LoRa Backscatter

The vision of embedding connectivity into billions of everyday objects runs into the reality of existing communication technologies -- there is no existing wireless technology that can provide reliable and long-range communication at tens of microwatts of power as well as cost less than a dime. While backscatter is low-power and low-cost, it is known to be limited to short ranges. This paper overturns this conventional wisdom about backscatter and presents the first wide-area backscatter system. Our design can successfully backscatter from any location between an RF source and receiver, separated by 475 m, while being compatible with commodity LoRa hardware. Further, when our backscatter device is co-located with the RF source, the receiver can be as far as 2.8 km away. We deploy our system in a 4,800 ft2 (446 m2) house spread across three floors, a 13,024 ft2 (1210 m2) office area covering 41 rooms, as well as a one-acre (4046 m2) vegetable farm and show that we can achieve reliable coverage, using only a single RF source and receiver. We also build a contact lens prototype as well as a flexible epidermal patch device attached to the human skin. We show that these devices can reliably backscatter data across a 3,328 ft2 (309 m2) room. Finally, we present a design sketch of a LoRa backscatter IC that shows that it costs less than a dime at scale and consumes only 9.25 &mgr;W of power, which is more than 1000x lower power than LoRa radio chipsets.

[1]  Joshua R. Smith,et al.  Inter-Technology Backscatter: Towards Internet Connectivity for Implanted Devices , 2016, SIGCOMM.

[2]  Min Li,et al.  Collision recovery receiver for EPC Gen2 RFID systems , 2012, 2012 3rd IEEE International Conference on the Internet of Things.

[3]  Sachin Katti,et al.  HitchHike: Practical Backscatter Using Commodity WiFi , 2016, SenSys.

[4]  Sachin Katti,et al.  BackFi: High Throughput WiFi Backscatter , 2015, SIGCOMM.

[5]  Dong Sam Ha,et al.  An overview of passive RFID , 2007, IEEE Communications Magazine.

[6]  Angli Liu,et al.  Turbocharging ambient backscatter communication , 2014, SIGCOMM.

[7]  Pan Hu,et al.  Laissez-Faire: Fully Asymmetric Backscatter Communication , 2015, SIGCOMM.

[8]  N. E. Roberts,et al.  A 98nW wake-up radio for wireless body area networks , 2012, 2012 IEEE Radio Frequency Integrated Circuits Symposium.

[9]  Robert B. Staszewski,et al.  A 56.4-to-63.4 GHz Multi-Rate All-Digital Fractional-N PLL for FMCW Radar Applications in 65 nm CMOS , 2014, IEEE Journal of Solid-State Circuits.

[10]  Fan Zhang,et al.  A 9 $\mu$ A, Addressable Gen2 Sensor Tag for Biosignal Acquisition , 2010, IEEE Journal of Solid-State Circuits.

[11]  Hoi-Jun Yoo,et al.  A 5.1-/spl mu/W UHF RFID tag chip integrated with sensors for wireless environmental monitoring , 2005, Proceedings of the 31st European Solid-State Circuits Conference, 2005. ESSCIRC 2005..

[12]  Hiroki Sakurai,et al.  A 1.5GHz-modulation-range 10ms-modulation-period 180kHzrms-frequency-error 26MHz-reference mixed-mode FMCW synthesizer for mm-wave radar application , 2011, 2011 IEEE International Solid-State Circuits Conference.

[13]  W. Gregg,et al.  On the Utility of Chirp Modulation for Digital Signaling , 1973, IEEE Trans. Commun..

[14]  Hooman Darabi,et al.  A multistandard, multiband SoC with integrated BT, FM, WLAN radios and integrated power amplifier , 2010, 2010 IEEE International Solid-State Circuits Conference - (ISSCC).

[15]  Amay J Bandodkar,et al.  Non-invasive wearable electrochemical sensors: a review. , 2014, Trends in biotechnology.

[16]  Matthew S. Reynolds,et al.  Every smart phone is a backscatter reader: Modulated backscatter compatibility with Bluetooth 4.0 Low Energy (BLE) devices , 2015, 2015 IEEE International Conference on RFID (RFID).

[17]  Li Lin,et al.  A 1.75 GHz highly-integrated narrow-band CMOS transmitter with harmonic-rejection mixers , 2001, 2001 IEEE International Solid-State Circuits Conference. Digest of Technical Papers. ISSCC (Cat. No.01CH37177).

[18]  Yu-Te Liao,et al.  A 3-$\mu\hbox{W}$ CMOS Glucose Sensor for Wireless Contact-Lens Tear Glucose Monitoring , 2012, IEEE Journal of Solid-State Circuits.

