oil dispersions , 2009 .

[13]  K. K. ØSTERGAARD,et al.  Gas Hydrates and Offshore Drilling: Predicting the Hydrate Free Zone , 2000 .

[14]  R. Grigg,et al.  Oil-Based Drilling Mud as a Gas-Hydrates Inhibitor , 1992 .

[15]  T. Barth,et al.  Wettability of Freon hydrates in crude oil/brine emulsions. , 2005, Journal of colloid and interface science.

[16]  Carolyn A. Koh,et al.  Hydrate formation from high water content-crude oil emulsions , 2008 .