An evaluation of the dosimetric performance characteristics of N-vinylpyrrolidone-based polymer gels

The aim of this work was to investigate the dosimetric performance properties of the N-vinylpyrrolidone argon (VIPAR) based polymer gel as a dosimetric tool in clinical radiotherapy. VIPAR gels with a larger concentration of gelatin than the standard recipe were manufactured and irradiated up to 68 Gy using a 6 and 18 MV linear accelerator. Using MRI, the R2-dose response was recorded at different imaging sessions within a 34 day time period post-irradiation. The R2-dose response was found to be linear between 5 and 68 Gy. Although dose sensitivity did not show significant variation with time, the measured R2-dose values showed an increasing trend, which was less evident beyond 17 days. At one day post-irradiation, calculated dose standard uncertainties at 20 Gy and 56 Gy were 2.2% and 1.7%, providing a dose resolution of 0.45 Gy and 0.97 Gy, respectively. Although these values fulfilled the 2% limit of ICRU, when gels were imaged at one day post-irradiation, it was shown that the temporal evolution of the R2 values deteriorated the per cent standard uncertainty and the dose resolution by approximately 57%, when imaged 17 days post-irradiation. Variation in the coagulation temperature of the gels did not impact the R2-dose sensitivity. This study has shown that the VIPAR gel has the properties of a dosimetric tool required in clinical radiotherapy, especially in applications where a wide dose dynamic range is employed. For results with the lowest per cent uncertainty and the optimum dose resolution, the dosimetry gels used in this work should be MR scanned at one day post-irradiation. Furthermore, a preliminary study on the R2-dose response of a new normoxic N-vinylpyrrolidone-based polymer gel showed that it could potentially replace the traditional VIPAR gel formulation, while preserving the wide dynamic dose response inherent to that monomer.

[1]  L J Schreiner,et al.  Polymer gel dosimeters with reduced toxicity: a preliminary investigation of the NMR and optical dose–response using different monomers , 2006, Physics in medicine and biology.

[2]  C De Wagter,et al.  The fundamental radiation properties of normoxic polymer gel dosimeters: a comparison between a methacrylic acid based gel and acrylamide based gels , 2006, Physics in medicine and biology.

[3]  C Baldock,et al.  Dose-response stability and integrity of the dose distribution of various polymer gel dosimeters. , 2002, Physics in medicine and biology.

[4]  S. Webb,et al.  An investigation into the dosimetry of a nine-field tomotherapy irradiation using BANG-gel dosimetry. , 1998, Physics in medicine and biology.

[5]  A modified polymer gel for radiotherapy dosimetry: assessment by MRI and MRS. , 2000, Physics in medicine and biology.

[6]  L. Sakelliou,et al.  Narrow stereotactic beam profile measurements using N-vinylpyrrolidone based polymer gels and magnetic resonance imaging , 2001, Physics in medicine and biology.

[7]  E Pappas,et al.  A new polymer gel for magnetic resonance imaging (MRI) radiation dosimetry. , 1999, Physics in medicine and biology.

[8]  D. Porter,et al.  Dose resolution in radiotherapy polymer gel dosimetry: effect of echo spacing in MRI pulse sequence. , 2001, Physics in medicine and biology.

[9]  C. Baldock,et al.  Modelling of post-irradiation events in polymer gel dosimeters. , 2001, Physics in medicine and biology.

[10]  S Webb,et al.  Radiation dosimetry using polymer gels: methods and applications. , 2000, The British journal of radiology.

[11]  A. Oppelt,et al.  Multiple‐spin‐echo imaging with a 2D Fourier method , 1986, Magnetic resonance in medicine.

[12]  A. Karantanas,et al.  Myocardial and liver iron status using a fast T  2* quantitative MRI (T  2* qMRI) technique , 2007, Magnetic resonance in medicine.

[13]  C Baldock,et al.  A basic study of some normoxic polymer gel dosimeters. , 2002, Physics in medicine and biology.

[14]  C Baldock,et al.  Experimental procedure for the manufacture and calibration of polyacrylamide gel (PAG) for magnetic resonance imaging (MRI) radiation dosimetry. , 1998, Physics in medicine and biology.

