Behavior of unbonded flexible risers subject to axial tension

Owing to nonlinear contact problems with slip and friction, a lot of limiting assumptions are made when developing analytical models to simulate the behavior of an unbonded flexible riser. Meanwhile, in order to avoid convergence problems and excessive calculating time associated with running the detailed finite element (FE) model of an unbonded flexible riser, interlocked carcass and zeta layers with complicated cross section shapes are replaced by simple geometrical shapes (e.g. hollow cylindrical shell) with equivalent orthotropic materials. But the simplified model does not imply the stresses equivalence of these two layers. To solve these problems, based on ABAQUS/Explicit, a numerical method that is suitable for the detailed FE model is proposed. In consideration of interaction among all component layers, the axial stiffness of an eight-layer unbonded flexible riser subjected to axial tension is predicted. Compared with analytical and experimental results, it is shown that the proposed numerical method not only has high accuracy but also can substantially reduce the calculating time. In addition, the impact of the lay angle of helical tendons on axial stiffness is discussed.

[1]  Carlos Magluta,et al.  An Experimental and Numerical Study on the Axial Compression Response of Flexible Pipes , 2012 .

[2]  Giulio Alfano,et al.  Numerical derivation of constitutive models for unbonded flexible risers , 2009 .

[3]  Walter Lacarbonara,et al.  Nonlinear Modeling of Cables with Flexural Stiffness , 2008 .

[4]  Ali Bahtui.  Development of a constitutive model to simulate unbonded flexible riser pipe elements , 2008 .

[5]  Thomas Clarke,et al.  Monitoring the structural integrity of a flexible riser during a full-scale fatigue test , 2011 .

[7]  Anders Lyckegaard,et al.  On modelling of lateral buckling failure in flexible pipe tensile armour layers , 2012 .

[8]  Celso P. Pesce,et al.  A Consistent Analytical Model to Predict the Structural Behavior of Flexible Risers Subjected to Combined Loads , 2004 .

[9]  Anders Lyckegaard,et al.  A method for prediction of the equilibrium state of a long and slender wire on a frictionless toroid applied for analysis of flexible pipe structures , 2012 .

[10]  S. Sævik.  Theoretical and experimental studies of stresses in flexible pipes , 2011 .

[11]  I Kraincanic,et al.  Slip initiation and progression in helical armouring layers of unbonded flexible pipes and its effect on pipe bending behaviour , 2001 .

[12]  J. A. Witz.  A case study in the cross-section analysis of flexible risers , 1996 .

[13]  Murilo Augusto Vaz,et al.  A finite element model for flexible pipe armor wire instability , 2011 .

[14]  Anders Lyckegaard,et al.  Imperfection analysis of flexible pipe armor wires in compression and bending , 2012 .

[15]  C. L. Bournazel,et al.  CALCULATION OF STRESSES AND SLIP IN STRUCTURAL LAYERS OF UNBONDED FLEXIBLE PIPES , 1987 .

[16]  Murilo Augusto Vaz,et al.  A nonlinear formulation for the axisymmetric response of umbilical cables and flexible pipes , 2002 .

[17]  R. Chandwani,et al.  A theoretical approach to prediction of service life of unbonded flexible pipes under dynamic loading conditions , 1992 .