A 0.5-V 3.69-nW Complementary Source-Follower-C Based Low-Pass Filter for Wearable Biomedical Applications

Ultra-low-power circuits that can work under a low-voltage supply are in great demand in future wearable biomedical applications, which tend to be integrated with low-output-voltage energy harvesting devices. In this paper, we present a low-voltage low-power continuous-time low-pass filter (CT-LPF), which is indispensable in biomedical systems. When a low-voltage supply is used, it is necessary to make the output quiescent voltage (<inline-formula> <tex-math notation="LaTeX">$\text{V}_{\mathrm {Q}}$ </tex-math></inline-formula>) stable in the LPF, otherwise the dynamic range will be reduced. Conventional Source-follower (SF) based topologies can achieve ultra-low-power consumption. However, the difference of the input and output <inline-formula> <tex-math notation="LaTeX">$\text{V}_{\mathrm {Q}}$ </tex-math></inline-formula> is sensitive to process and temperature variations. In this work, a complementary SF based topology with a bulk-common-mode-feedback (B-CMFB) circuit is proposed to keep the output <inline-formula> <tex-math notation="LaTeX">$\text{V}_{\mathrm {Q}}$ </tex-math></inline-formula> tracking the input <inline-formula> <tex-math notation="LaTeX">$\text{V}_{\mathrm {Q}}$ </tex-math></inline-formula> and immune to the process and temperature variations. A 4<sup>th</sup>-order LPF using the proposed topology has been implemented in a standard <inline-formula> <tex-math notation="LaTeX">$0.18~\mu \text{m}$ </tex-math></inline-formula> CMOS process, which achieves a power consumption of only 3.69-nW under a 0.5-V voltage supply with a bandwidth of 200 Hz. Measurement results show that the input-referred noise is <inline-formula> <tex-math notation="LaTeX">$91.9~\mu \text{V}_{\mathrm {rms}}$ </tex-math></inline-formula>. The IIP3 is 5.0 dBm and the dynamic range (DR) is 48.5 dB. The active chip area is only 0.074 mm<sup>2</sup>. The proposed LPF achieves both ultra-low power consumption with a 0.5-V supply and a stable output <inline-formula> <tex-math notation="LaTeX">$\text{V}_{\mathrm {Q}}$ </tex-math></inline-formula> immune to process and temperature variations, which is suitable for low-supply-voltage biomedical systems.

[1]  Shuenn-Yuh Lee,et al.  Systematic Design and Modeling of a OTA-C Filter for Portable ECG Detection , 2009, IEEE Transactions on Biomedical Circuits and Systems.

[2]  S. D'Amico,et al.  A 4.1-mW 10-MHz Fourth-Order Source-Follower-Based Continuous-Time Filter With 79-dB DR , 2006, IEEE Journal of Solid-State Circuits.

[3]  Chutham Sawigun,et al.  A Nanopower Biopotential Lowpass Filter Using Subthreshold Current-Reuse Biquads With Bulk Effect Self-Neutralization , 2019, IEEE Transactions on Circuits and Systems I: Regular Papers.

[4]  Andrea Baschirotto,et al.  A Biquadratic Cell Based on the Flipped-Source-Follower Circuit , 2017, IEEE Transactions on Circuits and Systems II: Express Briefs.

[5]  Feng Wan,et al.  15-nW Biopotential LPFs in 0.35- $\mu{\rm m}$ CMOS Using Subthreshold-Source-Follower Biquads With and Without Gain Compensation , 2013, IEEE Transactions on Biomedical Circuits and Systems.

[6]  Chutham Sawigun,et al.  A Subthreshold Buffer-Based Biquadratic Cell and its Application to Biopotential Filter Design , 2018, IEEE Transactions on Circuits and Systems I: Regular Papers.

[7]  Wouter A. Serdijn,et al.  Adaptive buck-boost converter for RF energy harvesting and transfer in biomedical applications , 2016, 2016 IEEE Biomedical Circuits and Systems Conference (BioCAS).

[8]  Tzu-Yun Wang,et al.  A Power-Efficient Reconfigurable OTA-C Filter for Low-Frequency Biomedical Applications , 2018, IEEE Transactions on Circuits and Systems I: Regular Papers.

[9]  Mohammad Tohidi,et al.  Low-Power High-Input-Impedance EEG Signal Acquisition SoC With Fully Integrated IA and Signal-Specific ADC for Wearable Applications , 2019, IEEE Transactions on Biomedical Circuits and Systems.

