论文信息 - Influence of Cutter Position on Cutting Forces and Tool Life in Face Milling

Influence of Cutter Position on Cutting Forces and Tool Life in Face Milling

In manufacturing industry there is a lack of information about the effect of relative transverse position between cutter and workpiece - centric or out of center face mailling - on tool life. In this work, the results of the investigation about the influence of the transverse position of face milling cutter on cutting forces, tool life and surface roughness are presented. Also, the experimental results obtained in this research were compared to data published in the literature.

[1] Anselmo Eduardo Diniz,et al. Influence of the relative positions of tool and workpiece on tool life, tool wear and surface finish in the face milling process , 1999 .

[2] Ahmed A. D. Sarhan,et al. Interrelationships between cutting force variation and tool wear in end-milling , 2001 .

[3] A.J.P. Sabberwal,et al. Cutting forces in down milling , 1962 .

[4] Elso Kuljanić,et al. TWEM, a method based on cutting forces—monitoring tool wear in face milling , 2005 .

[5] M. C. Shaw. Metal Cutting Principles , 1960 .

[6] F. Koenigsberger,et al. An investigation into the cutting force pulsations during milling operations , 1961 .

[7] A. Galip Ulsoy,et al. Tool Wear and Breakage Detection Using a Process Model , 1986 .