Analysis of processing parameters in fabrication of Fresnel lens solar collector

Abstract This study analyzed and evaluated important parameters in fabrication of Fresnel lens solar collector (melt temperature, mold temperature, packing pressure, and injection speed) based on its two qualities (ratio of power efficiency and percentage error of groove filling ratio). To design the experiment effectively, Taguchi method was applied. The experimental results were analyzed by analysis of variance (ANOVA) in order to derive the significant parameters affecting each quality. Relationships among significant parameters and each quality were established using the response surface methodology (RSM). Two equations were integrated to derive a fitness function, which was optimized by two popular optimization methods – particle swarm optimization (PSO) and genetic algorithm (GA). Optimization results from both methods were chosen based on the highest fitness value. The results showed that with the optimal combination (270 °C, 100 °C, 1040.4 bar, and 60 mm/s for melt temperature, mold temperature, packing pressure, and injection speed, respectively), a high ratio of conversion efficiency and a low percentage error of groove filling ratio could be successfully derived. Confirmation experiment was conducted to validate the results.

[1]  R. Leutz,et al.  Nonimaging fresnel lenses : design and performance of solar concentrators , 2001 .

[2]  Tieli Sun,et al.  Comparison of Particle Swarm Optimization and Genetic Algorithm for HMM training , 2008, 2008 19th International Conference on Pattern Recognition.

[3]  Chung-Feng Jeffrey Kuo,et al.  Optimization of Injection Molding Processing Parameters for LCD Light-Guide Plates , 2007 .

[4]  Ruzhu Wang,et al.  Numerical and experimental analysis of a point focus solar collector using high concentration imaging PMMA Fresnel lens , 2011 .

[5]  Kang-Min Park,et al.  Concept and design of modular Fresnel lenses for concentration solar PV system , 2006 .

[6]  Kuo-Ming Tsai,et al.  A study of the effects of process parameters for injection molding on surface quality of optical lenses , 2009 .

[7]  Jae-Seob Kwak,et al.  Application of Taguchi and response surface methodologies for geometric error in surface grinding process , 2005 .

[8]  Ruzhu Wang,et al.  Experimental investigation and analysis on a concentrating solar collector using linear Fresnel lens , 2010 .

[9]  Ruzhu Wang,et al.  Concentrated solar energy applications using Fresnel lenses: A review , 2011 .

[10]  Tung-Hsu Hou,et al.  Parameters optimization of a nano-particle wet milling process using the Taguchi method, response surface method and genetic algorithm , 2007 .

[11]  Peiwen Li,et al.  A novel application of a Fresnel lens for a solar stove and solar heating , 2011 .

[12]  Jong Tae Kim,et al.  Optical design and illumination simulation of Fresnel lenses for marine signal lanterns , 2005, SPIE/COS Photonics Asia.

[13]  David C. Miller,et al.  Durability of Fresnel lenses: A review specific to the concentrating photovoltaic application , 2011 .

[14]  Shou Liu,et al.  Fabrication of holographic Fresnel lens used as a solar concentrator , 2007, SPIE/COS Photonics Asia.