[15]  J C Gore,et al.  Magnetic resonance imaging of radiation dose distributions using a polymer-gel dosimeter , 1994, Physics in medicine and biology.

[16]  Y. D. Deene,et al.  Optimization of multiple spin-echo sequences for 3D polymer gel dosimetry. , 2002, Physics in medicine and biology.

[17]  Y. D. Deene.  On the accuracy and precision of gel dosimetry , 2006 .

[18]  P J Keall,et al.  Radiological properties of normoxic polymer gel dosimeters. , 2005, Medical physics.

[19]  Y De Deene,et al.  Essential characteristics of polymer gel dosimeters , 2004 .

[20]  J. Gore,et al.  Three-dimensional visualization and measurement of conformal dose distributions using magnetic resonance imaging of BANG polymer gel dosimeters. , 1997, International journal of radiation oncology, biology, physics.

[21]  J. Vymazal,et al.  Temperature dependence of polymer-gel dosimeter nuclear magnetic resonance response. , 2001, Medical physics.

[22]  L. Sakelliou,et al.  Dose verification of single shot gamma knife applications using VIPAR polymer gel and MRI , 2005, Physics in medicine and biology.

[23]  J. Damilakis,et al.  Experimental determination of the effect of detector size on profile measurements in narrow photon beams. , 2006, Medical physics.

[24]  C. Baldock,et al.  The relationship between radiation-induced chemical processes and transverse relaxation times in polymer gel dosimeters. , 2001, Physics in medicine and biology.

[25]  Joke Voogt,et al.  Use of computers , 1995 .

[26]  C. Baldock,et al.  13C-NMR, 1H-NMR, and FT-raman study of radiation-induced modifications in radiation dosimetry polymer gels , 2001 .

[27]  J. Gore,et al.  Polymer gels for magnetic resonance imaging of radiation dose distributions at normal room atmosphere. , 2001, Physics in medicine and biology.

[28]  C Baldock,et al.  Investigation of the PAGAT polymer gel dosimeter using magnetic resonance imaging , 2005, Physics in medicine and biology.

[29]  C. Baldock,et al.  Uncertainty analysis in polymer gel dosimetry. , 1999, Physics in medicine and biology.

[30]  D. Baltas,et al.  Dosimetry close to an 192Ir HDR source using N-vinylpyrrolidone based polymer gels and magnetic resonance imaging. , 2001, Medical physics.

[31]  C De Wagter,et al.  An investigation of the chemical stability of a monomer/polymer gel dosimeter. , 2000, Physics in medicine and biology.

[32]  M O Leach,et al.  Dynamics of polymerization in polyacrylamide gel (PAG) dosimeters: (II) modeling oxygen diffusion. , 1999, Physics in medicine and biology.

[33]  P. Sammes,et al.  Modified acrylic-based superabsorbent polymers. Effect of temperature and initiator concentration , 1998 .

[34]  C. Baldock,et al.  Experimental study of attenuation properties of normoxic polymer gel dosimeters. , 2004, Physics in medicine and biology.

[35]  J C Gore,et al.  Effects of crosslinking and temperature on the dose response of a BANG polymer gel dosimeter. , 1997, Physics in medicine and biology.

[36]  C. De Wagter,et al.  On the accuracy of monomer/polymer gel dosimetry in the proximity of a high-dose-rate 192Ir source. , 2001, Physics in medicine and biology.

[37]  E. Achten,et al.  Validation of MR‐based polymer gel dosimetry as a preclinical three‐dimensional verification tool in conformal radiotherapy , 2000, Magnetic resonance in medicine.

[38]  P. Righetti,et al.  Polymerization kinetics of polyacrylamide gels II. Effect of temperature , 1981 .

[39]  Clive Baldock,et al.  Investigation of the Magas Normoxic Polymer Gel Dosimeter with Pyrex Glass Walls for Clinical Radiotherapy Dosimetry , 2005 .

[40]  J. Gore,et al.  NMR relaxation enhancement in gels polymerized and cross-linked by ionizing radiation: a new approach to 3D dosimetry by MRI. , 1993, Magnetic resonance imaging.

[41]  E Pappas,et al.  Wide dynamic dose range of VIPAR polymer gel dosimetry. , 2001, Physics in medicine and biology.