[10]  Mario Konijnenburg,et al.  An Ultra Low Energy Biomedical Signal Processing System Operating at Near-Threshold , 2011, IEEE Transactions on Biomedical Circuits and Systems.

[11]  Rui Paulo Martins,et al.  Ultra-Low-Power and Ultra-Low-Cost Short-Range Wireless Receivers in Nanoscale CMOS , 2015 .

[12]  Chulwoo Kim,et al.  A 0.15 V Input Energy Harvesting Charge Pump With Dynamic Body Biasing and Adaptive Dead-Time for Efficiency Improvement , 2014, IEEE Journal of Solid-State Circuits.

[13]  Shuenn-Yuh Lee,et al.  A Fifth-Order Butterworth OTA-C LPF With Multiple-Output Differential-Input OTA for ECG Applications , 2018, IEEE Transactions on Circuits and Systems II: Express Briefs.

[14]  David D. Wentzloff,et al.  A 1.02 μW Battery-Less, Continuous Sensing and Post-Processing SiP for Wearable Applications , 2019, IEEE Transactions on Biomedical Circuits and Systems.

[15]  Hariprasad Chandrakumar,et al.  An 80-mVpp Linear-Input Range, 1.6- $\text{G}\Omega $ Input Impedance, Low-Power Chopper Amplifier for Closed-Loop Neural Recording That Is Tolerant to 650-mVpp Common-Mode Interference , 2017, IEEE Journal of Solid-State Circuits.

[16]  Andrea Baschirotto,et al.  A 33 MHz 70 dB-SNR Super-Source-Follower-Based Low-Pass Analog Filter , 2015, IEEE Journal of Solid-State Circuits.

[17]  Xuguang Zhang,et al.  A Novel CMOS OTA Based on Body-Driven MOSFETs and its Applications in OTA-C Filters , 2007, IEEE Transactions on Circuits and Systems I: Regular Papers.

[18]  Mohamad Sawan,et al.  Linear-Phase Delay Filters for Ultra-Low-Power Signal Processing in Neural Recording Implants , 2010, IEEE Transactions on Biomedical Circuits and Systems.

[19]  Congyin Shi,et al.  Highly Power-Efficient Active-RC Filters With Wide Bandwidth-Range Using Low-Gain Push-Pull Opamps , 2013, IEEE Transactions on Circuits and Systems I: Regular Papers.

[20]  Bozena Kaminska,et al.  Mechanically Flexible Wireless Multisensor Platform for Human Physical Activity and Vitals Monitoring , 2010, IEEE Transactions on Biomedical Circuits and Systems.

[21]  Benton H. Calhoun,et al.  A 71% efficient energy harvesting and power management unit for sub-μW power biomedical applications , 2017, 2017 IEEE Biomedical Circuits and Systems Conference (BioCAS).

[22]  Edgar Sánchez-Sinencio,et al.  Frequency-dependent harmonic-distortion analysis of a linearized cross-coupled CMOS OTA and its application to OTA-C filters , 2006, IEEE Transactions on Circuits and Systems I: Regular Papers.

[23]  Maysam Ghovanloo,et al.  A Low-Noise Preamplifier with Adjustable Gain and Bandwidth for Biopotential Recording Applications , 2007, 2007 IEEE International Symposium on Circuits and Systems.

[24]  Man-Kay Law,et al.  A Single-Chip Solar Energy Harvesting IC Using Integrated Photodiodes for Biomedical Implant Applications , 2017, IEEE Transactions on Biomedical Circuits and Systems.

[25]  Melanie Hartmann,et al.  Design Of Analog Cmos Integrated Circuits , 2016 .

[26]  Pui-In Mak,et al.  A 0.2-V Energy-Harvesting BLE Transmitter With a Micropower Manager Achieving 25% System Efficiency at 0-dBm Output and 5.2-nW Sleep Power in 28-nm CMOS , 2019, IEEE Journal of Solid-State Circuits.

[27]  Pui-In Mak,et al.  A 0.18-V 382- $\mu$ W Bluetooth Low-Energy Receiver Front-End With 1.33-nW Sleep Power for Energy-Harvesting Applications in 28-nm CMOS , 2018, IEEE Journal of Solid-State Circuits.

[28]  Yuan-Sun Chu,et al.  Low-Voltage OTA–C Filter With an Area- and Power-Efficient OTA for Biosignal Sensor Applications , 2019, IEEE Transactions on Biomedical Circuits and Systems.