[19]  Thomas Herndl,et al.  A 2.4µW Wake-up Receiver for wireless sensor nodes with −71dBm sensitivity , 2011, 2011 IEEE International Symposium of Circuits and Systems (ISCAS).

[20]  Marian Verhelst,et al.  A 32 nm SoC With Dual Core ATOM Processor and RF WiFi Transceiver , 2013, IEEE Journal of Solid-State Circuits.

[21]  Brian Otis,et al.  SOCWISP: A 9 μA, Addressable Gen2 Sensor Tag for Biosignal Acquisition , 2013 .

[22]  Thiemo Voigt,et al.  Augmenting IoT networks with backscatter-enabled passive sensor tags , 2016, HotWireless@MobiCom.

[23]  Alexander Vardy,et al.  Coding for tag collision recovery , 2015, 2015 IEEE International Conference on RFID (RFID).

[24]  David Wetherall,et al.  Ambient backscatter: wireless communication out of thin air , 2013, SIGCOMM.

[25]  Chen Wei,et al.  High-Efficiency Differential RF Front-End for a Gen2 RFID Tag , 2011, IEEE Transactions on Circuits and Systems II: Express Briefs.

[26]  Joshua R. Smith,et al.  PASSIVE WI-FI: Bringing Low Power to Wi-Fi Transmissions , 2016, GETMBL.

[27]  Bo Gao,et al.  A System-on-Chip EPC Gen-2 Passive UHF RFID Tag With Embedded Temperature Sensor , 2010, IEEE Journal of Solid-State Circuits.

[28]  Mohammad Rostami,et al.  Enabling Practical Backscatter Communication for On-body Sensors , 2016, SIGCOMM.

[29]  Joshua R. Smith,et al.  Wi-fi backscatter , 2014, SIGCOMM 2015.

[30]  Yu-Te Liao,et al.  A contact lens with integrated telecommunication circuit and sensors for wireless and continuous tear glucose monitoring , 2012 .

[31]  Alanson P. Sample,et al.  Design of an RFID-Based Battery-Free Programmable Sensing Platform , 2008, IEEE Transactions on Instrumentation and Measurement.

[32]  Thiemo Voigt,et al.  LoRea: A Backscatter Reader for Everyone! , 2016, ArXiv.

[33]  Mo Li,et al.  Come and Be Served: Parallel Decoding for COTS RFID Tags , 2017, IEEE/ACM Transactions on Networking.

[34]  Joshua R. Smith,et al.  Powering the next billion devices with wi-fi , 2015, CoNEXT.

[35]  Eric A. M. Klumperink,et al.  A Discrete-Time Mixing Receiver Architecture with Wideband Harmonic Rejection , 2008, 2008 IEEE International Solid-State Circuits Conference - Digest of Technical Papers.

[36]  D. Yamazaki,et al.  A Passive UHF RF Identification CMOS Tag IC Using Ferroelectric RAM in 0.35-$\mu{\hbox {m}}$ Technology , 2007, IEEE Journal of Solid-State Circuits.

[37]  Nikolaos G. Bourbakis,et al.  A Survey on Wearable Sensor-Based Systems for Health Monitoring and Prognosis , 2010, IEEE Transactions on Systems, Man, and Cybernetics, Part C (Applications and Reviews).

[38]  Yu-Te Liao,et al.  A Fully Integrated RF-Powered Contact Lens With a Single Element Display , 2010, IEEE Transactions on Biomedical Circuits and Systems.

[39]  Walter Morton,et al.  A Low-Power Single-Weight-Combiner 802.11abg SoC in 0.13 µm CMOS for Embedded Applications Utilizing An Area and Power Efficient Cartesian Phase Shifter and Mixer Circuit , 2008, IEEE Journal of Solid-State Circuits.

[40]  Aggelos Bletsas,et al.  Could battery-less scatter radio tags achieve 270-meter range? , 2016, 2016 IEEE Wireless Power Transfer Conference (WPTC).

[41]  Bruce A. Wooley,et al.  An IEEE 802.11a/b/g SoC for Embedded WLAN Applications , 2006, 2006 IEEE International Solid State Circuits Conference - Digest of Technical Papers.

[42]  Ying-Hsi Lin,et al.  A Low-Power Fullband 802.11a/b/g WLAN Transceiver With On-Chip PA , 2007, IEEE Journal of Solid-State Circuits.

[43]  S. J. Thomas,et al.  A 96 Mbit/sec, 15.5 pJ/bit 16-QAM modulator for UHF backscatter communication , 2012, 2012 IEEE International Conference on RFID (RFID).