A Voltage-Multiplying Self-Powered AC/DC Converter with 0.35-V Minimum Input Voltage for Energy Harvesting Applications

This paper demonstrates a highly efficient, low-voltage ac/dc converter using a voltage multiplier (octupler) circuit architecture intended for vibrational energy harvesting applications where a low-voltage ac waveform is used to charge a battery. The circuit employs output-powered active diodes and does not require any external power supply or startup circuitry. The circuit rectifies and boosts input ac voltages in the range of 0.35-2 V and 20-500 Hz to a dc voltage output, that is, ~8 times higher than the input amplitude. The circuit can cold start from an input voltage of 0.5 V or higher, providing an output voltage sufficient to charge a 3.7-V lithium ion battery. Once started, the circuit can maintain operation at input voltage amplitudes as low as 0.35 V. Over 80% efficiency is achieved from 20 to 100 Hz, with output power ranging from a few microwatts to 1 mW. Furthermore, in testing with an actual electrodynamic (magnetic) vibrational energy harvester that generates >;0.5-V ac output, the circuit delivers power to a lithium ion battery with an efficiency of >;80%.

[1]  Ka Wai Eric Cheng,et al.  Implementation of a Voltage Multiplier Integrated HID Ballast Circuit With Dimming Control for Automotive Application , 2009, IEEE Transactions on Industrial Electronics.

[2]  C. Saha,et al.  Step-up converter for electromagnetic vibrational energy scavenger , 2008, ArXiv.

[3]  M. Ghovanloo,et al.  Fully integrated wideband high-current rectifiers for inductively powered devices , 2004, IEEE Journal of Solid-State Circuits.

[4]  J. Krikke.  Sunrise for energy harvesting products , 2005, IEEE Pervasive Computing.

[5]  Hamid Jabbar,et al.  RF energy harvesting system and circuits for charging of mobile devices , 2010, IEEE Transactions on Consumer Electronics.

[6]  W. Liao,et al.  On the efficiencies of piezoelectric energy harvesting circuits towards storage device voltages , 2007 .

[7]  Anantha Chandrakasan,et al.  A batteryless thermoelectric energy-harvesting interface circuit with 35mV startup voltage , 2010, 2010 IEEE International Solid-State Circuits Conference - (ISSCC).

[8]  D. Guyomar,et al.  Buck-Boost Converter for Sensorless Power Optimization of Piezoelectric Energy Harvester , 2007, IEEE Transactions on Power Electronics.

[9]  Yiannos Manoli,et al.  An ultra-low-voltage active rectifier for energy harvesting applications , 2010, Proceedings of 2010 IEEE International Symposium on Circuits and Systems.

[10]  Shuo Cheng,et al.  An Active Voltage Doubling AC/DC Converter for Low-Voltage Energy Harvesting Applications , 2011, IEEE Transactions on Power Electronics.

[11]  Anantha Chandrakasan,et al.  A Battery-Less Thermoelectric Energy Harvesting Interface Circuit With 35 mV Startup Voltage , 2010, IEEE Journal of Solid-State Circuits.

[12]  Joseph A. Paradiso,et al.  Energy scavenging for mobile and wireless electronics , 2005, IEEE Pervasive Computing.

[13]  Ekachai Leelarasmee,et al.  Adaptive electromagnetic energy harvesting circuit for wireless sensor application , 2009, 2009 6th International Conference on Electrical Engineering/Electronics, Computer, Telecommunications and Information Technology.

[14]  Chi-Ying Tsui,et al.  Integrated Low-Loss CMOS Active Rectifier for Wirelessly Powered Devices , 2006, IEEE Transactions on Circuits and Systems II: Express Briefs.

[15]  Chi-Ying Tsui,et al.  Integrated single-inductor dual-input dual-output boost converter for energy harvesting applications , 2008, 2008 IEEE International Symposium on Circuits and Systems.

[16]  Leila Parsa,et al.  Design and Implementation of a Direct AC–DC Boost Converter for Low-Voltage Energy Harvesting , 2011, IEEE Transactions on Industrial Electronics.

[17]  R. Besar,et al.  A Dual-Mode Input Voltage Modulation Control Scheme for Voltage Multiplier Based X-Ray Power Supply , 2008, IEEE Transactions on Power Electronics.

[18]  Kai Strunz,et al.  A 20 mV Input Boost Converter With Efficient Digital Control for Thermoelectric Energy Harvesting , 2010, IEEE Journal of Solid-State Circuits.

[19]  Xinping Cao,et al.  Electromagnetic Energy Harvesting Circuit With Feedforward and Feedback DC–DC PWM Boost Converter for Vibration Power Generator System , 2007, IEEE Transactions on Power Electronics.

[20]  L. Colalongo,et al.  A 0.2$-\hbox{1.2}$ V DC/DC Boost Converter for Power Harvesting Applications , 2009, IEEE Transactions on Power Electronics.

[21]  Skandar Basrour,et al.  Integrated power harvesting system including a MEMS generator and a power management circuit , 2008 .

[22]  Daniel J. Inman,et al.  Energy Harvesting Technologies , 2008 .

[23]  Heath Hofmann,et al.  Adaptive piezoelectric energy harvesting circuit for wireless, remote power supply , 2001 .

[24]  H. Yoshida,et al.  A 950-MHz rectifier circuit for sensor network tags with 10-m distance , 2006, IEEE Journal of Solid-State Circuits.

[25]  Mickaël Lallart,et al.  Low-Cost Integrable Tuning-Free Converter for Piezoelectric Energy Harvesting Optimization , 2010, IEEE Transactions on Power Electronics.

[26]  Z. Hossain,et al.  Forward drop-leakage current tradeoff analysis of a junction barrier Schottky (JBS) rectifier , 1999, 11th International Symposium on Power Semiconductor Devices and ICs. ISPSD'99 Proceedings (Cat. No.99CH36312).