Investigating the technological limits of micro-injection molding in replicating high aspect ratio micro-structured surfaces

Abstract Micro injection molding is a key technology for mass-production of micro-structured surfaces, such as optical and microfluidic devices. However, the complete replication of high aspect ratio micro features is challenging even using state-of-the-art high-speed injection systems, rapid heat cycle molding and vacuum mold venting. In this work the technological limits of micro-injection molding in replicating high aspect ratio micro-structured surfaces are experimentally investigated, using the molding of a bio-MEMS for erythrocytes depletion as a case study. The obtained results show how these limits are inherently related to an uneven distribution of cavity pressure during mold filling.

[1]  L. J. Lee,et al.  Experimental and numerical studies of injection molding with microfeatures , 2005 .

[2]  T. Jaaskelainen,et al.  Replication of sub‐micron features using amorphous thermoplastics , 2002 .

[3]  R. Hocken,et al.  Replication of micro and nano surface geometries , 2011 .

[4]  A. Liou,et al.  Injection molding of polymer micro- and sub-micron structures with high-aspect ratios , 2006 .

[5]  Kazunori Kato,et al.  Experimental study of transcription of minute width grooves in injection molding , 1994 .

[6]  J. Mead,et al.  Evaluation of Vacuum Venting for Micro-injection Molding , 2011 .

[7]  X. Han,et al.  Effects of molding conditions on transcription molding of microscale prism patterns using ultra-high-speed injection molding , 2006 .

[8]  N. Larsen,et al.  Injection molding of high aspect ratio sub-100 nm nanostructures , 2013 .

[9]  Hiroshi Ito,et al.  REPLICATION BEHAVIOR FOR MICRO SURFACE FEATURES WITH HIGH ASPECT RATIO AND STRUCTURE DEVELOPMENT IN INJECTION COMPRESSION MOLDING , 2012 .

[10]  H. N. Hansen,et al.  Study of process parameters effect on the filling phase of micro-injection moulding using weld lines as flow markers , 2010 .

[11]  Michael Sylvester Packianather,et al.  Micro-injection moulding: Factors affecting the achievable aspect ratios , 2007 .

[12]  Paolo Francesco Bariani,et al.  Influence of rapid mold temperature variation on surface topography replication and appearance of injection-molded parts , 2012 .